- 您現在的位置：買賣IC網 > PDF目錄373996 > ADM1070ART (ANALOG DEVICES INC) -48 V Hot Swap Controller PDF資料下載
參數資料
| 型號： | ADM1070ART |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 電源管理 |
| 英文描述： | -48 V Hot Swap Controller |
| 中文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
| 封裝： | PLASTIC, MO-178AB, SOT-23, 6 PIN |
| 文件頁數： | 4/16頁 |
| 文件大小： | 367K |
| 代理商： | ADM1070ART |
REV. 0
–4–
ADM1070
PIN CONFIGURATION
(Not to Scale)
6
5
4
SENSE
V
IN
GATE
UV/OV
TIMER
ADM1070ART
1
2
3
V
EE
PIN FUNCTION DESCRIPTION
Pin No.
Mnemonic
Function
1
SENSE
Connection to External FET Source Voltage. A sense resistor is connected in the supply path
between the SENSE Pin and V
EE
, and the voltage across this resistor is monitored to detect current
faults. This voltage is fed as an input to the linear current regulator. When it reaches 100 mV for
a specified period, t
ON
, the regulator reduces the gate voltage and drives the FET as a linear pass
device. If current monitoring is not required, this feature can be turned off by shorting the
SENSE Pin and V
EE
together.
Device Negative Supply Voltage. This pin should be connected to the lower potential of the
power supply.
Shunt Regulated On-Chip Supply, Nominally V
EE
+ 12.3 V. This pin should be current fed
through a dropper resistor that is connected to the higher potential of the power supply inputs.
Allows User Control over Timing Functions by Determining Frequency of Oscillator. Fre-
quency set by connecting external capacitor to V
EE
. Tying pin directly to V
EE
causes oscillator to
default to internally set value.
Input Pin for Overvoltage and Undervoltage Detection Circuitry. The voltage appearing on the
UV/OV Pin is proportional to board supply and is determined by external resistors. When the
voltage on UV/OV falls below the undervoltage threshold of 0.86 V, the GATE Pin is driven low.
When the voltage appearing at the UV/OV Pin rises above the overvoltage threshold of 1.97 V,
the GATE Pin is also driven low. If the external resistor ratio of R1/R2 = 40 is used, then this
gives an operating range of –36 V to –77 V.
Output to External FET Gate Drive. Controlled by linear current regulator. The gate is driven
low if an overvoltage or undervoltage fault occurs or if a current fault lasts for longer than the
time, t
ON
. When in linear regulation, the GATE Pin voltage is controlled as part of the servo loop.
No external compensation is required. When the FET is fully enhanced and the load capacitance
has been charged, the GATE Pin reaches a high level of typically 12 V.
2
V
EE
3
V
IN
4
TIMER
5
UV/OV
6
GATE
相關PDF資料 |
PDF描述 |
|---|---|
| ADM1072ARQ | Dual, USB 2.0 Full/Standby Power Controller with Supply Steering |
| ADM1085 | Simple Sequencers in 6-Lead SC70 |
| ADM1085AKS-REEL7 | Simple Sequencers in 6-Lead SC70 |
| ADM1086 | Simple Sequencers in 6-Lead SC70 |
| ADM1086AKS-REEL7 | Simple Sequencers in 6-Lead SC70 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM1070ART-REEL | 制造商:Analog Devices 功能描述:Hot Swap Controller 1-CH -80V 6-Pin SOT-23 T/R 制造商:Analog Devices 功能描述:6-PIN -48V HOT SWAP CONTROLLER I.C. - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:6-PIN -48V HOT SWAP CONTROLLER I.C. - Tape and Reel |
| ADM1070ART-REEL7 | 功能描述:IC CTRL HOTSWAP -48 SOT23-6 RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| ADM1070ARTZ-REEL | 功能描述:IC CTRLR HOTSWAP -48V SOT23-6 RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| ADM1070ARTZ-REEL7 | 功能描述:IC CTRLR HOTSWAP -48V SOT23-6 RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| ADM1070EB | 制造商:AD 制造商全稱:Analog Devices 功能描述:ADM1070 Hot Swap Controller Evaluation Kit Documentation |
發布緊急采購，3分鐘左右您將得到回復。