- 您現在的位置：買賣IC網 > PDF目錄374004 > ADM489AR (ANALOG DEVICES INC) Full-Duplex, Low Power, Slew Rate Limited, EIA RS-485 Transceivers PDF資料下載
參數資料
| 型號： | ADM489AR |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 通用總線功能 |
| 英文描述： | Full-Duplex, Low Power, Slew Rate Limited, EIA RS-485 Transceivers |
| 中文描述： | LINE TRANSCEIVER, PDSO14 |
| 封裝： | MS-012AB, SOIC-14 |
| 文件頁數： | 9/12頁 |
| 文件大?。?/td> | 212K |
| 代理商： | ADM489AR |
ADM488/ADM489
–9–
REV. 0
T he fast transient burst test, defined in IEC1000-4-4, simulates
this arcing and its waveform is illustrated in Figure 20. It
consists of a burst of 2.5 kHz to 5 kHz transients repeating at
300 ms intervals. It is specified for both power and data lines.
Four severity levels are defined in terms of an open-circuit volt-
age as a function of installation environment. T he installation
environments are defined as
1. Well-protected
2. Protected
3. T ypical Industrial
4. Severe Industrial
300ms
16ms
V
t
V
0.2/0.4ms
t
5ns
50ns
Figure 20. IEC1000-4-4 Fast Transient Waveform
T able III shows the peak voltages for each of the environments.
T able III.
V
PE AK
(kV)
PSU
V
PE AK
(kV)
I-O
Level
1
2
3
4
0.5
1
2
4
0.25
0.5
1
2
A simplified circuit diagram of the actual EFT generator is
illustrated in Figure 21.
T hese transients are coupled onto the signal lines using an EFT
coupling clamp. T he clamp is 1 m long and completely sur-
rounds the cable, providing maximum coupling capacitance
(50 pF to 200 pF typ) between the clamp and the cable. High
energy transients are capacitively coupled onto the signal lines.
Fast rise times (5 ns) as specified by the standard result in very
effective coupling. T his test is very severe since high voltages are
coupled onto the signal lines. T he repetitive transients can often
cause problems, where single pulses do not. Destructive latchup
may be induced due to the high energy content of the transients.
Note that this stress is applied while the interface products are
powered up and are transmitting data. T he EFT test applies
hundreds of pulses with higher energy than ESD. Worst case
transient current on an I-O line can be as high as 40 A.
HIGH
VOLTAGE
SOURCE
R
C
C
C
Z
S
L
R
M
C
D
50
V
OUTPUT
Figure 21. EFT Generator
T est results are classified according to the following:
1. Normal performance within specification limits.
2. T emporary degradation or loss of performance that is self-
recoverable.
3. T emporary degradation or loss of function or performance
that requires operator intervention or system reset.
4. Degradation or loss of function that is not recoverable due to
damage.
T he ADM488/ADM489 has been tested under worst case con-
ditions using unshielded cables, and meets Classification 2 at
severity Level 4. Data transmission during the transient condi-
tion is corrupted, but it may be resumed immediately following
the EFT event without user intervention.
RADIAT E D IMMUNIT Y (IE C1000-4-3)
IEC1000-4-3 (previously IEC801-3) describes the measurement
method and defines the levels of immunity to radiated electro-
magnetic fields. It was originally intended to simulate the elec-
tromagnetic fields generated by portable radio transceivers or
any other device that generates continuous wave radiated electro-
magnetic energy. Its scope has since been broadened to include
spurious EM energy, which can be radiated from fluorescent
lights, thyristor drives, inductive loads, etc.
T esting for immunity involves irradiating the device with an EM
field. T here are various methods of achieving this including use
of anechoic chamber, stripline cell, T EM cell and GT EM cell.
T hese consist essentially of two parallel plates with an electric
field developed between them. T he device under test is placed
between the plates and exposed to the electric field. T here are
three severity levels having field strengths ranging from 1 V to
10 V/m. Results are classified as follows:
1. Normal Operation.
2. T emporary Degradation or loss of function that is self-
recoverable when the interfering signal is removed.
3. T emporary degradation or loss of function that requires
operator intervention or system reset when the interfering
signal is removed.
4. Degradation or loss of function that is not recoverable due to
damage.
相關PDF資料 |
PDF描述 |
|---|---|
| ADM489ARU | PHOTODIODE, 0.05A, 1.3V; Area, active:7.5mm2; Case style:SOT-23; Sensitivity:0.6A/W @ 950nm; Wavelength, peak:940nm RoHS Compliant: Yes |
| ADM5104 | Four-channel FastFast Ethernet 110Base-TX Transceiver(四通道110Base-TX快速以太網收發器) |
| ADM5170AN | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM5170AP | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ADM5170JN | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM489AR-REEL | 制造商:Analog Devices 功能描述:Single Transmitter/Receiver RS-422/RS-485 14-Pin SOIC N T/R 制造商:Rochester Electronics LLC 功能描述:FULL DUPLEX,RS-485 TRANSCEIVER I.C. - Tape and Reel |
| ADM489AR-REEL7 | 制造商:Analog Devices 功能描述:Single Transmitter/Receiver RS-422/RS-485 14-Pin SOIC N T/R |
| ADM489ARU | 制造商:Rochester Electronics LLC 功能描述:FULL DUPLEX,RS-485 TRANSCEIVER I.C. - Bulk |
| ADM489ARU-REEL | 制造商:Analog Devices 功能描述:Single Transmitter/Receiver RS-422/RS-485 16-Pin TSSOP T/R 制造商:Analog Devices 功能描述:LINE TRNSCVR 1TR 1TX 1RX 16TSSOP - Tape and Reel |
| ADM489ARU-REEL7 | 制造商:Analog Devices 功能描述:Single Transmitter/Receiver RS-422/RS-485 16-Pin TSSOP T/R |
發布緊急采購，3分鐘左右您將得到回復。