欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: ADM8691
廠商: Analog Devices, Inc.
英文描述: Linear 1-cell Li-Ion Battery Charger w/Integrated FET, One LED 20-HTSSOP -20 to 70
中文描述: 微處理器監控電路
文件頁數: 7/16頁
文件大小: 207K
代理商: ADM8691
ADM8690–ADM8695
REV. 0
–7–
T able I. ADM8691, ADM8693, ADM8695 Reset Pulse Width and Watchdog T imeout Selections
Watchdog T imeout Period
Reset Active Period
Immediately
After Reset
OSC SE L
OSC IN
Normal
ADM8691/ADM8693
ADM8695
Low
Low
Floating or High
Floating or High
External Clock Input
External Capacitor
Low
Floating or High
1024 CLK S
400 ms
×
C/47 pF
100 ms
1.6 s
4096 CLK S
1.6 s
×
C/47 pF
1.6 s
1.6 s
512 CLK S
200 ms
×
C/47 pF
50 ms
50 ms
2048 CLK S
520 ms
×
C/47 pF
200 ms
200 ms
NOT E
With the OSC SEL pin low, OSC IN can be driven by an external clock signal, or an external capacitor can be connected between OSC IN and GND. T he nominal
internal oscillator frequency is 10.24 kHz. T he nominal oscillator frequency with external capacitor is: F
OSC
(Hz) = 184,000/C (pF)
On the ADM8690/ADM8692 the watchdog timeout period is
fixed at 1.6 seconds and the reset pulse width is fixed at 50 ms.
On the ADM8694 the watchdog timeout period is also 1.6 sec-
onds but the reset pulse width is fixed at 200 ms. T he ADM8691/
ADM8693/ADM8695 allow these times to be adjusted as
shown in T able I. Figure 4 shows the various oscillator configu-
rations that can be used to adjust the reset pulse width and
watchdog timeout period.
T he internal oscillator is enabled when OSC SEL is high or
floating. In this mode, OSC IN selects between the 1.6 second
and 100 ms watchdog timeout periods. With OSC IN connected
high or floating, the 1.6 second timeout period is selected; while
with it connected low, the 100 ms timeout period is selected. In
either case, immediately after a reset the timeout period is 1.6
seconds. T his gives the microprocessor time to reinitialize the
system. If OSC IN is low, then the 100 ms watchdog period be-
comes effective after the first transition of WDI. T he software
should be written such that the I/O port driving WDI is left in
its power-up reset state until the initialization routines are com-
pleted and the microprocessor is able to toggle WDI at the mini-
mum watchdog timeout period of 70 ms.
Watchdog Output (WDO)
T he Watchdog Output
WDO
(ADM8691/ADM8693/
ADM8695) provides a status output which goes low if the
watchdog timer “times out” and remains low until set high by
the next transition on the Watchdog Input.
WDO
is also set
high when V
CC
goes below the reset threshold.
8
7
CLOCK
0 TO 500kHz
OSC SEL
OSC IN
ADM8691
ADM8693
ADM8695
Figure 4a. External Clock Source
8
7
OSC SEL
OSC IN
ADM8691
ADM8693
ADM8695
C
OSC
Figure 4b. External Capacitor
8
7
NC
NC
OSC SEL
OSC IN
ADM8691
ADM8693
ADM8695
Figure 4c. Internal Oscillator (1.6 Second Watchdog)
8
7
OSC SEL
OSC IN
ADM8691
ADM8693
ADM8695
NC
Figure 4d. Internal Oscillator (100 ms Watchdog)
相關PDF資料
PDF描述
ADM8691AN Linear 1-cell Li-Ion Battery Charger w/Integrated FET, One LED 20-HTSSOP -20 to 70
ADM8693 bqTINY(TM) Linear 1-cell Li-Ion Charger w/ 1-A FET, AC Present and Temp Sense in QFN-10 10-SON -40 to 85
ADM8693AN bqTINY(TM) Linear 1-cell Li-Ion Charger w/ 1-A FET, AC Present & Charge Enable in QFN-10 10-SON -40 to 85
ADM8695AN bqTINY-II Dual Input USB/AC Adpater 1-Cell Li-Ion Charger w/Charge Enable & Temp Sense in QFN-10 10-SON -40 to 125
ADM8695ARW bqTINY-II Dual Input USB/AC Adpater 1-Cell Li-Ion Charger w/Charge Enable & Power Good in QFN-10 10-SON -40 to 125
相關代理商/技術參數
參數描述
ADM8691AN 制造商:Analog Devices 功能描述:Processor Supervisor 4.65V 4.75V to 5.5V 16-Pin PDIP 制造商:Rochester Electronics LLC 功能描述:IMPROVED ADM691 I.C. - Bulk 制造商:Analog Devices 功能描述:IC SUPERVISORY CCT 8691 DIP16
ADM8691ANZ 功能描述:IC SUPERVSR MPU 4.65V ADJ 16DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:高有效 復位超時:- 電壓 - 閥值:1.8V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-TSOP(0.059",1.50mm 寬)5 引線 供應商設備封裝:5-TSOP 包裝:剪切帶 (CT) 其它名稱:NCP301HSN18T1GOSCT
ADM8691ARN 功能描述:IC SUPERVSR MPU 4.65V ADJ 16SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:高有效 復位超時:- 電壓 - 閥值:1.8V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-TSOP(0.059",1.50mm 寬)5 引線 供應商設備封裝:5-TSOP 包裝:剪切帶 (CT) 其它名稱:NCP301HSN18T1GOSCT
ADM8691ARN-REEL 功能描述:IC SUPERVSR MPU 4.65V ADJ 16SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:高有效 復位超時:- 電壓 - 閥值:1.8V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-TSOP(0.059",1.50mm 寬)5 引線 供應商設備封裝:5-TSOP 包裝:剪切帶 (CT) 其它名稱:NCP301HSN18T1GOSCT
ADM8691ARNZ 功能描述:IC SUPERVSR MPU 4.65V ADJ 16SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:高有效 復位超時:- 電壓 - 閥值:1.8V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-TSOP(0.059",1.50mm 寬)5 引線 供應商設備封裝:5-TSOP 包裝:剪切帶 (CT) 其它名稱:NCP301HSN18T1GOSCT
主站蜘蛛池模板: 应用必备| 汉源县| 天等县| 惠安县| 任丘市| 涟源市| 台东市| 加查县| 红安县| 泰和县| 武川县| 右玉县| 双辽市| 蒙自县| 广昌县| 资溪县| 昌宁县| 涡阳县| 镇巴县| 吉林省| 平远县| 东丽区| 新野县| 廊坊市| 尤溪县| 尉氏县| 鄂托克旗| 海盐县| 临清市| 原阳县| 郴州市| 防城港市| 墨竹工卡县| 澜沧| 乌审旗| 礼泉县| 郑州市| 衡水市| 陈巴尔虎旗| 同心县| 自贡市|