- 您現在的位置：買賣IC網 > PDF目錄374035 > ADSP-2181KST-160 (ANALOG DEVICES INC) DSP Microcomputer PDF資料下載
參數資料
| 型號： | ADSP-2181KST-160 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 數字信號處理 |
| 英文描述： | DSP Microcomputer |
| 中文描述： | 24-BIT, 20 MHz, OTHER DSP, PQFP128 |
| 封裝： | METRIC, PLASTIC, TQFP-128 |
| 文件頁數： | 11/32頁 |
| 文件大小： | 290K |
| 代理商： | ADSP-2181KST-160 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
ADSP-2181
–11–
REV. D
T he 14-pin, 2-row pin strip header is keyed at the Pin 7 loca-
tion—you must remove Pin 7 from the header. T he pins must
be 0.025 inch square and at least 0.20 inch in length. Pin spac-
ing should be 0.1 x 0.1 inches. T he pin strip header must have
at least 0.15 inch clearance on all sides to accept the EZ-ICE
probe plug. Pin strip headers are available from vendors such as
3M, McK enzie and Samtec.
T arget Memory Interface
For your target system to be compatible with the EZ-ICE emu-
lator, it must comply with the memory interface guidelines listed
below.
PM, DM, BM, IOM and CM
Design your Program Memory (PM), Data Memory (DM),
Byte Memory (BM), I/O Memory (IOM) and Composite
Memory (CM) external interfaces to comply with worst case
device timing requirements and switching characteristics as
specified in the DSP’s data sheet. T he performance of the
EZ-ICE
may approach published worst case specification for
some memory access timing requirements and switching
characteristics.
Note:
If your target does not meet the worst case chip specifica-
tion for memory access parameters, you may not be able to
emulate your circuitry at the desired CLK IN frequency. De-
pending on the severity of the specification violation, you may
have trouble manufacturing your system as DSP components
statistically vary in switching characteristic and timing require-
ments within published limits.
Restriction:
All memory strobe signals on the ADSP-2181
(
RD
,
WR
,
PMS
,
DMS
,
BMS
,
CMS
and
IOMS
) used in your
target system must have 10 k
pull-up resistors connected when
the EZ-ICE
is being used. T he pull-up resistors are necessary
because there are no internal pull-ups to guarantee their state
during prolonged three-state conditions resulting from typical
EZ-ICE
debugging sessions. T hese resistors may be removed at
your option when the EZ-ICE
is not being used.
T arget System Interface Signals
When the EZ-ICE
board is installed, the performance on some
system signals changes. Design your system to be compatible
with the following system interface signal changes introduced by
the EZ-ICE
board:
EZ-ICE
emulation introduces an 8 ns propagation delay be-
tween your target circuitry and the DSP on the
RESET
signal.
EZ-ICE
emulation introduces an 8 ns propagation delay be-
tween your target circuitry and the DSP on the
BR
signal.
EZ-ICE
emulation ignores
RESET
and
BR
when single-
stepping.
EZ-ICE
emulation ignores
RESET
and
BR
when in Emulator
Space (DSP halted).
EZ-ICE
emulation ignores the state of target
BR
in certain
modes. As a result, the target system may take control of the
DSP’s external memory bus
only
if bus grant (
BG
) is asserted
by the EZ-ICE
board’s DSP.
T arget Architecture File
T he EZ-ICE
software lets you load your program in its linked
(executable) form. T he EZ-ICE
PC program can not load sec-
tions of your executable located in boot pages (by the linker).
With the exception of boot page 0 (loaded into PM RAM), all
sections of your executable mapped into boot pages are not
loaded.
Write your target architecture file to indicate that only PM
RAM is available for program storage, when using the EZ-ICE
software’s loading feature. Data can be loaded to PM RAM or
DM RAM.
相關PDF資料 |
PDF描述 |
|---|---|
| ADSP-2181 | ADSP-2100 Family DSP Microcomputers |
| ADSP-2181BST-115 | DSP Microcomputer |
| ADSP-2181BST-133 | DSP Microcomputer |
| ADSP2181 | DSP Microcomputer |
| ADSP-2183KST-115 | DSP Microcomputer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADSP-2181KST-160R | 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 40MHz 40MIPS 128-Pin LQFP T/R |
| ADSP-2181KSTZ-115 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: |
| ADSP-2181KSTZ-133 | 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 33.3MHz 33.3MIPS 128-Pin LQFP 制造商:Analog Devices 功能描述:MICROCOMPUTER 16BIT 33MIPS SMD |
| ADSP-2181KSTZ-160 | 功能描述:IC DSP CONTROLLER 16BIT 128TQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:ADSP-21xx 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，F(xiàn)CBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA |
| ADSP-2181KSZ-133 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述:MICROCOMPUTER 16BIT 33MIPS SMD |
發布緊急采購，3分鐘左右您將得到回復。