- 您現在的位置：買賣IC網 > PDF目錄374037 > ADSP-2196MBCA-140X (ANALOG DEVICES INC) DSP Microcomputer PDF資料下載
參數資料
| 型號： | ADSP-2196MBCA-140X |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 數字信號處理 |
| 英文描述： | DSP Microcomputer |
| 中文描述： | 16-BIT, 160 MHz, OTHER DSP, PBGA144 |
| 封裝： | MINI, BGA-144 |
| 文件頁數： | 10/68頁 |
| 文件大小： | 897K |
| 代理商： | ADSP-2196MBCA-140X |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
For current information contact Analog Devices at 800/262-5643
ADSP-2196
PC stack can generate a stack-level interrupt if the PC stack
falls below three locations full or rises above 28
locations full.
The following instructions globally enable or disable
interrupt servicing, regardless of the state of IMASK.
September 2001
This information applies to a product under development. Its characteristics and specifications are subject to change with-
out notice. Analog Devices assumes no obligation regarding future manufacturing unless otherwise agreed to in writing.
10
REV. PrA
ENA INT;
DIS INT;
At reset, interrupt servicing is disabled.
For quick servicing of interrupts, a secondary set of DAG
and computational registers exist. Switching between the
primary and secondary registers lets programs quickly
service interrupts, while preserving the DSP’s state.
DMA Controller
The ADSP-2196 has a DMA controller that supports
automated data transfers with minimal overhead for the
DSP core. Cycle stealing DMA transfers can occur between
the ADSP-2196’s internal memory and any of its
DMA-capable peripherals. Additionally, DMA transfers
can be accomplished between any of the DMA-capable
peripherals and external devices connected to the external
memory interface. DMA-capable peripherals include the
Host port, SPORTs, SPI ports, and UART. Each individual
DMA-capable peripheral has a dedicated DMA channel. To
describe each DMA sequence, the DMA controller uses a
set of parameters—called a DMA descriptor. When succes-
sive DMA sequences are needed, these DMA descriptors
can be linked or chained together, so the completion of one
DMA sequence auto-initiates and starts the next sequence.
DMA sequences do not contend for bus access with the DSP
core, instead DMAs “steal” cycles to access memory.
All DMA transfers use the DMA bus shown in the func-
tional block diagram
on page 1
. Because all of the
peripherals use the same bus, arbitration for DMA bus
access is needed. The arbitration for DMA bus access
appears in
Table 4
.
Host Port
The ADSP-2196’s Host port functions as a slave on the
external bus of an external Host. The Host port interface
lets a Host read from or write to the DSP’s memory space,
boot space, or internal I/O space. Examples of Hosts include
external microcontrollers, microprocessors, or ASICs.
The Host port is a multiplexed address and data bus that
provides both an 8-bit and a 16-bit data path and operates
using an asynchronous transmission protocol. Through this
port, an off-chip Host can directly access the DSP’s entire
memory space map, boot memory space, and internal I/O
space. To access the DSP’s internal memory space, a Host
steals one cycle per access from the DSP. A Host access to
the DSP’s external memory uses the external port interface
and does not stall (or steal cycles from) the DSP’s core.
Because a Host can access internal I/O memory space, a
Host can control any of the DSP’s I/O mapped peripherals.
The Host port is most efficient when using the DSP as a
slave and uses DMA to automate the incrementing of
addresses for these accesses. In this case, an address does
not have to be transferred from the Host for every
data transfer.
Host Port Acknowledge (HACK) Modes
The Host port supports a number of modes (or protocols)
for generating a HACK output for the host. The host selects
ACK or Ready Modes using the HACK_P and HACK pins.
The Host port also supports two modes for address control:
Address Latch Enable (ALE) and Address Cycle Control
(ACC) modes. The DSP auto-detects ALE versus ACC
Mode from the HALE and HWR inputs.
The host port HACK signal polarity is selected (only at
reset) as active high or active low, depending on the value
driven on the HACK_P pin.The HACK polarity is stored
into the host port configuration register as a read only bit.
The DSP uses HACK to indicate to the Host when to
complete an access. For a read transaction, a Host can
proceed and complete an access when valid data is present
in the read buffer and the host port is not busy doing a write.
For a write transactions, a Host can complete an access
when the write buffer is not full and the host port is not busy
doing a write.
Table 4. I/O Bus Arbitration Priority
DMA Bus Master
Arbitration Priority
SPORT0 Receive DMA
0—Highest
SPORT1 Receive DMA
1
SPORT2 Receive DMA
2
SPORT0 Transmit DMA
3
SPORT1 Transmit DMA
4
SPORT2 Transmit DMA
5
SPI0 Receive/Transmit DMA
6
SPI1 Receive/Transmit DMA
7
UART Receive DMA
8
UART Transmit DMA
9
Host Port DMA
10
Memory DMA
11—Lowest
Table 4. I/O Bus Arbitration Priority (Continued)
DMA Bus Master
Arbitration Priority
相關PDF資料 |
PDF描述 |
|---|---|
| ADSP-2196MBST-140X | DSP Microcomputer |
| ADSP-2196MKCA-160X | DSP Microcomputer |
| ADSP-2196MKST-160X | DSP Microcomputer |
| ADSP-21990 | 16-bit fixed point DSP with Flash |
| ADSP-21990BBC | 16-bit fixed point DSP with Flash |
相關代理商/技術參數 |
參數描述 |
|---|---|
| adsp-2196mbst-140 | 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 140MHz 140MIPS 144-Pin LQFP 制造商:Rochester Electronics LLC 功能描述: |
| ADSP-2196MBST-140Z | 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 140MHz 140MIPS 144-Pin LQFP |
| ADSP-2196MKST-160 | 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 160MHz 160MIPS 144-Pin LQFP 制造商:Analog Devices 功能描述:16-Bit DSP 160 MIPs 2.5V 40 Kbytes |
| ADSP-2196MKSTZ-160 | 功能描述:IC DSP CONTROLLER 16BIT 144-LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:ADSP-21xx 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，FCBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA |
| ADSP-21990BBC | 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 150MHz 150MIPS 196-Pin Mini-BGA 制造商:Rochester Electronics LLC 功能描述:160 MIPS, MIXED SIGNAL DSPWITH 14-BIT - Bulk |
發布緊急采購，3分鐘左右您將得到回復。