- 您現在的位置：買賣IC網 > PDF目錄374046 > ADV7181BBCPZ (ANALOG DEVICES INC) Multiformat SDTV Video Decoder PDF資料下載
參數資料
| 型號： | ADV7181BBCPZ |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 顏色信號轉換 |
| 英文描述： | Multiformat SDTV Video Decoder |
| 中文描述： | COLOR SIGNAL DECODER, QCC64 |
| 封裝： | 9 X 9 MM, LEAD FREE, MO-220-VMMD, LFCSP-64 |
| 文件頁數： | 26/96頁 |
| 文件大小： | 873K |
| 代理商： | ADV7181BBCPZ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁
ADV7181B
Y Shaping Filter
For input signals in CVBS format, the luma shaping filters play
an essential role in removing the chroma component from a
composite signal. YC separation must aim for best possible
crosstalk reduction while still retaining as much bandwidth
(especially on the luma component) as possible. High quality
YC separation can be achieved by using the internal comb filters
of the ADV7181B. Comb filtering, however, relies on the
frequency relationship of the luma component (multiples of the
video line rate) and the color subcarrier (Fsc). For good quality
CVBS signals, this relationship is known; the comb filter
algorithms can be used to separate out luma and chroma with
high accuracy.
Rev. 0 | Page 26 of 96
In the case of nonstandard video signals, the frequency
relationship may be disturbed and the comb filters may not be
able to remove all crosstalk artifacts in an optimum fashion
without the assistance of the shaping filter block.
An automatic mode is provided. Here, the ADV7181B evaluates
the quality of the incoming video signal and selects the filter
responses in accordance with the signal quality and video
standard. YFSM, WYSFMOVR, and WYSFM allow the user to
manually override the automatic decisions in part or in full.
The luma shaping filter has three control registers:
YSFM[4:0] allows the user to manually select a shaping
filter mode (applied to all video signals) or to enable an
automatic selection (dependent on video quality and video
standard).
WYSFMOVR allows the user to manually override the
WYSFM decision.
WYSFM[4:0] allows the user to select a different shaping
filter mode for good quality CVBS, component (YPrPb),
and S-VHS (YC) input signals.
In automatic mode, the system preserves the maximum possible
bandwidth for good CVBS sources (since they can successfully
be combed) as well as for luma components of YPrPb and YC
sources, since they need not be combed. For poor quality
signals, the system selects from a set of proprietary shaping
filter responses that complements comb filter operation in order
to reduce visual artifacts.
The decisions of the control logic are shown in Figure 10.
YSFM[4:0] Y Shaping Filter Mode, Address 0x17 [4:0]
The Y shaping filter mode bits allow the user to select from a
wide range of low-pass and notch filters. When switched in
automatic mode, the filter is selected based on other register
selections, for example, detected video standard, as well as
properties extracted from the incoming video itself, for
example, quality, time base stability. The automatic selection
always picks the widest possible bandwidth for the video input
encountered.
If the YSFM settings specify a filter (i.e., YSFM is set to
values other than 00000 or 00001), the chosen filter is
applied to all video, regardless of its quality.
In automatic selection mode, the notch filters are only used
for bad quality video signals. For all other video signals,
wideband filters are used.
WYSFMOVR Wideband Y Shaping Filter Override,
Address 0x18,[7]
Setting the WYSFMOVR bit enables the use of the WYSFM[4:0]
settings for good quality video signals. For more information,
refer to the general discussion of the luma shaping filters in the
Y Shaping Filter section and the flowchart shown in Figure 10.
When WYSFMOVR is 0, the shaping filter for good quality
video signals is selected automatically.
Setting WYSFMOVR to 1 (default) enables manual override via
WYSFM[4:0].
相關PDF資料 |
PDF描述 |
|---|---|
| ADV7181BBSTZ | Multiformat SDTV Video Decoder |
| ADV7181BCP | Multiformat SDTV Video Decoder |
| ADV7181BST | Multiformat SDTV Video Decoder |
| ADV7183B | Multiformat SDTV Video Decoder |
| ADV7183BBSTZ | Multiformat SDTV Video Decoder |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADV7181BBSTZ | 制造商:Analog Devices 功能描述:Video Decoder 3ADC 9-Bit 64-Pin LQFP 制造商:Analog Devices 功能描述:IC VIDEO ENCODER |
| ADV7181BCP | 制造商:Analog Devices 功能描述:Video Decoder 3ADC 9-Bit 64-Pin LFCSP EP 制造商:Rochester Electronics LLC 功能描述:10BIT NTSC/PAL/SECAM VIDEO DECODER I.C. - Bulk |
| ADV7181BCPZ | 制造商:Analog Devices 功能描述: |
| ADV7181BST | 制造商:Analog Devices 功能描述:Video Decoder 3ADC 9-Bit 64-Pin LQFP 制造商:Rochester Electronics LLC 功能描述:9-BIT BIT NTSC/PAL/SECAM VIDEO DECODER - Bulk 制造商:Analog Devices 功能描述:IC VIDEO ENCODER |
| ADV7181C | 制造商:AD 制造商全稱:Analog Devices 功能描述:10-Bit, Integrated, Multiformat SDTV Video Decoder and RGB Graphics Digitizer |
發布緊急采購，3分鐘左右您將得到回復。