- 您現在的位置：買賣IC網 > PDF目錄374047 > ADV7341 (Analog Devices, Inc.) Multiformat Video Encoder, Six 12-Bit Noise Shaped Video㈢ DACS PDF資料下載
參數資料
| 型號： | ADV7341 |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | Multiformat Video Encoder, Six 12-Bit Noise Shaped Video㈢ DACS |
| 中文描述： | 多格式視頻編碼器，6個12位噪聲整形視頻㈢交叉連接系統 |
| 文件頁數： | 61/88頁 |
| 文件大小： | 1066K |
| 代理商： | ADV7341 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁當前第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁
ADV7340/ADV7341
When changing the adaptive filter mode to Mode B
(Subaddress 0x35, Bit 6), the output shown in Figure 76
can be obtained.
Rev. 0 | Page 61 of 88
0
Figure 76. Output Signal from ED/HD Adaptive Filter (Mode B)
SD DIGITAL NOISE REDUCTION
Subaddress 0xA3 to Subaddress 0xA5
Digital noise reduction (DNR) is applied to the Y data only.
A filter block selects the high frequency, low amplitude compo-
nents of the incoming signal (DNR input select). The absolute
value of the filter output is compared to a programmable
threshold value (DNR threshold control). There are two DNR
modes available: DNR mode and DNR sharpness mode.
In DNR mode, if the absolute value of the filter output is smaller
than the threshold, it is assumed to be noise. A programmable
amount (coring gain border, coring gain data) of this noise
signal is subtracted from the original signal. In DNR sharpness
mode, if the absolute value of the filter output is less than the
programmed threshold, it is assumed to be noise. Otherwise, if
the level exceeds the threshold, now identified as a valid signal,
a fraction of the signal (coring gain border, coring gain data) is
added to the original signal to boost high frequency components
and sharpen the video image.
In MPEG systems, it is common to process the video information
in blocks of 8 pixels × 8 pixels for MPEG2 systems, or 16 pixels ×
16 pixels for MPEG1 systems (block size control). DNR can be
applied to the resulting block transition areas that are known to
contain noise. Generally, the block transition area contains two
pixels. It is possible to define this area to contain four pixels
(border area).
It is also possible to compensate for variable block positioning
or differences in YCrCb pixel timing with the use of the DNR
block offset.
The digital noise reduction registers are three 8-bit registers.
They are used to control the DNR processing.
BLOCK SIZE CONTROL
BORDER AREA
BLOCK OFFSET
CORING GAIN DATA
CORING GAIN BORDER
GAIN
DNR CONTROL
FILTER
OUTPUT
> THRESHOLD
INPUT FILTER
BLOCK
FILTER OUTPUT
< THRESHOLD
DNR OUT
+
+
MAIN SIGNAL PATH
ADD SIGNAL
ABOVE
THRESHOLD
RANGE FROM
ORIGINAL SIGNAL
DNR
SHARPNESS
MODE
NOISE
SIGNAL PATH
Y DATA
INPUT
BLOCK SIZE CONTROL
BORDER AREA
BLOCK OFFSET
CORING GAIN DATA
CORING GAIN BORDER
GAIN
DNR CONTROL
FILTER
OUTPUT
< THRESHOLD
INPUT FILTER
BLOCK
FILTER OUTPUT
> THRESHOLD
DNR OUT
MAIN SIGNAL PATH
SUBTRACT
SIGNAL IN
THRESHOLD
RANGE FROM
ORIGINAL SIGNAL
DNR MODE
NOISE
SIGNAL PATH
Y DATA
INPUT
–
+
0
Figure 77. SD DNR Block Diagram
Coring Gain Border—Subaddress 0xA3, Bits[3:0]
These four bits are assigned to the gain factor applied to border
areas. In DNR mode, the range of gain values is 0 to 1 in
increments of 1/8. This factor is applied to the DNR filter
output that lies below the set threshold range. The result is then
subtracted from the original signal.
In DNR sharpness mode, the range of gain values is 0 to 0.5 in
increments of 1/16. This factor is applied to the DNR filter
output that lies above the threshold range. The result is added to
the original signal.
Coring Gain Data—Subaddress 0xA3, Bits[7:4]
These four bits are assigned to the gain factor applied to the luma
data inside the MPEG pixel block. In DNR mode, the range of
gain values is 0 to 1 in increments of 1/8. This factor is applied
to the DNR filter output that lies below the set threshold range.
The result is then subtracted from the original signal.
In DNR sharpness mode, the range of gain values is 0 to 0.5 in
increments of 1/16. This factor is applied to the DNR filter
output that lies above the threshold range. The result is added to
the original signal.
相關PDF資料 |
PDF描述 |
|---|---|
| ADV7341BSTZ | Multiformat Video Encoder, Six 12-Bit Noise Shaped Video㈢ DACS |
| ADV7341EBZ | Multiformat Video Encoder, Six 12-Bit Noise Shaped Video㈢ DACS |
| ADV7343BSTZ | Multiformat Video Encoder Six, 11-Bit, 297 MHz DACs |
| ADV7342 | Multiformat Video Encoder Six, 11-Bit, 297 MHz DACs |
| ADV7342BSTZ | Multiformat Video Encoder Six, 11-Bit, 297 MHz DACs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADV7341BSTZ | 制造商:Analog Devices 功能描述:Video Encoder 6DAC 12-Bit 64-Pin LQFP Tray 制造商:Analog Devices 功能描述:MULTI-FORMAT VIDEO ENCODER SIX 12-BIT NOISE SHAPED VIDEO DAC - Bulk |
| ADV7341EBZ | 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat Video Encoder, Six 12-Bit Noise Shaped Video㈢ DACS |
| ADV7342 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat Video Encoder Six, 11-Bit, 297 MHz DACs |
| ADV7342BSTZ | 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat Video Encoder Six, 11-Bit, 297 MHz DACs |
| ADV7343 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat Video Encoder Six, 11-Bit, 297 MHz DACs |
發布緊急采購，3分鐘左右您將得到回復。