欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: DC1525A-C
廠商: Linear Technology
文件頁數: 18/34頁
文件大小: 0K
描述: BOARD DEMO 80MSPS LTC2173-14
軟件下載: QuikEval II System
設計資源: DC1525A Design Files
標準包裝: 1
系列: *
相關產品: DC1371A-ND - BOARD USB DATA ACQUISITION HS
25
21754314fa
LTC2175-14/
LTC2174-14/LTC2173-14
applicaTions inForMaTion
mode. Recovering from nap mode requires at least 100
clock cycles. If the application demands very accurate DC
settling then an additional 50s should be allowed so the
on-chip references can settle from the slight temperature
shift caused by the change in supply current as the A/D
leaves nap mode. Nap mode is enabled by mode control
register A1 in the serial programming mode.
DEVICE PROGRAMMING MODES
The operating modes of the LTC2175-14/LTC2174-14/
LTC2173-14 can be programmed by either a parallel in-
terface or a simple serial interface. The serial interface has
more flexibility and can program all available modes. The
parallel interface is more limited and can only program
some of the more commonly used modes.
Parallel Programming Mode
To use the parallel programming mode, PAR/SER should
be tied to VDD. The CS, SCK, SDI and SDO pins are binary
logic inputs that set certain operating modes. These pins
can be tied to VDD or ground, or driven by 1.8V, 2.5V, or
3.3V CMOS logic. When used as an input, SDO should
be driven through a 1k series resistor. Table 3 shows the
modes set by CS, SCK, SDI and SDO.
Serial Programming Mode
To use the serial programming mode, PAR/SER should be
tied to ground. The CS, SCK, SDI and SDO pins become a
serialinterfacethatprogramtheA/Dmodecontrolregisters.
Data is written to a register with a 16-bit serial word. Data
can also be read back from a register to verify its contents.
Serial data transfer starts when CS is taken low. The data
on the SDI pin is latched at the first 16 rising edges of
SCK. Any SCK rising edges after the first 16 are ignored.
The data transfer ends when CS is taken high again.
The first bit of the 16-bit input word is the R/W bit. The
next seven bits are the address of the register (A6:A0).
The final eight bits are the register data (D7:D0).
If the R/W bit is low, the serial data (D7:D0) will be writ-
ten to the register set by the address bits (A6:A0). If the
R/W bit is high, data in the register set by the address bits
(A6:A0) will be read back on the SDO pin (see the Timing
Diagrams sections). During a read back command the
register is not updated and data on SDI is ignored.
The SDO pin is an open-drain output that pulls to ground
with a 200 impedance. If register data is read back
through SDO, an external 2k pull-up resistor is required.
If serial data is only written and read back is not needed,
Table 3. Parallel Programming Mode Control Bits (PAR/SER = VDD)
Pin
DESCRIPTION
CS
2-Lane / 1-Lane Selection Bit
0 = 2-Lane, 16-Bit Serialization Output Mode
1 = 1-Lane, 14-Bit Serialization Output Mode
SCK
LVDS Current Selection Bit
0 = 3.5mA LVDS Current Mode
1 = 1.75mA LVDS Current Mode
SDI
Power Down Control Bit
0 = Normal Operation
1 = Sleep Mode
SDO
Internal Termination Selection Bit
0 = Internal Termination Disabled
1 = Internal Termination Enabled
相關PDF資料
PDF描述
SM2420L LAMP T-1.5 TELE SLIDE 24V .02A
SM1250L LAMP T-1.5 TELE SLIDE 12V .05A
SM2420M LAMP T1.25 TELE SLIDE 24V .02A
SM1250M LAMP T1.25 TELE SLIDE 12V .05A
SM1240M LAMP T1.25 TELE SLIDE 12V .04A
相關代理商/技術參數
參數描述
DC1525A-D 功能描述:BOARD DEMO 65MSPS LTC2172-14 RoHS:是 類別:未定義的類別 >> 其它 系列:* 標準包裝:1 系列:* 其它名稱:MS305720A
DC1525A-E 功能描述:BOARD DEMO 40MSPS LTC2171-14 RoHS:是 類別:未定義的類別 >> 其它 系列:* 標準包裝:1 系列:* 其它名稱:MS305720A
DC1525A-F 功能描述:BOARD DEMO 25MSPS LTC2170-14 RoHS:是 類別:未定義的類別 >> 其它 系列:* 標準包裝:1 系列:* 其它名稱:MS305720A
DC1525A-G 功能描述:BOARD DEMO 125MSPS LTC2175-12 RoHS:是 類別:未定義的類別 >> 其它 系列:* 標準包裝:1 系列:* 其它名稱:MS305720A
DC1525A-H 功能描述:BOARD DEMO 105MSPS LTC2174-12 RoHS:是 類別:未定義的類別 >> 其它 系列:* 標準包裝:1 系列:* 其它名稱:MS305720A
主站蜘蛛池模板: 新安县| 聊城市| 镇康县| 措美县| 鸡东县| 井研县| 高尔夫| 尉犁县| 遵义县| 北海市| 阳朔县| 肥西县| 中宁县| 宁都县| 沧源| 宜良县| 浦城县| 石嘴山市| 门源| 太湖县| 天镇县| 大田县| 沈丘县| 大埔县| 长阳| 乌拉特前旗| 新河县| 屯昌县| 富宁县| 孝昌县| 鄂托克前旗| 仙桃市| 南平市| 家居| 同心县| 巫山县| 兴国县| 云南省| 旌德县| 阿尔山市| 台中县|