欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: EFM32-TG210F32-SK
廠商: Energy Micro
文件頁數: 20/136頁
文件大小: 0K
描述: IC MICRO KIT GECKO 32QFN
標準包裝: 1
系列: Tiny Gecko
套件類型: 微控制器
值: 2 件 - 閃存 - 32KB
包裝: 紙板盒
安裝類型: 表面貼裝
包括封裝: 32-QFN
工具箱內容: (2) 914-1034-2-ND - MCU 32BIT 32KB FLASH 32-QFN
其它名稱: 914-1019
...the world's most energy friendly microcontrollers
2011-02-04 - d0002_Rev1.00
116
www.energymicro.com
Bits
Name
Function
0 = MPU is disabled during hard fault, NMI, and FAULTMASK handlers, regardless of the value
of the ENABLE bit
1 = the MPU is enabled during hard fault, NMI, and FAULTMASK handlers.
When the MPU is disabled, if this bit is set to 1 the behavior is Unpredictable.
[0]
ENABLE
Enables the MPU:
0 = MPU disabled
1 = MPU enabled.
When ENABLE and PRIVDEFENA are both set to 1:
For privileged accesses, the default memory map is as described in Section 2.2 (p. 14) . Any access
by privileged software that does not address an enabled memory region behaves as defined by the
default memory map.
Any access by unprivileged software that does not address an enabled memory region causes a
memory management fault.
XN and Strongly-ordered rules always apply to the System Control Space regardless of the value of
the ENABLE bit.
When the ENABLE bit is set to 1, at least one region of the memory map must be enabled for the system
to function unless the PRIVDEFENA bit is set to 1. If the PRIVDEFENA bit is set to 1 and no regions
are enabled, then only privileged software can operate.
When the ENABLE bit is set to 0, the system uses the default memory map. This has the same memory
attributes as if the MPU is not implemented, see Table 2.11 (p. 16) . The default memory map applies
to accesses from both privileged and unprivileged software.
When the MPU is enabled, accesses to the System Control Space and vector table are always permitted.
Other areas are accessible based on regions and whether PRIVDEFENA is set to 1.
Unless HFNMIENA is set to 1, the MPU is not enabled when the processor is executing the handler for
an exception with priority –1 or –2. These priorities are only possible when handling a hard fault or NMI
exception, or when FAULTMASK is enabled. Setting the HFNMIENA bit to 1 enables the MPU when
operating with these two priorities.
4.5.3 MPU Region Number Register
The RNR selects which memory region is referenced by the RBAR and RASR registers. See the register
summary in Table 4.38 (p. 114) for its attributes. The bit assignments are:
Reserved
31
8 7
0
REGION
Table 4.41. RNR bit assignments
Bits
Name
Function
[31:8]
-
Reserved.
[7:0]
REGION
Indicates the MPU region referenced by the RBAR and RASR registers.
The MPU supports 8 memory regions, so the permitted values of this field are 0-7.
Normally, you write the required region number to this register before accessing the RBAR or RASR.
However you can change the region number by writing to the RBAR with the VALID bit set to 1, see
Section 4.5.4 (p. 117) . This write updates the value of the REGION field.
相關PDF資料
PDF描述
1267 X 6" TAPE ALUMINUM FOIL 6" X 1FT
7810 0.25MM ECAP COND PAD .25MM 7.7" X 10"
7810 0.20MM ECAP COND PAD .20MM 7.7" X 10"
1170 X 6" TAPE FOIL .002" 6" X 18YDS
EFM32-TG110F32-SK IC MICRO KIT GECKO 24QFN
相關代理商/技術參數
參數描述
EFM32TG210F32-T 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 32KB FLASH 32QFN
EFM32TG210F8 功能描述:ARM微控制器 - MCU 8KB Flash 2KB RAM RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
EFM32TG210F8-QFN32 制造商:Energy Micro AS 功能描述:TINY GECKO MCU - Tape and Reel 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 8KB FLASH 32QFN
EFM32TG210F8-QFN32T 制造商:Energy Micro AS 功能描述:32 BIT ARM MPU, TINY GECKO - Trays
EFM32TG210F8-QFN32-T 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 8KB FLASH 32QFN
主站蜘蛛池模板: 盐津县| 龙山县| 竹山县| 江陵县| 吴桥县| 武义县| 屯昌县| 德庆县| 县级市| 喀什市| 托克逊县| 托克托县| 航空| 碌曲县| 彩票| 荔浦县| 讷河市| 阿合奇县| 潮州市| 多伦县| 龙川县| 绥中县| 海南省| 大宁县| 龙山县| 丁青县| 滨海县| 临潭县| 临泽县| 巩留县| 体育| 安平县| 南城县| 电白县| 松滋市| 繁昌县| 二连浩特市| 禄丰县| 江安县| 嘉祥县| 台东县|