欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: FM8P51EF
廠商: Electronic Theatre Controls, Inc.
英文描述: EPROM/ROM-Based 8-Bit Microcontroller
中文描述: 存儲器/基于ROM的8位微控制器
文件頁數: 22/60頁
文件大?。?/td> 369K
代理商: FM8P51EF
FM8P51
Rev1.2 Mar 15, 2005
P.22/FM8P51
FEELING
TECHNOLOGY
2.2 I/O Ports
Port A, port B, port C, port D and port E are bi-directional tri-state I/O ports.
All I/O pins (IOA, IOB, IOC, IOD and IOE) have data direction control registers (IOSTA, IOSTB, IOSTC, IOSTD, and
IOSTE) which can configure these pins as output or input.
IOA<7:0>, IOB<7:0>, IOC<5:4>, IOD<7:0> and IOE<5:0> have corresponding pull-high control bits (/PHBCE, /PHA,
/PHB, /PHD, and /PHE bits) to enable the weak internal pull-high. The weak pull-high is automatically turned off
when the pin is configured as an output pin.
IOC6 and IOC7 have an open-drain control bit (ODE, PCON<6>) to enable the open-drain output when these pins
are configured to be an output pin.
IOD0 and IOD1 are the R-option pins enabled by setting the ROC bit (PCON<3>). When the R-option function is
used, it is recommended that IOD0 and IOD1 are used as output pins, and read the status of IOD0 and IOD1 before
these pins are configured to be an output pin.
IOB0~IOB7, IOC4~IOC5, and IOE0~IOE1 also provide the input change interrupt/wake-up function which are
enabled by clear /WUE bit (PCON<0>). The input change interrupt/wake-up function is automatically turned off
when the pin is configured as an output pin.
FIGURE 2.3: Block Diagram of I/O PINs
Pull-high/R-option is not shown in the figure
2.3 Timer0/WDT & Prescler
2.3.1
Timer0
The Timer0 is a 8-bit timer/counter. The clock source of Timer0 comes from the internal clock.
The timer0 register (TMR0) will increment every instruction cycle (without prescaler). If TMR0 register is written, the
increment is inhibited for the following two cycles.
2.3.2 Watchdog Timer (WDT)
The Watchdog Timer (WDT) is a free running on-chip RC oscillator which does not require any external components.
So the WDT will still run even if the clock on the OSCI and OSCO pins is turned off, such as in SLEEP mode. During
normal operation or in SLEEP mode, a WDT time-out will cause the device reset and the TO bit (STATUS<4>) will
be cleared.
The WDT can be disabled by clearing the control bit WDTE (PCON<5>) to “0”.
The WDT has a nominal time-out period of 18 ms (without prescaler). If a longer time-out period is desired, a
D Q
IOST
Latch
> EN
Q
I/O PIN
D Q
DATA
Latch
> EN Q
Data bus
IOST R
WR PORT
RD PORT
相關PDF資料
PDF描述
FM8P51EP EPROM/ROM-Based 8-Bit Microcontroller
FM8P51F EPROM/ROM-Based 8-Bit Microcontroller
FM8P51P EPROM/ROM-Based 8-Bit Microcontroller
FM8P51E EPROM/ROM-Based 8-Bit Microcontroller
FM8P54 EPROM/ROM-Based 8-Bit Microcontroller Series
相關代理商/技術參數
參數描述
FM8P51EP 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller
FM8P51F 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller
FM8P51P 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller
FM8P54 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller Series
FM8P54E 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller Series
主站蜘蛛池模板: 崇文区| 手机| 长垣县| 西乌珠穆沁旗| 读书| 名山县| 建始县| 松溪县| 来安县| 盘锦市| 湾仔区| 高雄县| 拉萨市| 特克斯县| 云南省| 兴业县| 滨州市| 祁连县| 连平县| 呼图壁县| 嘉祥县| 宝兴县| 中超| 房产| 包头市| 和平县| 武宣县| 青海省| 阜南县| 新乐市| 东乡县| 江山市| 安徽省| 朝阳县| 渭源县| 旬邑县| 桂平市| 曲沃县| 漾濞| 化州市| 垣曲县|