- 您現在的位置：買賣IC網 > PDF目錄360998 > ISP1109 (NXP Semiconductors N.V.) Universal Serial Bus transceiver with carkit support PDF資料下載
參數資料
| 型號： | ISP1109 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Universal Serial Bus transceiver with carkit support |
| 中文描述： | 與車載通用串行總線收發器支持 |
| 文件頁數： | 15/59頁 |
| 文件大小： | 295K |
| 代理商： | ISP1109 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
9397 750 13355
Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Product data sheet
Rev. 01 — 14 July 2005
15 of 59
Philips Semiconductors
ISP1109
USB transceiver with carkit support
8.
Modes of operation
The ISP1109 supports four types of modes:
Power modes
Serial control modes
USB modes
Transparent modes.
8.1 Power modes
8.1.1
Normal mode
In this mode, both V
CC
and V
CC(I/O)
are connected and their voltage levels are within the
operation range (V
CC
≥
3.0 V, V
CC(I/O)
≥
1.65 V, V
CC(I/O)
≤
V
CC
).
There are three levels of power saving schemes in the ISP1109:
Active power mode: Power is on; all circuits are active.
USB suspend mode: To reduce power consumption, the USB differential receiver is
powered off.
Power-down mode: Set by writing logic 1 to bit PWR_DN of the Mode Control 2
register. The clock generator and all biasing circuits are turned off to reduce power
consumption to the minimum possible; typically I
CC
is less than 20
μ
A. For details on
waking up the clock, see
Section 10
.
8.1.2
Disable mode
In disable mode, V
CC(I/O)
is cut-off and V
CC
is powered. In this mode, the ISP1109 is in
Power-down state, if V
BUS
is below SESS_VLD threshold (0.8 V to 2.0 V).
When V
CC
is below threshold V
th(ISET)
, pin ISET will remain at the LOW level.
When V
BUS
> V
th(svc)
and V
CC
rises above V
th(ISET)
, the ISP1109 will output HIGH on
pin ISET, if any of the following conditions is detected:
Voltage on pin ID is greater than V
th(ID_FM)
DP and DM are single-ended one (SE1).
If the preceding condition is detected, pin ISET will be asserted within 1.5 ms when V
CC
rises above V
th(ISET)
.
The USB differential driver will be set in three-state as long as V
CC(I/O)
is lost. The DP
pull-up resistor (R
UP(DP)
) will be disconnected from the DP line. The DP weak pull-up
resistor (R
weakUP(DP)
) will be connected if the V
BUS
voltage is above V
th(svc)
.
8.1.3
Isolate mode
In isolate mode, V
CC
is cut-off and V
CC(I/O)
is powered. In this mode, the ISP1109 will drive
stable level to all digital output pins, and all bidirectional digital pins will be set in
three-state.
Table 10
shows a summary of power modes.
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1109BS | Universal Serial Bus transceiver with carkit support |
| ISP1122A | Universal Serial Bus stand-alone hub |
| ISP1122ABD | Universal Serial Bus stand-alone hub |
| ISP1122AD | Universal Serial Bus stand-alone hub |
| ISP1122ANB | Universal Serial Bus stand-alone hub |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1109BS | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus transceiver with carkit support |
| ISP1109BS,118 | 功能描述:射頻收發器 USB FS TRANSCVR RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1109BS,151 | 功能描述:射頻收發器 DO NOT USE ORDER -T PART RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1109BS,157 | 功能描述:射頻收發器 DO NOT USE ORDER -T PART RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1109BSFE | 功能描述:IC TXRX SERIAL BUS UNIV 32HVQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:2,500 系列:- 類型:驅動器 驅動器/接收器數:4/0 規程:RS422 電源電壓:4.5 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。