- 您現在的位置：買賣IC網 > Datasheet目錄41 > LTC1642CGN#TRPBF (Linear Technology)IC CONTROLLER HOTSWAP ADJ 16SSOP Datasheet資料下載
參數資料
| 型號： | LTC1642CGN#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 10/16頁 |
| 文件大小： | 243K |
| 描述： | IC CONTROLLER HOTSWAP ADJ 16SSOP |
| 標準包裝： | 2,500 |
| 類型： | 熱交換控制器 |
| 應用： | 通用型 Infiniband? |
| 內部開關： | 無 |
| 電源電壓： | 2.97 V ~ 16.5 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SSOP（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁
10
LTC1642
1642fb
APPLICATIO S I FOR ATIO
U
U
U
an internal servo loop adjusts the GATE pin voltage such
that Q1 acts as a constant current source. The voltage limit
across R2 increases as the output charges; this foldback
in the current limit helps to even out Q1s power dissipa-
tion. The output is sensed at the FB pin. When FB is
grounded, the sense voltage is limited to 26mV. When FB
is greater than 0.7V, the limit is 56mV and the full depen-
dence is shown in Figure 3.
When the sense resistor voltage is 3mV below its limit, the
circuit breaker timer starts. Once BRK TMR reaches its
threshold, the circuit breaker opens, the GATE pin is pulled
to ground (cutting off Q1) and FAULT is asserted.
The parameter V
CB
specified in the DC electrical character-
istics refers to the voltage difference between the V
CC
and
SENSE pins needed to start the circuit breaker timer. The
limiting value maintained by the servo loop is 3mV higher
than V
CB
.
Should the sense resistor voltage drop below its limit
before the timer trips, the GATE voltage begins ramping
back up immediately and the BRK TMR pin returns to
ground. However, due to the slow gate ramp, Q1 continues
to dissipate substantial power for some time. Connecting
R10 in series with timing capacitor C4 (as shown in
Figure 1) ensures that the circuit breaker trips in the event
of repetitive, but brief, load shorts. The delay before the
circuit breaker opens is:
t
BRKTMR
= C4 (61k& R10).
Once the circuit breaker trips, GATE and FAULT remain at
ground until the chip is restarted. To restart, hold the ON
pin low for at least 2祍 and FAULT will go high. Then take
ON high again and the GATE will ramp up after a system
timing cycle. Or, configure the LTC1642 to restart itself
after the circuit breaker trips by connecting FAULT to the
ON pin, as shown in the next section.
The servo loop controlling Q1 during current limit has a
unity-gain frequency of about 125kHz. In Figure 1, R4 and
C2 provide compensation. To ensure stability the product
1/(2 " ?" R4 " C2) should be kept below the unity-gain
frequency, and C2 should be more than Q1s input capaci-
tance C
ISS
. A good starting point for C2 is 0.047礔 and R4
is 330&. Keep R4 e 100&.
Typical waveforms during a load short to ground are
shown in Figure 4. The load is shorted to ground at time 1.
The GATE voltage drops until the load current equals its
maximum limit, and the circuit breaker timer starts. The
short is cleared at time 2, before the timer trips. The BRK
TMR pin returns to ground, and the GATE voltage begins
ramping up. At time 3 the load is shorted again and at time
4 the timer trips, pulling the GATE to ground and asserting
FAULT. Although the short is cleared at time 5, FAULT
doesnt go high until the ON pin is pulled low at time 6. At
time 7 ON goes high and the system timer starts. When it
trips at time 8 the GATE voltage begins ramping.
To disable current limit and electronic circuit breaker
protection, tie the SENSE pin to V
CC
, the BRK TMR pin to
GND and omit compensating resistor R4.
FB PIN VOLTAGE (mV)
0
0.1
0.2
0.3
0.4
0.5
0.6
0.7
0.8 0.9 1
1642 F03
70
60
50
40
30
20
10
0
Figure 3. Foldback Current Limit
Figure 4. Current Limit and Circuit Breaker Timing
40ms/DIV
1642 F04
t
1
t
2
t
3
t
4
t
5
t
7
t
6
t
8
RST TMR
2V/DIV
ON
20V/DIV
FAULT
20V/DIV
BRK TMR
2V/DIV
V
OUT
20V/DIV
GATE
20V/DIV
I
LOAD
5A/DIV
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1643AL-1CGN#PBF | IC CTRLR HOTSWAP PCI BUS 16SSOP |
| LTC1644CGN#TRPBF | IC CONTROLLER HOT SWAP 20-SSOP |
| LTC1645IS#TRPBF | IC CTRLR SEQ HOTSWAP DUAL 14SOIC |
| LTC1646IGN#TR | IC CNTRLR HOTSWAP PCIDUAL 16SSOP |
| LTC1647-1IS8#TRPBF | IC CONTROLLR HOTSWAP DUAL 8-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1642IGN | 功能描述:IC CONTROLLER HOTSWAP ADJ 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC1642IGN#PBF | 功能描述:IC CONTROLLER HOTSWAP ADJ 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC1642IGN#TR | 功能描述:IC CONTROLLER HOTSWAP ADJ 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC1642IGN#TRPBF | 功能描述:IC CONTROLLER HOTSWAP ADJ 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC1643AHCGN | 功能描述:IC CTRLR HOTSWAP PCI BUS 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
發布緊急采購，3分鐘左右您將得到回復。