- 您現在的位置：買賣IC網 > Datasheet目錄42 > LTC4223CDHD-2#PBF (Linear Technology)IC CNTRLR HOT SWAP DUAL 16-DFN Datasheet資料下載
參數資料
| 型號： | LTC4223CDHD-2#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 9/24頁 |
| 文件大小： | 290K |
| 描述： | IC CNTRLR HOT SWAP DUAL 16-DFN |
| 標準包裝： | 73 |
| 類型： | 熱交換控制器 |
| 應用： | ATCA，MicroTCA? |
| 內部開關： | 無 |
| 電源電壓： | 2.7 V ~ 6 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 16-DFN（5x4） |
| 包裝： | 管件 |
LTC4223-1/LTC4223-2
9
422312f
OPERATION
The LTC4223 is designed to control the power on an Ad-
vanced Mezzanine Card (AMC) or MicroTCA backplane,
allowing boards to be safely inserted and removed. It
controls the 12V main and 3.3V auxiliary power through an
external N-channel MOSFET and integrated pass transistor.
These two supplies can be turned on and off independently
by their respective ON control pins.
If either AUXON or 12ON is pulled high, an initial tim-
ing cycle set by the TIMER capacitor value is initiated
once all these conditions are met: input supplies out of
undervoltage lockout; TIMER < 0.2V and
?/DIV>
E
?/DIV>
N low. At the
end of the initial timing cycle, if the AUXON pin is high, the
internal pass transistor turns on. It enters into an active
current limit loop if the inrush current charging the load
capacitor exceeds 240mA. When the load is in current
limit, a 10糀 pull-up charges the TIMER pin capacitor. If
the load capacitor is fully charged and the switch is no
longer in current limit before the TIMER reaches 1.235V,
?/DIV>
A
?/DIV>
U
?/DIV>
X
?/DIV>
P
?/DIV>
G
?/DIV>
O
?/DIV>
O
?/DIV>
D pulls low indicating that power is good.
Otherwise the internal switch turns off and
?/DIV>
F
?/DIV>
A
?/DIV>
U
?/DIV>
L
?/DIV>
T pulls
low when TIMER reaches 1.235V.
If 12ON pin is high at the end of the initial timing cycle,
an internal charge pump charges the gate of the external
MOSFET with 10糀 pull-up. Connecting an external gate
capacitor limits the inrush current charging the load ca-
pacitor. If the inrush current exceeds its limited current
value, an internal analog current limit (ACL) ampli er
servos the gate to force 60mV across the external sense
resistor connected between 12VIN and 12V
SENSE
pins.
During this period, TIMER pin capacitor is charged by a
200糀 pull-up. If the load is fully charged and no longer in
current limit before the TIMER reaches 1.235V,
?/DIV>
1
?/DIV>
2
?/DIV>
P
?/DIV>
G
?/DIV>
O
?/DIV>
O
?/DIV>
D
pulls low. Otherwise 12V shuts off and
?/DIV>
F
?/DIV>
A
?/DIV>
U
?/DIV>
L
?/DIV>
T pulls low
when TIMER reaches 1.235V.
If an overcurrent fault occurs on the auxiliary supply after
power-up, the current is limited to 240mA and after a 25約
delay, the circuit breaker trips and
?/DIV>
F
?/DIV>
A
?/DIV>
U
?/DIV>
L
?/DIV>
T pulls low. Ther-
mal shutdown protects the internal pass transistor from
overheating by shutting it off at 150癈. If an overcurrent
fault occurs on the 12V supply, the current is limited to
60mV/R
SENSE
. After a timing cycle delay set by 200糀
charging the TIMER capacitor, the circuit breaker trips
and
?/DIV>
主站蜘蛛池模板：
永吉县|
习水县|
台州市|
定陶县|
东丰县|
浦江县|
莎车县|
虹口区|
长宁县|
平乐县|
绵阳市|
兰西县|
博兴县|
五家渠市|
荆门市|
肇庆市|
星座|
北辰区|
伊川县|
玉屏|
蒙自县|
涿鹿县|
新化县|
万源市|
陵川县|
雷山县|
宁晋县|
兴安县|
都江堰市|
当涂县|
温泉县|
项城市|
镶黄旗|
曲阳县|
嘉祥县|
漳平市|
通化县|
和林格尔县|
武宣县|
和平区|
临沂市|
F
?/DIV>
A
?/DIV>
U
?/DIV>
L
?/DIV>
T pulls low. An overcurrent fault on the auxiliary
supply shuts off 12V; a fault on the 12V supply does not
affect the auxiliary supply.
The LTC4223 provides high side current sensing informa-
tion for the 12V supply at the 12IMON pin. The 12IMON
output voltage is 33 times the sense voltage, allowing it
to be used with an external ADC.
In the off condition, 12V
OUT
and AUXOUT are discharged
to ground by internal N-channel pull downs.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4224IDDB-2#TRPBF | IC CNTRLR HOT SWAP DUAL 10-DFN |
| LTC4225IGN-1#PBF | IC CONTROLLER HOT SWAP 24-SSOP |
| LTC4230CGN#TRPBF | IC CONTRLLR HOT SWAP TRPL 20SSOP |
| LTC4232CDHC#TRPBF | IC CTLR HOT SWAP 5A 16-DFN |
| LTC4240IGN#TRPBF | IC CTRLR HOTSWAP CPCI I2C 28SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4223CDHD-2TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Supply Hot Swap Controller for Advanced Mezzanine Card |
| LTC4223CGN-1#PBF | 功能描述:IC CNTRLR HOT SWAP DUAL 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LTC4223CGN-1#TRPBF | 功能描述:IC CNTRLR HOT SWAP DUAL 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LTC4223CGN-1PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Supply Hot Swap Controller for Advanced Mezzanine Card |
| LTC4223CGN-1TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Supply Hot Swap Controller for Advanced Mezzanine Card |
發布緊急采購，3分鐘左右您將得到回復。