- 您現在的位置：買賣IC網 > PDF目錄382289 > MBM30LV0064-PFTN (FUJITSU LTD) 64M (8M X 8) BIT NAND-type PDF資料下載
參數資料
| 型號： | MBM30LV0064-PFTN |
| 廠商： | FUJITSU LTD |
| 元件分類： | DRAM |
| 英文描述： | 64M (8M X 8) BIT NAND-type |
| 中文描述： | 8M X 8 FLASH 3.3V PROM, 7000 ns, PDSO40 |
| 封裝： | 0.80 MM PITCH, PLASTIC, TSOP2-44/40 |
| 文件頁數： | 35/43頁 |
| 文件大?。?/td> | 397K |
| 代理商： | MBM30LV0064-PFTN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁當前第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁
MBM30LV0064
35
(12) Invalid block (bad block)
The device contains unusable blocks. Therefore, the following issues must be recognized:
(13) Failure Phenomena for Program and Erase Operations
Repeated rewriting might cause an error at programming and erasing. Possible error modes, and detection
methods and remedies are listed in the following table. System-based remedies will provide a highly reliable
system.
* : (1) or (2)
ECC
:
Error Correcting code
→
Hamming Code etc.
Example : 1 bit correction & 2 bit detection.
Block Replacement
Erase
If an error occurs at erasing, like programming, remedies should be executed on a system basis to prevent
access to blocks causing the error.
Failure Mode
Detection and Countermeasure Sequence
Block
Erase Failure
Status Read after Erase
→
Block Replacement
Page
Program Failure
Status Read after Prog.
→
Block Replacement
Single Bit*
Program Failure
‘1’
→
‘0’
(1) Block Verify after Prog.
→
Retry
(2) ECC
Bad Block
Bad Block
Valid (Good) Block Number
Min.
1014
Typ.
1020
Max.
1024
Unit
Block
Figure 36. Shows the Bad Block Test Flow
Some MBM30LV0064 products have invalid blocks (bad blocks) at
shipping. After mounting the device in the system, test whether
there are no bad blocks. If there are any bad blocks, they should
not be accessed.
The bad blocks are connected to sense-amp of the bit lines via the
selector transistors. Good blocks will not be affected unless the bad
blocks are accessed. The effective number of good blocks
specified by Fujitsu is shown below.
Figure 34 Bad Block
Program
Buffer
Memory
error occurs
Block A
Block B
If an error occurs in block A, reprogramming from
the external buffer to block B. Block A should not
be accessed after an error occurs.
Figure 35 Reprogramming to Good Block
相關PDF資料 |
PDF描述 |
|---|---|
| MBM30LV0064-PFTR | 64M (8M X 8) BIT NAND-type |
| MBM30LV0032 | 32M (4M X 8) BIT NAND-type |
| MBM30LV0032-PFTN | 32M (4M X 8) BIT NAND-type |
| MBM30LV0032-PFTR | RES 150-OHM 1% 0.063W 200PPM THICK-FILM SMD-0402 10K/REEL-7IN-PA |
| MBM30LV0064 | 64M (8M X 8) BIT NAND-type |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MBM30LV0064-PFTR | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:64M (8M X 8) BIT NAND-type |
| MBM30LV0128 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:128 M (16 M X 8) BIT NAND-type |
| MBM30LV0128-PFTN | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:128 M (16 M X 8) BIT NAND-type |
| MBM30LV0128-PFTR | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:128 M (16 M X 8) BIT NAND-type |
| MBM31048901 | 制造商:LG Corporation 功能描述:Card |
發布緊急采購，3分鐘左右您將得到回復。