欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: MC1GH256DACA-2SA00
廠商: SAMSUNG SEMICONDUCTOR CO. LTD.
英文描述: SAMSUNG MultiMediaCard
中文描述: 三星多媒體
文件頁數: 79/102頁
文件大小: 1384K
代理商: MC1GH256DACA-2SA00
MultiMediaCard
TM
79
Sep.22.2005
Revision 0.3
Introduction
The SPI mode consists of a secondary, optional communication protocol which is offered by Flash-based MultiMedi-
aCards. This mode is a subset of the MultiMediaCard protocol, designed to communicate with a SPI channel, commonly
found in Motorola’s (and lately a few other vendors’) microcontrollers. The interface is selected during the first reset com-
mand after power up (CMD0) and cannot be changed once the part is powered on.
The SPI standard defines the physical link only, and not the complete data transfer protocol. The MultiMediaCard SPI
implementation uses a subset of the MultiMediaCard protocol and command set. It is intended to be used by systems
which typically require one card and have lower data transfer rates (compared to MultiMediaCard protocol based sys-
tems). From the application point of view, the advantage of the SPI mode is the capability of using an off-the-shelf host,
hence reducing the design-in effort to minimum. The disadvantage is the loss of performance of the SPI mode versus Mul-
tiMediaCard mode (lower data transfer rate, hardware CS, etc.).
7.1 SPI Interface Concept
The Serial Peripheral Interface (SPI) is a general purpose synchronous serial interface originally found on certain Motorola
microcontrollers. A virtually identical interface can now be found on certain TI and SGS Thomson microcontrollers as well.
The MultiMediaCard SPI interface is compatible with SPI hosts available on the market. As in any other SPI device, the
MultiMediaCard SPI channel consists of the following four signals:
CS
: Host to card Chip Select signal.
CLK
:Host to card clock signal
DataIn
:Host to card data signal.
DataOut
: Card to host data signal.
Another SPI common characteristic is byte transfers, which is implemented in the card as well. All data tokens are multi-
ples of bytes (8 bit) and always byte aligned to the CS signal.
7.2 SPI Bus Topology
The card identification and addressing methods are replaced by a hardware Chip Select (CS) signal. There are no broad-
cast commands. For every command, a card (slave) is selected by asserting (active low) the CS signal (see Figure ).
The CS signal must be continuously active for the duration of the SPI transaction (command, response and data). The
only exception occurs during card programming, when the host can de-assert the CS signal without affecting the program-
ming process.
The bidirectional CMD and DAT lines are replaced by unidirectional
dataIn
and
dataOut
signals.
The MultiMediaCard pin assignment in SPI mode (compared to MultiMediaCard mode) is given in Table 7-1.
7. SPI Mode
相關PDF資料
PDF描述
MC2GH01GDMCA-2SA00 SAMSUNG MultiMediaCard
MC2GH256NMCA-2SA00 SAMSUNG MultiMediaCard
MC2GH512DMCA-2SA00 SAMSUNG MultiMediaCard
MC2GH512NMCA-2SA00 SAMSUNG MultiMediaCard
MC4GH01GNMCA-2SA00 SAMSUNG MultiMediaCard
相關代理商/技術參數
參數描述
MC1GU016HACA 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:MultiMediaCard Specification
MC1GU016HACA-0QC00 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:MultiMediaCard Specification
MC1GU016HACB-0QC00 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:MultiMediaCard Specification
MC1GU016HACC-0QC00 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:MultiMediaCard Specification
MC1GU016HAFA-0QC00 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:MultiMediaCard Specification
主站蜘蛛池模板: 封丘县| 普兰县| 东台市| 九寨沟县| 曲阳县| 厦门市| 濮阳市| 六盘水市| 庄浪县| 桂林市| 旺苍县| 钟山县| 临江市| 阿合奇县| 古浪县| 荥阳市| 乐亭县| 南川市| 丹阳市| 堆龙德庆县| 邵东县| 门头沟区| 威信县| 临猗县| 大余县| 鄢陵县| 新丰县| 建水县| 江安县| 天门市| 吐鲁番市| 磴口县| 齐齐哈尔市| 龙陵县| 什邡市| 宜春市| 迁西县| 甘孜县| 温宿县| 科技| 桓台县|