- 您現在的位置：買賣IC網 > PDF目錄371047 > MC68HC05X4CDW (MOTOROLA INC) HCMOS Microcontroller Unit PDF資料下載
參數資料
| 型號： | MC68HC05X4CDW |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | HCMOS Microcontroller Unit |
| 中文描述： | 8-BIT, MROM, 2.2 MHz, MICROCONTROLLER, PDSO28 |
| 封裝： | PLASTIC, SOIC-28 |
| 文件頁數： | 52/156頁 |
| 文件大小： | 926K |
| 代理商： | MC68HC05X4CDW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁當前第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁
Resets, Interrupts and Low Power Modes
MC68HC05X4
52
Resets, Interrupts and Low Power Modes
For More Information On This Product,
Go to: www.freescale.com
MOTOROLA
WOI interrupt is bit 5 of the port configuration register ($03). This latch is
set by the WOI, and is cleared by writing a zero to the bit. A WOI will
cause the MPU to exit from STOP mode.
Real time and
core timer
(C TIMER) interrupts
There are two different core timer interrupt flags that cause a CTIMER
interrupt whenever an interrupt is enabled and its flag becomes set,
namely RTIF and CTOF. The interrupt flags and enable bits are located
in the CTIMER control and status register (CTCSR). These interrupts will
vector to the same interrupt service routine, whose start address is
contained in memory locations $1FF8 and $1FF9 (see
Core timer
control and status register (CTCSR)
and
Figure 1
).
To make use of the real time interrupt the RTIE bit must first be set. The
RTIF bit will then be set after the specified number of counts.
To make use of the core timer overflow interrupt the CTOFE bit must first
be set. The CTOF bit will then be set when the core timer counter
register overflows from $FF to $00.
Programmable
16-bit timer
interrupt
There are three different timer interrupt flags (ICF, OCF, TOF) that
cause a timer interrupt whenever they are set and enabled. The timer
interrupt enable bits (ICIE, OCIE, TOIE) are located in the timer control
register (TCR) and the timer interrupt flag is located in the timer status
register (TSR). All three interrupts will vector to the same service routine,
whose start address is contained in memory locations $1FF4 and
$1FF5.
Hardware
controlled
interrupt
sequence
The following three functions (RESET, STOP, and WAIT) are not in the
strictest sense interrupts. However, they are acted upon in a similar
manner. Flowcharts for STOP and WAIT are shown in
Figure 3
.
RESET:
A reset condition causes the program to vector to its
starting address, which is contained in memory locations
$1FFE (MSB) and $1FFF (LSB). The I-bit in the condition
code register is also set, to disable interrupts.
STOP:
The STOP instruction causes the oscillator to be turned off
and the processor to ‘sleep’ until an external interrupt
6-resets
F
Freescale Semiconductor, Inc.
n
.
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HC05X4DW | HCMOS Microcontroller Unit |
| MC68HC705X4 | HCMOS Microcontroller Unit |
| MC68HC705X4CDW | HCMOS Microcontroller Unit |
| MC68HC705X4DW | HCMOS Microcontroller Unit |
| MC68HC08AB16A | Low Cost HCMOS Microcontroller(低成本、8位HCMOS微控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC05X4DW | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS Microcontroller Unit |
| MC68HC08AB16A | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers |
| MC68HC08AB16AD | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers |
| MC68HC08AZ0 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Advance Information |
| MC68HC08AZ0CFU | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Advance Information |
發布緊急采購，3分鐘左右您將得到回復。