欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: MC68HC11A8BCFU2
廠商: MOTOROLA INC
元件分類: 微控制器/微處理器
英文描述: HCMOS Single-Chip Microcontroller
中文描述: 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PQFP64
封裝: QFP-64
文件頁數: 33/158頁
文件大?。?/td> 776K
代理商: MC68HC11A8BCFU2
MC68HC11A8
TECHNICAL DATA
ON-CHIP MEMORY
MOTOROLA
3-7
3
EELAT — EEPROM Latch Control
0 = EEPROM Address and Data Configured for Read Mode
1 = EEPROM Address and Data Configured for Programming/Erasing
EEPGM — EEPROM Programming Voltage Enable
0 = Programming Voltage Switched Off
1 = Programming Voltage Turned On
If an attempt is made to set both the EELAT and EEPGM bits in the same write cycle,
neither will be set. If a write to an EEPROM address is performed while the EEPGM
bit is set, the write is ignored and the programming operation currently in progress is
not disturbed. These two safeguards were included to prevent accidental EEPROM
changes in cases of program runaway. Mask sets A38P, A49N, and date codes before
86xx did not have these safeguards.
3.5.2 Programming/Erasing Internal EEPROM
The EEPROM programming and erasure process is controlled by the PPROG regis-
ter. The following paragraphs describe the various operations performed on the EE-
PROM and include example program segments to demonstrate programming and
erase operations.
These program segments are intended to be simple straightforward examples of the
sequences needed for basic program and erase operations. There are no special re-
strictions on the address modes used and bit manipulation instructions may be used.
Other MCU operations can continue to be performed during EEPROM programming
and erasure provided these operations do not include reads of data from EEPROM
(the EEPROM is disconnected from the read data bus during EEPROM program and
erase operations). The subroutine DLY10 used in these program segments is not
shown but can be any set of instructions which takes ten milliseconds.
3.5.2.1 Read
For the read operation the EELAT bit in the PPROG register must be clear. When this
bit is cleared, the remaining bits in the PPROG register have no meaning or effect, and
the EEPROM may be read as if it were a normal ROM.
3.5.2.2 Programming
During EEPROM programming, the ROW and BYTE bits are not used. If the E clock
frequency is 1 MHz or less, the CSEL bit in the OPTION register must be set. Recall
that in this EEPROM, zeros must be erased by a separate erase operation before pro-
gramming. The following program segment demonstrates how to program an EE-
PROM byte.
相關PDF資料
PDF描述
MC68HC11A8BCP2 HCMOS Single-Chip Microcontroller
MC68HC11A8BMP2 HCMOS Single-Chip Microcontroller
MC68HC11A8BVP2 HCMOS Single-Chip Microcontroller
MC68HC11A1CFN2 HCMOS Single-Chip Microcontroller
MC68HCP11A1CFN2 HCMOS Single-Chip Microcontroller
相關代理商/技術參數
參數描述
MC68HC11A8BCP2 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HCMOS Single-Chip Microcontroller
MC68HC11A8BMP2 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HCMOS Single-Chip Microcontroller
MC68HC11A8BVP2 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HCMOS Single-Chip Microcontroller
MC68HC11A8FN 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:8-Bit Microcontrollers
MC68HC11A8FN1 制造商:Motorola Inc 功能描述:
主站蜘蛛池模板: 东至县| 夏津县| 江门市| 齐齐哈尔市| 高唐县| 红河县| 武汉市| 珠海市| 巴东县| 腾冲县| 改则县| 榆社县| 安达市| 黄浦区| 新丰县| 肥西县| 鄂托克前旗| 桦川县| 和政县| 南岸区| 沁阳市| 永济市| 汝南县| 富裕县| 奇台县| 新安县| 无极县| 保康县| 寻乌县| 镇平县| 镇江市| 汪清县| 昔阳县| 四会市| 汝南县| 赣榆县| 惠州市| 扶余县| 自贡市| 霸州市| 临颍县|