- 您現在的位置：買賣IC網 > PDF目錄361091 > NCP1217P133G (ON SEMICONDUCTOR) Enhanced PWM Current−Mode Controller for High−Power Universal Off−Line Supplies PDF資料下載
參數資料
| 型號： | NCP1217P133G |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 穩壓器 |
| 英文描述： | Enhanced PWM Current−Mode Controller for High−Power Universal Off−Line Supplies |
| 中文描述： | 0.5 A SWITCHING CONTROLLER, 146 kHz SWITCHING FREQ-MAX, PDIP8 |
| 封裝： | LEAD FREE, PLASTIC, DIP-8 |
| 文件頁數： | 10/18頁 |
| 文件大?。?/td> | 249K |
| 代理商： | NCP1217P133G |
NCP1217, NCP1217A
http://onsemi.com
10
Figure 18. Typical Waveforms in Short Circuit Conditions
VCC
ON
= 12.8 V
V
CC
DRIVING PULSES
VCC
min
= 7.6 V
VCC
latch
= 5.6 V
Calculating the V
CC
Capacitor
The V
CC
capacitor can be calculated knowing the IC
consumption as soon as V
CC
reaches 12.8 V. Suppose that a
NCP1217P065 is used and drives a MOSFET with a 30 nC
total gate charge (Qg). The total average current is thus
made of ICC1 (750
A) plus the driver current,
Fsw * Qg
1.95 mA
. The total current is therefore 2.7 mA.
The V available to fully startup the circuit (e.g. never reach
the 8.2 V VCC
min
during power on) is
13.78.2
best case or 4.9 V worse case
(11.97.0)
. We have a
capacitor that then needs to supply the NCP1217 with
2.7 mA during a given time until the auxiliary supply takes
over. Suppose that this time was measured at around 15 ms.
CV
CC
is calculated using the equation
C
C
8.3 F.
Select a 22 F/25 V and this will fit.
5.5 V
t · i
V
or
Skipping Cycle Mode
The NCP1217 automatically skips switching cycles when
the output power demand drops below a given level. This is
accomplished by monitoring the FB pin. In normal
operation, pin 2 imposes a peak current accordingly to the
load value. If the load demand decreases, the internal loop
asks for less peak current. When this setpoint reaches a
determined level (Vpin 1), the IC prevents the current from
decreasing further down and starts to blank the output
pulses: the IC enters the socalled skip cycle mode, also
named controlled burst operation. The power transfer now
depends upon the width of the pulse bunches (Figure 20).
Suppose we have the following component values:
Lp, primary inductance = 350 H
Fsw, switching frequency = 65 kHz
Ip skip = 600 mA (or 333 mV/Rsense)
The
2· Lp · Ip2· Fsw
mode with a bunch length of 10 ms over a recurrent
period of 100 ms, then the total power transfer is:
4.1 * 0.1
410 mW
.
To better understand how this skip cycle mode takes place,
a look at the operation mode versus the FB level
immediately gives the necessary insight.
theoretical
power
transfer
is
therefore:
1
4.1 W
. If this IC enters skip cycle
Figure 19.
SKIP CYCLE OPERATION
I
P(min)
= 333 mV/R
SENSE
NORMAL CURRENT
MODE OPERATION
FB
1 V
4.2 V, FB Pin Open
3.2 V, Upper
Dynamic Range
Time
When FB is above the skip cycle threshold (1.0 V by
default), the peak current cannot exceed 1.0 V/Rsense.
When the IC enters the skip cycle mode, the peak current
cannot go below Vpin1/3.3. The user still has the flexibility
to alter this 1.0 V by either shunting pin 1 to ground through
a resistor or raising it through a resistor up to the desired
level. In this later case, care must be taken to keep sufficient
margin between this pin 1 adjustment level and the latchoff
level. Grounding pin 1 permanently invalidates the skip
cycle operation.
相關PDF資料 |
PDF描述 |
|---|---|
| NCP1217P65G | Enhanced PWM Current−Mode Controller for High−Power Universal Off−Line Supplies |
| NCP1217P65 | Enhanced PWM Current-Mode Controller for High-Power Universal Off-Line Supplies |
| NCP1337 | PWM Current−Mode Controller for Free Running Quasi−Resonant Operation |
| NCP1337DR2G | PWM Current−Mode Controller for Free Running Quasi−Resonant Operation |
| NCP1337PG | PWM Current−Mode Controller for Free Running Quasi−Resonant Operation |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCP1217P65 | 功能描述:電流型 PWM 控制器 Enhanced Current RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1217P65G | 功能描述:電流型 PWM 控制器 Enhanced Current Mode PWM RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1218 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:PWM Controller with Adjustable Skip Level and External Latch Input |
| NCP1218AD65R2G | 功能描述:電流型 PWM 控制器 ANA PWM CONTROLLER RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1219 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:PWM Controller with Adjustable Skip Level and External Latch Input |
發布緊急采購，3分鐘左右您將得到回復。