- 您現在的位置：買賣IC網 > PDF目錄361091 > NCP1217P133G (ON SEMICONDUCTOR) Enhanced PWM Current−Mode Controller for High−Power Universal Off−Line Supplies PDF資料下載
參數資料
| 型號： | NCP1217P133G |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 穩壓器 |
| 英文描述： | Enhanced PWM Current−Mode Controller for High−Power Universal Off−Line Supplies |
| 中文描述： | 0.5 A SWITCHING CONTROLLER, 146 kHz SWITCHING FREQ-MAX, PDIP8 |
| 封裝： | LEAD FREE, PLASTIC, DIP-8 |
| 文件頁數： | 13/18頁 |
| 文件大小： | 249K |
| 代理商： | NCP1217P133G |
NCP1217, NCP1217A
http://onsemi.com
13
In normal operation, the Adj pin level is kept at a fixed
level, the default one or lower. As soon as some external
signal pulls this Adj pin level above 3.1 V typical, the output
pulses are permanently disabled. Care must be taken to limit
the injected current into pin 1 to less than 2.0 mA, e.g.
through a series resistor of 5.6 k with a 10 V V
CC
. The
startup switch is activated every time V
CC
reaches 5.6 V and
maintains a V
CC
voltage ramping up and down between
5.6 V and 12.8 V. Reset occurs when V
CC
falls below 5.6 V,
e.g. when the user cycle the SMPS down. Figure 25
illustrates the operation. Adding a zener diode from Q1 base
to ground makes a cheap OVP, protecting the supply from
any lethal openloop operation. If a thermistor (NTC) is
added in parallel with the Zenerdiode, overtemperature
protection is also ensured.
Figure 25. A Thermistor and a Zener Diode Offer
Both OVP and Overtemperature LatchedOff
Protection
Laux
8
7
6
5
1
2
3
4
Vaux
CV
CC
16 V
OVP
T
Nonlatching Shutdown
In some cases, it might be desirable to shut off the part
temporarily and authorize its restart once the default has
disappeared. This option can easily be accomplished
through a single NPN bipolar transistor wired between FB
and ground. By pulling FB below the Adj Pin 1 level, the
output pulses are disabled as long as FB is pulled below
Pin 1. As soon as FB is relaxed, the IC resumes its operation.
Figure 26
depicts the application example.
Figure 26. Another Way of Shutting Down the IC
Without a Definitive Latchoff State
8
7
6
5
1
2
3
4
Q1
ON/OFF
Protecting the Controller Against Negative Spikes
As with any controller built upon a CMOS technology, it
is the designer’s duty to avoid the presence of negative
spikes on sensitive pins. Negative signals have the bad habit
to forward bias the controller substrate and induce erratic
behaviors. Sometimes, the injection can be so strong that
internal parasitic SCRs are triggered, engendering
irremediable damages to the IC if a low impedance path is
offered between V
CC
and GND. If the current sense pin is
often the seat of such spurious signals, the highvoltage pin
can also be the source of problems in certain circumstances.
During the turnoff sequence, e.g. when the user unplugs the
power supply, the controller is still fed by its V
CC
capacitor
and keeps activating the MOSFET ON and OFF with a peak
current limited by Rsense. Unfortunately, if the quality
coefficient Q of the resonating network formed by Lp and
Cbulk is low (e.g. the MOSFET Rdson + Rsense are small),
conditions are met to make the circuit resonate and thus
negatively bias the controller. Since we are talking about ms
pulses, the amount of injected charge (Q = I * t) immediately
latches the controller that brutally discharges its V
CC
capacitor. If this V
CC
capacitor is of sufficient value, its
stored energy damages the controller. Figure 27 depicts a
typical negative shot occurring on the HV pin where the
brutal V
CC
discharge testifies for latchup.
相關PDF資料 |
PDF描述 |
|---|---|
| NCP1217P65G | Enhanced PWM Current−Mode Controller for High−Power Universal Off−Line Supplies |
| NCP1217P65 | Enhanced PWM Current-Mode Controller for High-Power Universal Off-Line Supplies |
| NCP1337 | PWM Current−Mode Controller for Free Running Quasi−Resonant Operation |
| NCP1337DR2G | PWM Current−Mode Controller for Free Running Quasi−Resonant Operation |
| NCP1337PG | PWM Current−Mode Controller for Free Running Quasi−Resonant Operation |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCP1217P65 | 功能描述:電流型 PWM 控制器 Enhanced Current RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1217P65G | 功能描述:電流型 PWM 控制器 Enhanced Current Mode PWM RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1218 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:PWM Controller with Adjustable Skip Level and External Latch Input |
| NCP1218AD65R2G | 功能描述:電流型 PWM 控制器 ANA PWM CONTROLLER RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1219 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:PWM Controller with Adjustable Skip Level and External Latch Input |
發布緊急采購，3分鐘左右您將得到回復。