- 您現在的位置：買賣IC網 > PDF目錄361091 > NCP1395A (ON SEMICONDUCTOR) High Performance Resonant Mode Controller(高性能諧振模式控制器) PDF資料下載
參數資料
| 型號： | NCP1395A |
| 廠商： | ON SEMICONDUCTOR |
| 英文描述： | High Performance Resonant Mode Controller(高性能諧振模式控制器) |
| 中文描述： | 高性能諧振模式控制器（高性能諧振模式控制器） |
| 文件頁數： | 21/27頁 |
| 文件大小： | 335K |
| 代理商： | NCP1395A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁
NCP1395A/B
http://onsemi.com
21
To the contrary, when the internal BO signal is high
(A and B pulse), the IBO source is activated and creates
a hysteresis. The hysteresis level actually depends
on the circuit: NCP1395A features a 28 A whereas
the NCP1395B uses a 83
A current. Changes are
implemented to a) reduce the standby power on the
NCP1395A b) improve the noise immunity on the
NCP1395B. Knowing these values, it becomes possible to
select the turnon and turnoff levels via a few lines of
algebra:
IBO is off
V(
)
Vbulk1
Rlower
Rlower
Rupper
(eq. 1)
IBO is on
V(
)
Vbulk2
Rlower
Rlower
Rupper
IBO
Rlower
Rlower
Rupper
Rupper
(eq. 2)
We can now extract Rlower from Equation 1 and plug it
into Equation 2, then solve for Rupper:
Rupper
Rlower
Vbulk1VBO
VBO
Rlower
VBO
Vbulk1Vbulk2
IBO
(Vbulk1VBO)
If we decide to turn on our converter for Vbulk1 equals
350 V, and turn it off for Vbulk2 equals 250 V, then we
obtain:
IBO = 28 A
Rupper = 3.6 M
Rlower = 10 k
The bridge power dissipation is 400
2
/3.601 M =
45 mW when the frontend PFC stage delivers 400 V.
IBO = 83 A
Rupper = 1.2 M
Rlower = 3.4 k
The bridge power dissipation is 132 mW when the
frontend PFC stage delivers 400 V. Figure 46 simulation
result confirms our calculations.
LatchOff Protection
There are some situations where the converter shall be
fully turned off and stay latched. This can happen in
presence of an overvoltage (the feedback loop is drifting)
or when an overtemperature is detected. Due to the addition
of a comparator on the BO pin, a simple external circuit can
lift up this pin above VLATCH (5.0 V typical) and
permanently disable pulses. The V
CC
needs to be cycled
down below 5.0 V typically to reset the controller.
+
20 s
RC
To permanent
latch
+
Vlatch
IBO
Vdd
+
BO
+VBO
BO
Rlower
Rupper
Vbulk
V
CC
Q1
NTC
Vout
Figure 47. Adding a comparator on the BO pin offers a way to latchoff the controller.
In Figure 47, Q1 is blocked and does not bother the BO
measurement as long as the NTC and the optocoupler are
not activated. As soon as the secondary optocoupler senses
an OVP condition, or the NTC reacts to a high ambient
temperature, Q1 base is brought to ground and the BO pin
goes up, permanently latching off the controller.
相關PDF資料 |
PDF描述 |
|---|---|
| NCP1395B | High Performance Resonant Mode Controller(高性能諧振模式控制器) |
| NCP1400A(中文) | 100 mA, Fixed Frequency PWM Step-Up Micropower Switching Regulator(100mA,固定頻率PWM升壓微功率開關穩壓器) |
| NCP1400ASN30T1(中文) | 100 mA, Fixed Frequency PWM Step-Up Micropower Switching Regulator(微功率固定頻率脈寬調制升壓直流-直流交換器) |
| NCP1400ASN33T1(中文) | 100 mA, Fixed Frequency PWM Step-Up Micropower Switching Regulator(微功率固定頻率脈寬調制升壓直流-直流交換器) |
| NCP1400ASN50T1(中文) | 100 mA, Fixed Frequency PWM Step-Up Micropower Switching Regulator(微功率固定頻率脈寬調制升壓直流-直流交換器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCP1395ADR2G | 功能描述:電壓模式 PWM 控制器 PWM CONTROLLER RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| NCP1395APG | 功能描述:電壓模式 PWM 控制器 PWM CONTROLLER RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| NCP1395B | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:High Performance Resonant Mode Controller |
| NCP1395BDR2G | 功能描述:電壓模式 PWM 控制器 PWM CONTROLLER RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| NCP1395BPG | 功能描述:電壓模式 PWM 控制器 PWM CONTROLLER RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。