- 您現在的位置：買賣IC網 > Datasheet目錄55 > OCB350L187Z (TT Electronics/Optek Technology)BOARD CALIBR CIRCUIT OPB350L187 Datasheet資料下載
參數資料
| 型號： | OCB350L187Z |
| 廠商： | TT Electronics/Optek Technology |
| 文件頁數： | 1/8頁 |
| 文件大?。?/td> | 862K |
| 描述： | BOARD CALIBR CIRCUIT OPB350L187 |
| 標準包裝： | 1 |
| 系列： | * |
| 產品目錄頁面： | 2788 (CN2011-ZH PDF) |
| 配用： | 365-1490-ND - BOARD CALIBR CIRCUIT OPB350L062 |
| 其它名稱： | 365-1531 |
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
OPTEK Technology Inc. 1645 Wallace Drive, Carrollton, Texas 75006
Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 sensors@optekinc.com www.optekinc.com
Issue E 11/2011
Page 1 of 8
Tube Liquid Sensor
OPB350 / OCB350 Series
(Calibration Circuit Available)
Features:
" Can identify if liquid is present in clear tubes that have an
outside diameter of 1/16 [1.6mm], 1/8" [3.2mm], 3/16" [4.8 mm]
or 1/4" [6.3 mm]
" Opaque plastic housing enhances ambient light rejection
" Printed circuit board mounting or 24 (610 mm) 26 AWG wires
Description:
The OPB350 series liquid sensor is designed to work with 1/16 [1.6mm] 1/8 [3.2mm], 3/16 [4.8 mm] and
1/4 [6.3 mm] outside diameter clear tubes. When output reference circuitry is added, multiple output states such
as fluid present, no fluid present and no tube present can be recognized.
Clear liquid present causes the phototransistor to sink the maximum current, while dark liquid present causes it to
sink the minimum current. As bubbles pass through the tube, the signal will vary between the liquid present and
no liquid states. If no tube is present, the phototransistor sinks current between the dark fluid and clear Fluid
states. The customer will have to identify the typical current values for each situation. The ratio between the
different states allows acknowledgement of different conditions.
The OPB350L series have leads that are designed to mount directly to PCBoards. The OPB350W series with 26
AWG wires are remote mountable. The OCB350 series provides a full solution with automatic calibration
capability and a preset trip level.
The OCB350 series is configured to optimize the design effort needed to use a fluid sensor with the addition of
self calibration circuitry. The OCB350 series are easy to use requiring only an optical device and power supply.
Four lights are provided on the board that acknowledge when the device is calibrated (Green LED), that the
device could not be calibrated (Red LED) and when the analog output has reached the logical trip higher than the
calibration point (Blue LED) or lower than the calibration point (Green LED). The internal phototransistor load
resistance can be set for three different values (~2.5K, ~9.6K or ~27K Ohms). A Reset/Clear pin is provided for
remote signaling to calibrate of the system.
The OCB350 series comes with an OPB350L_ _ _Z, PCBoard, interface cable (OCB100-MC24) and all the
necessary electronics required for sensing either transmissive or opaque fluids.
See Theory of Operation for detailed information.
For a custom PCBoard design for your unique challenge, contact your OPTEK representative.
Product Photo Here
T
Package
RoHS
Applications:
" Non-contact fluid sensing
" IV fluid
" Oils and other petroleum products
" Colored fluids
" Toner fluids
" Water
N
Package
C
Package
相關PDF資料 |
PDF描述 |
|---|---|
| OMB.242.08F21 | OMNI OUTDOOR ANTENNA |
| OMNILOG90200 | ANTENNA ISOTRP 700MHZ-2.5GHZ RAD |
| OPR5011 | COMPARATOR OPTICAL 3 CHAN SMD |
| P522304 | CELL ANTENNA 5-BAND 35X9X3.2MM |
| P522306 | RF ANT PRESTTA PENTA-BAND U.FL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OCB350L250Z | 功能描述:光學開關（透射型，光電晶體管輸出） Calibration Circuit With OPB350L250 RoHS:否 制造商:Omron Electronics 輸出設備:Phototransistor 槽寬:3.4 mm 光圈寬度:0.5 mm 集電極—發(fā)射極最大電壓 VCEO:30 V 最大集電極電流:20 mA 正向電流: 安裝風格:Through Hole 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 封裝: |
| OCB-375 | 制造商:Heyco Products Inc 功能描述: |
| OCB-500 | 制造商:Heyco Products Inc 功能描述: |
| OCB-562 | 制造商:Heyco Products Inc 功能描述: |
| OCB-625 | 制造商:Heyco Products Inc 功能描述: |
發(fā)布緊急采購，3分鐘左右您將得到回復。