欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: PCD5041H
廠商: NXP SEMICONDUCTORS
元件分類: 無繩電話/電話
英文描述: DECT burst mode controller
中文描述: TELECOM, CORDLESS, BURST MODE CONTROLLER, PQFP64
文件頁數: 15/28頁
文件大小: 134K
代理商: PCD5041H
1996 Oct 31
15
Philips Semiconductors
Objective specification
DECT burst mode controller
PCD5041
The ‘DPLL_sync’ indication should only be used, when
‘SlotSync’ is active. It indicates that the last 4 bits of the
pre-amble field (the training sequence) are received
correctly, and thus indicates that the DPLL was in lock
(synchronized) in time. If the ‘SlotSync’ is active, and the
‘DPLL_sync’ is not, then a sliding interferer might have
been detected.
If ‘SlotSync’ is not detected, effectively no data is received
in that slot. This implies a ‘fast mute’ because speech data
received in the previous frame is not destroyed.
6.5.9
C
IPHERING MACHINE
The description of the cipher machine is subject to
confidentiality. The specification of its algorithms are
delivered by ETSI under the terms of a Non-Disclosure
Agreement.
The cipher machine is under control of the TBC, which is
implemented in the PCC. The cipher machine generates
2 fields of ciphering bits:
A_cipher (40 bits) for A-field messages (ciphers tail
only)
B_cipher (320 bits) for speech in B-field.
The transmitted ciphered bits are then:
A_ciphered: = A XOR A_cipher
B_ciphered: = B XOR B_cipher.
On reception by the peer end point, deciphering consists
of the same operation thanks to the synchronous
generation of A_cipher and B_cipher.
The cipher machine is time-multiplexed on a slot basis.
Initially, the Initialisation Vector (IV) and the key must be
loaded into the cipher machine. Transfer of the IV and key
from the common data area to the cipher machine is done
Fig.11 Cipher machine and its sources.
handbook, halfpage
MBH714
KEY
64 BITS
CIPHER
MACHINE
A_cipher
(40 bits)
B_cipher
(320 bits)
KEY
64 BITS
automatically by the cipher machine. The contents of the
memory space where IV and key are found, are the
responsibility of the PCC, and the external
microprocessor.
6.5.10
C
OMPARATOR
/
DATA SLICER ON
PCD5041HZ
The PCD5041HZ contains a comparator/data slicer.
The comparator is a stand-alone circuit. No connections
other than power supply are made internally. The
comparator can be used as a data slicer for the receiver
input. The delay requirements listed in Chapter 8 were
derived from this application. Another use of the
comparator is in a successive approximation A/D
converter to indicate battery low-voltage condition, or in a
power-on-reset circuit.
When the signal COMP_NE is LOW the comparator is
enabled. When COMP_NE is HIGH the comparator is
disabled, and the circuit consumes no power. If the
comparator is used as a data slicer for the receiver input,
the R_DATA is connected to COMP_OUT, the COMP_NE
is connected to R_ENABLE, both connection are done
externally. The pin COMP_INP is connected to the RF
mixer. A proper bias voltage (from the slicer time constant
control circuit) is connected to COMP_INM. Another use of
the comparator is in a successive approximation A/D
converter for battery voltage detection.
The pins are protected against ESD damaging, with a
protection diode to the positive and negative supply rail.
The input pin COMP_NE has a pull-up resistor which
keeps the comparator in power-down mode by default.
Fig.12 Circuit schematic of the comparator/data
slicer.
handbook, halfpage
MBH715
COMP_INP
COMP_INM
COMP_OUT
COMP_NE
相關PDF資料
PDF描述
PCD5041HZ DECT burst mode controller
PCD5042H DECT burst mode controller
PCD5042HZ DECT burst mode controller
PCD5042 DECT burst mode controller
PCD5043 DECT burst mode controller
相關代理商/技術參數
參數描述
PCD5041HZ 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5042 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5042H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5042HZ 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5043 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
主站蜘蛛池模板: 崇仁县| 新建县| 英山县| 平原县| 张北县| 本溪市| 荃湾区| 静宁县| 丰都县| 常熟市| 家居| 阳朔县| 杭锦旗| 道真| 天台县| 和政县| 宁城县| 横峰县| 始兴县| 基隆市| 阿克苏市| 肃北| 家居| 九龙城区| 建水县| 武定县| 德阳市| 兴仁县| 阆中市| 山阳县| 仁寿县| 恩施市| 绩溪县| 安达市| 南宫市| 华蓥市| 泰来县| 筠连县| 伊宁市| 兴文县| 迁安市|