欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: PCD5041H
廠商: NXP SEMICONDUCTORS
元件分類: 無繩電話/電話
英文描述: DECT burst mode controller
中文描述: TELECOM, CORDLESS, BURST MODE CONTROLLER, PQFP64
文件頁數: 16/28頁
文件大小: 134K
代理商: PCD5041H
1996 Oct 31
16
Philips Semiconductors
Objective specification
DECT burst mode controller
PCD5041
6.6
Microcontroller Interface
6.6.1
F
UNCTION OF THE MICROCONTROLLER INTERFACE
The microcontroller interface will provide the following
services.
Direct interface to processors which have an
INTEL-8051 compatible interface
General interface to processors that can handle ‘wait
states’ e.g. 68000-family; in this case glue logic is
required
Processor clock signal of which the frequency is
programmable in order to adjust instantaneously
processor performance to processor work load
A programmable interrupt register
A watchdog timer with time-out periods of
1.25 or 82 seconds, depending on the programming.
The microcontroller can address the PCD5041 as any
other RAM memory connected to the microcontroller bus.
By writing the ‘Interface-Mode Register’, the
microcontroller can select the interface mode and its own
clock frequency.
6.6.2
M
ICROCONTROLLER INTERRUPTS
The function of microcontroller Interrupts is to make
optimal use of the microcontroller’s processing power, and
to achieve optimal cooperation between time-critical tasks
and less time-critical tasks both executed in software.
Three registers are available to handle interrupts. These
are:
Interrupt Event Register
Interrupt Enable Register
Interrupt Reset Register.
These registers are to be regarded together.
Corresponding bits in these registers relate to one and the
same event. Bits in the Interrupt Event Register are set by
the PCC and are to be reset by the external processor by
writing ‘1’s in the corresponding bits in the Interrupt Reset
Register. The mask in the Interrupt Enable Register
enables the interrupt if corresponding events do occur.
6.6.3
W
ATCHDOG
The PCD5041 is equipped with a watchdog timer, which
generates a reset towards an external device (e.g. a
microcontroller) after time-out. Two (fixed) time-out
periods can be programmed; 1.25 s and 82 s.
The watchdog function can be disabled by using the
EN_WATCHDOG input pin.
6.6.4
P
OWER
-
DOWN
The PCC may switch off the 6.912 MHz internal clock, to
enter a power saving mode. All blocks, running on this
clock are then switched off (i.e. RF-interface, cipher block,
speech interface, PCC). This is called the power-down
state, and is only used in the handset mode.
The 13.824 MHz clock is never switched off. The Timing
Control, microcontroller interface, and Bus Controller keep
running, in order to remain synchronous with a base
station, and to keep the wake-up circuitry active. During
power-down the external microcontroller has still access to
the common data area.
6.7
Survey of registers
For a survey of all addresses occupied refer to
Tables 1 and 2. Some of the address locations are used
differently for read and write. The addresses 000 to 7DF
are occupied by RAM memory, while the upper 32 bytes
are assigned to the hardware registers. A part of the RAM
memory is allocated for use by the RF block, cipher block,
and the speech interface.
相關PDF資料
PDF描述
PCD5041HZ DECT burst mode controller
PCD5042H DECT burst mode controller
PCD5042HZ DECT burst mode controller
PCD5042 DECT burst mode controller
PCD5043 DECT burst mode controller
相關代理商/技術參數
參數描述
PCD5041HZ 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5042 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5042H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5042HZ 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5043 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
主站蜘蛛池模板: 抚州市| 班玛县| 平和县| 饶阳县| 六枝特区| 鄂托克旗| 昔阳县| 拉萨市| 湛江市| 贵定县| 随州市| 灵石县| 郓城县| 收藏| 都昌县| 陆良县| 神木县| 土默特右旗| 嵩明县| 平安县| 灵寿县| 民县| 武陟县| 彭泽县| 福鼎市| 丽水市| 阳信县| 阳高县| 定兴县| 凌源市| 丰台区| 广南县| 南雄市| 上饶县| 扎赉特旗| 固原市| 浏阳市| 临城县| 恩施市| 华阴市| 建平县|