- 您現在的位置：買賣IC網 > PDF目錄361225 > Q67000-A9284-X201-K5 (SIEMENS AG) High Performance Power Combi Controller PDF資料下載
參數資料
| 型號： | Q67000-A9284-X201-K5 |
| 廠商： | SIEMENS AG |
| 英文描述： | High Performance Power Combi Controller |
| 中文描述： | 高性能功率Combi機控制器 |
| 文件頁數： | 8/39頁 |
| 文件大小： | 472K |
| 代理商： | Q67000-A9284-X201-K5 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁
TDA 16888
Semiconductor Group
8
Data Sheet 1998-05-06
PFC Section
At normal operation the PFC section operates with dual loop control. An inner loop,
which includes OP2, C1, FF1 and the PFC’s driver, controls the shape of the line current
by average current control enabling either continuous or discontinuous operation. By the
outer loop, which is supported by OP1, the multiplier, OP2, C1, FF1 and the PFC's driver,
the PFC output voltage is controlled. Furthermore there is a third control loop composed
of OTA1, OP2, C1, FF1 and the PFC’s driver, which allows the PFC section to be
operated as an auxiliary power supply even when the PWM section is disabled. With
disabled PWM section, however, the PFC section is operated with half of its nominal
operating frequency in order to reduce the overall current consumption.
Based on a pulse-width-modulation, which is leading edge triggered with respect to the
internal clock reference CLK OUT and which is trailing edge modulated according to the
PFC ramp signal
V
PFC RMP
and the output voltage of OP2
V
PFC CC
(see
Figure 18
), the
PFC section is designed for a maximum duty cycle of ca. 94% to achieve minimal line
current gaps.
PWM Section
The PWM section is equipped with improved current mode control containing effective
slope compensation as well as enhanced spike suppression in contrast to the commonly
used leading edge current blanking. This is achieved by the chain of operational amplifier
OP3, voltage source
V
1
and the 1st order low pass filter composed of
R
1
and an external
capacitor, which is connected to pin 15 (PWM RMP). For crosstalk suppression between
PFC and PWM section a signal-to-noise ratio comparable to voltage mode controlled
PWM’s is set by operational amplifier OP3 performing a fivefold amplification of the PWM
load current, which is sensed by an external shunt resistor. In order to simultaneously
perform effective slope compensation and to suppress leading spikes, which are due to
parasitic capacitances being discharged whenever the power transistor is switched on,
the resulting signal is subsequently increased by the constant voltage of
V
1
and finally
fed into the 1st order low pass filter. The peak ramp voltage, that in this way can be
reached, amounts to ca. 6.5 V. By combination of voltage source
V
1
and the following
low pass filter a basic ramp (step response) with a leading notch is created, which will
fully compensate a leading spike (see
Figure 12
) provided, the external capacitor at
pin 15 (PWM RMP) and the external current sensing shunt resistor are scaled properly.
相關PDF資料 |
PDF描述 |
|---|---|
| Q67001-A5214 | Components for Entertainment Electronics, Satellite Sound IF |
| Q67003H9339 | ICs for Communications |
| Q67006-A9171 | Dynamic Differential Hall Effect Sensor IC |
| Q67006-A9515 | Step Down Voltage-Regulator with Reset |
| Q67006-A9286 | 5-V Voltage Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| Q67000-A9295 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:5-A DC Motor Driver with Inhibit |
| Q67000-A9303 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:1-A DC Motor Driver for Servo Driver Applications |
| Q67000-A9310-A702 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:High Performance Power Combi Controller |
| Q67000-A9324 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:5-A H-Bridge for DC-Motor Applications |
| Q67000-A940 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:LED Driver for Light Spot Displays |
發布緊急采購，3分鐘左右您將得到回復。