欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: Q67100-H6209
廠商: SIEMENS AG
英文描述: Multipoint Switching and Conferencing Unit - Attenuation MUSAC
中文描述: 多點交換和會議股-衰減MUSAC
文件頁數: 13/53頁
文件大小: 418K
代理商: Q67100-H6209
HYB 39S64400/800/160BT(L)
64-MBit Synchronous DRAM
Data Book
13
12.99
command is necessary. A minimum
t
RC
time is required between two automatic refreshes in a burst
refresh mode. The same rule applies to any access command after the automatic refresh operation.
The chip has an on-chip timer and the Self Refresh mode is available. It enters the mode when RAS,
CAS, and CKE are low and WE is high at a clock timing. All of external control signals including the
clock are disabled. Returning CKE to high enables the clock and initiates the refresh exit operation.
After the exit command, at least one
t
RC
delay is required prior to any access command.
DQM Function
DQM has two functions for data I/O read and write operations. During reads, when it turns to “high”
at a clock timing, data outputs are disabled and become high impedance after two clock delay (DQM
Data Disable Latency
t
DQZ
). It also provides a data mask function for writes. When DQM is activated,
the write operation at the next clock is prohibited (DQM Write Mask Latency
t
DQW
= zero clocks).
Suspend Mode
During normal access mode, CKE is held high enabling the clock. When CKE is low, it freezes the
internal clock and extends data read and write operations. One clock delay is required for mode
entry and exit (Clock Suspend Latency
t
CSL
).
Power Down
In order to reduce standby power consumption, a power down mode is available. All banks must be
precharged and the necessary Precharge delay (
t
RP
) must occur before the SDRAM can enter the
Power Down mode. Once the Power Down mode is initiated by holding CKE low, all of the receiver
circuits except CLK and CKE are gated off. The Power Down mode does not perform any refresh
operations, therefore the device can’t remain in Power Down mode longer than the Refresh period
(
t
REF
) of the device. Exit from this mode is performed by taking CKE “high”. One clock delay is
required for mode entry and exit.
Auto Precharge
Two methods are available to precharge SDRAMs. In an automatic precharge mode, the CAS
timing accepts one extra address, CA10, to determine whether the chip restores or not after the
operation. If CA10 is high when a Read Command is issued, the
Read with Auto-Precharge
function is initiated. If CA10 is high when a Write Command is issued, the
Write with Auto-
Precharge
function is initiated. The SDRAM automatically enters the precharge operation two
clocks after the last data in.
Precharge Command
There is also a separate precharge command available. When RAS and WE are low and CAS is
high at a clock timing, it triggers the precharge operation. Three address bits, BA0, BA1 and A10 are
used to define banks as shown in the following list. The precharge command can be imposed one
clock before the last data out for CAS latency = 2 and two clocks before the last data out for CAS
latency = 3. Writes require a time delay
t
WR
from the last data out to apply the precharge command.
相關PDF資料
PDF描述
Q67100-H6238 Memory Time Switch Large MTSL
Q67100-H6278 ISDN Remote Power Controller
Q67100-H6298 Multipoint Switching and Conferencing Unit - Attenuation MUSAC-A
Q67100-H6422 Octal Transceiver for UPN Interfaces OCTAT-P
Q67100-H6423 PLL-Frequency Synthesizer PMB2306R/PMB2306T Version 2.2
相關代理商/技術參數
參數描述
Q67100-H6216 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:ICs for Communications
Q67100-H6222 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:ICs for Communications
Q67100-H6238 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Memory Time Switch Large MTSL
Q67100-H6278 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:ISDN Remote Power Controller
Q67100-H6298 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Multipoint Switching and Conferencing Unit - Attenuation MUSAC-A
主站蜘蛛池模板: 万年县| 自治县| 炎陵县| 太仓市| 万年县| 启东市| 大厂| 涪陵区| 交城县| 贡觉县| 兴义市| 长顺县| 临朐县| 怀来县| 鲁山县| 台东县| 陆丰市| 阿荣旗| 鲁甸县| 辛集市| 天台县| 保靖县| 广河县| 东光县| 平定县| 平湖市| 马鞍山市| 平邑县| 卫辉市| 邯郸市| 拉萨市| 大竹县| 太康县| 通海县| 方城县| 紫阳县| 禹州市| 双柏县| 寻乌县| 报价| 浠水县|