欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: Q67126-C2088
英文描述: RF inductor, ceramic core, 2% tol, SMT, RoHS
中文描述: 集成電路釤CAN控制器
文件頁數: 91/121頁
文件大小: 1000K
代理商: Q67126-C2088
Power Saving Modes
C501
Semiconductor Group
8-2
8.2
Idle Mode
In the idle mode the oscillator of the C501 continues to run, but the CPU is gated off from the clock
signal. However, the interrupt system, the serial port, and all timers are further provided with the
clock. The CPU status is preserved in its entirety: the stack pointer, program counter, program
status word, accumulator, and all other registers maintain their data during idle mode.
The reduction of power consumption, which can be achieved by this feature depends on the number
of peripherals running. If all timers are stopped and the serial interfaces are not running, the
maximum power reduction can be achieved. This state is also the test condition for the idle mode
I
CC
.
So, the user has to take care which peripheral should continue to run and which has to be stopped
during idle mode. Also the state of all port pins – either the pins controlled by their latches or
controlled by their secondary functions – depends on the status of the controller when entering idle
mode.
Normally, the port pins hold the logical state they had at the time when the idle mode was activated.
If some pins are programmed to serve as alternate functions they still continue to output during idle
mode if the assigned function is on. This applies to the serial interface in case it cannot finish
reception or transmission during normal operation. The control signals ALE and PSEN are hold at
logic high levels.
As in normal operation mode, the ports can be used as inputs during idle mode. Thus a capture or
reload operation can be triggered, the timers can be used to count external events, and external
interrupts will be detected.
The idle mode is a useful feature which makes it possible to "freeze" the processor's status - either
for a predefined time, or until an external event reverts the controller to normal operation, as
discussed below. The watchdog timer is the only peripheral which is automatically stopped during
idle mode.
The idle mode is entered by setting the flag bit IDLE (PCON.0).
Note:
PCON is not a bit-addressable register, so the above mentioned sequence for entering the idle
mode is obtained by byte-handling instructions,
as shown in the following example:
ORL
PCON,#00000001B
;Set bit IDLE
The instruction that sets bit IDLE is the last instruction executed before going into idle mode.
There are two ways to terminate the idle mode:
– The idle mode can be terminated by activating any enabled interrupt. This interrupt will be
serviced and normally the instruction to be executed following the RETI instruction will be the
one following the instruction that sets the bit IDLE.
– The other way to terminate the idle mode, is a hardware reset. Since the oscillator is still
running, the hardware reset must be held active only for two machine cycles for a complete
reset.
相關PDF資料
PDF描述
Q67127-C2036SAB-C161R1-L16M IC-SM-16 BIT CPU
Q67120-C2200 16-Bit Single-Chip Microcontroller Bare Die Delivery
Q67120-C1054 High Speed CMOS Logic Triple 3-Input NOR Gates 14-SOIC -55 to 125
Q67120-C1056 High Speed CMOS Logic Triple 3-Input NOR Gates 14-SOIC -55 to 125
Q67120-C2002 High Speed CMOS Logic Octal D-Type Flip-Flops with Reset 20-SOIC -55 to 125
相關代理商/技術參數
參數描述
Q67127-C1009 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
Q67127-C1014 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
Q67127-C1030 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
Q67127-C1031 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
Q67127-C1032 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
主站蜘蛛池模板: 松溪县| 萍乡市| 将乐县| 郓城县| 洛隆县| 灌阳县| 双桥区| 新蔡县| 遂宁市| 上犹县| 舟曲县| 洱源县| 文成县| 莎车县| 遂宁市| 临城县| 台前县| 行唐县| 古田县| 梁平县| 镶黄旗| 淮滨县| 习水县| 额济纳旗| 陇川县| 左权县| 临西县| 铁岭县| 高密市| 莱西市| 古田县| 岱山县| 克东县| 当涂县| 开原市| 福贡县| 武义县| 梁河县| 乌海市| 宜君县| 灵宝市|