- 您現在的位置：買賣IC網 > PDF目錄376314 > RS-422 (Electronic Theatre Controls, Inc.) RS-422 AND RS-485 APPLICATION NOTE PDF資料下載
參數資料
| 型號： | RS-422 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | RS-422 AND RS-485 APPLICATION NOTE |
| 中文描述： | RS - 422和RS - 485接口應用筆記 |
| 文件頁數： | 26/44頁 |
| 文件大小： | 628K |
| 代理商： | RS-422 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁
RS-422/485 Application Note
23
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 434-7094
Chapter 4: Transient Protection of RS-422 and RS-485
Systems
The first step towards protecting an RS-422 or RS-485 system from
transients is understanding the nature of the energy we are guarding against.
Transient energy may come from several sources, most typically environmental
conditions or induced by switching heavy inductive loads.
What does a surge look like
Surge Specifications
While transients may not always conform to industry specifications, both
the Institute of Electrical and Electronics Engineers (IEEE) and the
International Electrotechnical Commission (IEC) have developed transient
models for use in evaluating electrical and electronic equipment for immunity
to surges. These models can offer some insight into the types of energy that
must be controlled to prevent system damage.
Both IEC 1000-4-5: 1995 “Surge Immunity Test” and IEEE C62.41-1991
“IEEE Recommended Practice on Surge Voltages in Low-Voltage AC Power
Circuits” define a “1.2/50
μ
s - 8/20
μ
s combination wave” surge which has a 1.2
μ
s voltage rise time with a 50
μ
s decay across an open circuit. The specified
current waveform has an 8
μ
s rise time with a 20
μ
s decay into a short circuit.
Open circuit voltages levels from 1 to 6 kV are commonly used in both the
positive and negative polarities, although under some circumstances voltages as
high as 20 kV may be applied. Figures 4.1 and 4.2 illustrate the combination
wave characteristics. In addition, IEEE C62.41 also specifies a 100 kHz “ring
wave” test. The ring wave has a 0.5
μ
s rise time and a decaying oscillation at
100 kHz with source impedance of 12
as shown in Figure 4.3. Typical
amplitudes for the 100 kHz ring wave also range from 1 – 6 kV.
相關PDF資料 |
PDF描述 |
|---|---|
| RS-485 | RS-422 AND RS-485 APPLICATION NOTE |
| RS-MK-X2010 | High Integrity FM Transceiver |
| RS3FS | SDR Cable Assembly; Connector Type A:micro D Ribbon Plug; Connector Type B:micro D Ribbon Plug; Cable Length:2m; No. of Contacts:26; Pitch Spacing:0.8mm RoHS Compliant: Yes |
| RS3FS | Damper Diodes (For TV) |
| RS4FS | SDR Cable Assembly; Connector Type A:micro D Ribbon Plug; Connector Type B:micro D Ribbon Plug; Cable Length:5m; No. of Contacts:26; Pitch Spacing:0.8mm RoHS Compliant: Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RS422-GE1 | 制造商:Carlo Gavazzi 功能描述:CABLE FOR GE90 |
| RS422-MI1 | 制造商:Carlo Gavazzi 功能描述:CABLE FOR MITS MASTER |
| RS422-MI2 | 制造商:Carlo Gavazzi 功能描述:CABLE FOR MITS MASTER |
| RS422-MI3 | 制造商:Carlo Gavazzi 功能描述:CABLE FOR MITS MASTER |
| RS422-OM2 | 制造商:Carlo Gavazzi 功能描述:CABLE FOR OMRON MASTER |
發布緊急采購，3分鐘左右您將得到回復。