
1
S3028
S3028
SONET/SDH/ATM OC-3/OC-12 TRANSCEIVER
December 13, 1999 / Revision H
DEVICE
SPECIFICATION
FEATURES
Complies with Bellcore and ITU-T
specifications
Jitter generation better than ITU-T requirements
On-chip high-frequency PLL for clock
generation
Supports 155.52 Mbps (OC-3) and
622.08 Mbps (OC-12)
Selectable reference frequencies of 19.44,
38.88, 51.84, or 77.76 MHz
Interface to both PECL and TTL logic
4-bit or 8-bit OC-3 TTL datapath
8-bit OC-12 TTL datapath
Compact 64 PQFP package
Diagnostic loopback mode
Line loopback mode
Lock detect
LOS input
Low jitter PECL interface
0.9W typical power dissipation
Loop Timing (S3028B only)
Forward Clocking (S3028B only)
"Squelched Clock" operation (S3028B only)
5 V Power supply
APPLICATIONS
SONET/SDH-based transmission systems
SONET/SDH modules
SONET/SDH test equipment
ATM over SONET/SDH
Section repeaters
Add Drop Multiplexers (ADM)
Broad-band cross-connects
Fiber optic terminators
Fiber optic test equipment
Figure 1. System Block Diagram
GENERAL DESCRIPTION
The S3028 SONET/SDH transceiver chip is a fully
integrated serialization/deserialization SONET
OC-12 (622.08 Mbit/s) and OC-3 (155.52 Mbit/s) in-
terface device. The chip performs all necessary
serial-to-parallel and parallel-to-serial functions in
conformance with SONET/SDH transmission stan-
dards. The device is suitable for SONET-based ATM
applications and can be used in conjunction with
AMCC’s S3026 Clock Recovery Unit (CRU). Figure
1 shows a typical network application.
On-chip clock synthesis is performed by the high-
frequency phase-locked loop on the S3028
transceiver chip allowing the use of a slower external
transmit clock reference. The S3028 also performs
SONET/SDH frame detection. The chip can be used
with a 19.44, 38.88, 51.84 or 77.76 MHz reference
clock, in support of existing system clocking
schemes.
The low jitter PECL interface guarantees compliance
with the bit-error rate requirements of the Bellcore
and ITU-T standards. The S3028 is packaged in a
64 PQFP, offering designers a small package out-
line.
Since the S3028 jitter generation is better than the
ITU-T requirements over all reference frequencies,
the designer can meet the overall system require-
ment including the optical interface devices (refer to
Table 9 for jitter generation specifications).
Transceiver
S3028
Controller
Controller
Transceiver
S3028
8
8
8
8
Fiber
Optic
Module
Fiber
Optic
Module
S3026
S3026
Now available with
Loop Timing!