- 您現在的位置：買賣IC網 > Datasheet目錄57 > SI4713-B30-GMR (Silicon Laboratories Inc)IC TX FM RADIO RPS/RDS 20UQFN Datasheet資料下載
參數資料
| 型號： | SI4713-B30-GMR |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 22/42頁 |
| 文件大小： | 430K |
| 描述： | IC TX FM RADIO RPS/RDS 20UQFN |
| 標準包裝： | 2,500 |
| 頻率： | 76MHz ~ 108MHz |
| 應用： | 通用 |
| 調制或協議： | FM |
| 電流 - 傳輸： | 18.8mA |
| 數據接口： | PCB，表面貼裝 |
| 天線連接器： | PCB，表面貼裝 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 封裝/外殼： | 20-UFQFN 裸露焊盤 |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
Si4712/13-B30
22
Rev. 1.1
5.3.1. Stereo Encoder
Figure 14 shows an example modulation level
breakdown for the various components of a typical MPX
signal.
The total modulation level for the MPX signal shown in
Figure 14, assuming no correlation, is equal to the
arithmetic sum of each of the subchannel levels
resulting in 102.67 percent modulation or a peak
frequency deviation of 77.0025 kHz (an instantaneous
frequency deviation of 75 kHz corresponds to 100
percent modulation). Frequency deviation is related to
the amplitude of the MPX signal by a gain constant,
K
VCO
, as given by the following equation:
where 攆 is the frequency deviation; K
VCO
is the
voltage-to-frequency gain constant, and A
m
is the
amplitude of the MPX message signal. For a fixed
K
VCO
, the amplitude of all the subchannel signals within
the MPX message signal must be scaled to give the
appropriate total frequency deviation.
Figure 14. MPX Encoder
Figure 14 shows a conceptual block diagram of an MPX
encoder used to generate the MPX signal. L(t) and R(t)
denote the time domain waveforms from the left and
right audio channels, and RDS(t) denotes the time
domain waveform of the RDS/RBDS signal.
The MPX message signal can be expressed as follows:
m(t) = C
0
[L(t) + R(t)] + C
1
cos(2?/SPAN>19 kHz)
+ C
0
[L(t) R(t)] cos(2?/SPAN>38 kHz)
+ C
2
RDS(t) cos(2?/SPAN>57 kHz)
where C
0
, C
1
, and C
2
are gains used to scale the
amplitudes of the audio signals (L(t) ?R(t)), the 19 kHz
pilot tone, and the RDS subcarrier respectively, to
generate the appropriate modulation level. To achieve
the modulation levels of Figure 14 with
K
VCO
= 75 kHz/V, C
0
would be set to 0.45; C
1
would be
set to 0.1, and C
2
would be set to 0.0267 giving a peak
audio frequency deviation of 0.9 x 75 kHz = 67.5 kHz, a
peak
pilot
frequency
deviation
of
0.1 x 75 kHz = 7.5 kHz, and a peak RDS frequency
deviation of 0.0267 x 75 kHz = 2.0025 kHz for a total
peak frequency deviation of 77.0025 kHz.
In the Si4712/13, the peak audio, pilot, and RDS
frequency deviations can be programmed directly with
the Transmit Audio, Pilot, and RDS Deviation
commands with an accuracy of 10 Hz. For the example
in Figure 14, the Transmit Audio Deviation is
programmed with the value 6750, the Transmit Pilot
Deviation with 750, and the Transmit RDS Deviation
with 200, generating peak audio frequency deviations of
67.5 kHz, peak pilot deviations of 7.5 kHz, and peak
RDS deviations of 2.0 kHz for a total peak frequency
deviation of 77 kHz. The total peak transmit frequency
deviation of the Si4712/13 can range from 0 to 100 kHz
and is equal to the arithmetic sum of the Transmit
Audio, Pilot, and RDS deviations. Users must comply
with local regulations on radio frequency transmissions.
Each of the individual deviations (transmit audio, pilot,
and RDS) can be independently programmed; however,
the total peak frequency deviation cannot exceed
100 kHz.
The Si4712/13 provides an overmodulation indicator to
allow the user to dynamically set the maximum
deviation level. If the instantaneous frequency exceeds
the
deviation
level
specified
by
the
TX_AUDIO_DEVIATION property, the SQINT interrupt
bit (and optional interrupt) will be set.
攆
K
VCO
A
m
=
57 kHz
MPX Encoder
C2
m(t)
RDS(t)
Frequency
Doubler
Frequency
Tripler
L(t)
R(t)
C1
38 kHz
19 kHz
C0
C0
相關PDF資料 |
PDF描述 |
|---|---|
| SKY12146-321LF | IC VAR VOLT ATTEN 12QFN |
| SN171GG-NR | SNAP PROTOBOARD W/NO RADIO |
| SWLP.2450.12.4.B.02 | ANTENNA WI-FI WLAN 2.4GHZ |
| TD4A | SENSOR RTD LIQUID TEMP 2TERM |
| TD5A | SENSOR RTD TEMP MINI 3LEAD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI4713-B-EVB | 功能描述:射頻開發工具 SI4713 EVAL BOARD REV B RoHS:否 制造商:Taiyo Yuden 產品:Wireless Modules 類型:Wireless Audio 工具用于評估:WYSAAVDX7 頻率: 工作電源電壓:3.4 V to 5.5 V |
| SI4714DY | 制造商:VISHAY 制造商全稱:Vishay Siliconix 功能描述:N-Channel 30 V (D-S) MOSFET with Schottky Diode |
| Si4714DY-T1-GE3 | 功能描述:MOSFET 30 Volts 13.6 Amps 4.5 Watts RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS（導通）:0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube |
| SI4719CY | 功能描述:電源開關 IC - 配電 P-Ch Battery Switch RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| SI4719CY-E3 | 功能描述:電源開關 IC - 配電 P-Ch Battery Switch RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
發布緊急采購，3分鐘左右您將得到回復。