- 您現在的位置：買賣IC網 > PDF目錄98227 > THS4601CDG4 (TEXAS INSTRUMENTS INC) 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 PDF資料下載
參數資料
| 型號： | THS4601CDG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
| 封裝： | GREEN, PLASTIC, MS-012AA, SOIC-8 |
| 文件頁數： | 11/34頁 |
| 文件大小： | 826K |
| 代理商： | THS4601CDG4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
THS4601
SLOS388B OCTOBER 2001 REVISED JUNE 2002
19
www.ti.com
APPLICATION INFORMATION
selection of feedback resistors
Feedback resistor selection can have a significant effect on the performance of the THS4601 in a given
application, especially in configurations with low closed-loop gain. If the amplifier is configured for unity gain,
the output should be directly connected to the inverting input. Any resistance between these two points interacts
with the input capacitance of the amplifier and causes an additional pole in the frequency response. For
non-unity gain configurations, low resistances are desirable for flat frequency response. However, care must
be taken not to load the amplifier too heavily with the feedback network if large output signals are expected. In
most cases, a tradeoff will be made between the frequency response characteristics and the loading of the
amplifier. For a gain of 2, a 250
feedback resistor is a suitable operating point from both perspectives.
If resistor values are chosen too large, the THS4601 is subject to oscillation problems. For example, an inverting
amplifier configuration with a 1-k
gain resistor and a 1-k feedback resistor develops an oscillation due to the
interaction of the large resistors with the input capacitance. In low gain configurations, avoid feedback resistors
this large or anticipate using an external compensation scheme to stabilize the circuit.
overdrive recovery
The THS4601 has an overdrive recovery period when the output is driven close to one power supply rail or the
other. The overdrive recovery time period is dependent upon the magnitude of the overdrive and whether the
output is driven towards the positive or the negative power supply. The four graphs shown here depict the
overdrive recovery time in two cases, an attempted 28 VPP signal on the output and an attempted 30 VPP signal
on the output. Note that in both of these cases, the output does not achieve these levels as the output voltage
swing is limited to less than these values, but these values are representative of the desired signal swing on
the output for the given inputs. As shown in the figures, the recovery period increases as the magnitude of the
overdrive increases, with the worst case recovery occurring with the negative rail. The recovery times are
summarized in Table 2.
Table 2. Overdrive Recovery Characteristics
VOLTAGE RAIL
IDEAL OUTPUT SWING
(VPP)
OVERDRIVE RECOVERY TIME
(ns)
+VS
28
320
VS
28
340
+VS
30
540
VS
30
680
相關PDF資料 |
PDF描述 |
|---|---|
| THS4601IDDAG3 | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
| THS4601IDDARG3 | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
| THS4601IDG4 | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
| THS4601CDDAR | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
| THS4601CDDA | 1 CHANNEL, VIDEO AMPLIFIER, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS4601EVM | 功能描述:放大器 IC 開發工具 THS4601 Eval Mod RoHS:否 制造商:International Rectifier 產品:Demonstration Boards 類型:Power Amplifiers 工具用于評估:IR4302 工作電源電壓:13 V to 23 V |
| THS4601ID | 功能描述:高速運算放大器 Wideband FET-Input Op Amp RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| THS4601IDDA | 功能描述:高速運算放大器 Wideband FET In RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| THS4601IDDAG3 | 功能描述:高速運算放大器 Wideband FET-Input Op Amp RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| THS4601IDDAR | 功能描述:高速運算放大器 Wideband FET-Input Op Amp RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。