- 您現在的位置：買賣IC網 > PDF目錄98246 > TLE5250 (INFINEON TECHNOLOGIES AG) STEPPER MOTOR CONTROLLER, 3 A, PZFM15 PDF資料下載
參數資料
| 型號： | TLE5250 |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 運動控制電子 |
| 英文描述： | STEPPER MOTOR CONTROLLER, 3 A, PZFM15 |
| 封裝： | PLASTIC, SIP-15 |
| 文件頁數： | 21/22頁 |
| 文件大小： | 142K |
| 代理商： | TLE5250 |
TLE 5250
Semiconductor Group
8
1998-02-01
Bits 10, 11
With these bits it is possible to detect the status of the gate voltages of the lower output-
stage transistors T3 and T4. Bit 10: status for EN edge transition. Bit 11: whether the
lower transistor has at all been turned on.
Bit 12 indicates whether the nominal/actual comparator has switched. The comparator
switches when the output current is regulated.
Bits 13, 14, 15
These bits indicate the presence of overcurrent, undervoltage or overtemperature. A
fault is ORed and output direct by bit 0 on DI.
When the multiplexer is read out, bits 0 through 15 are output once non-inverted (Phase
= Low) and once inverted (Phase = High).
Bit Assignment in Error Register
Bit 0
=
High for overtemperature/undervoltage/overcurrent
Bit 1
=
always High
Bit 2
=
High when sink transistor Q1 turned on
Bit 3
=
High when sink transistor Q2 turned on
Bit 4
=
High when source transistor Q1 turned on
Bit 5
=
High when source transistor Q2 turned on
Bits 2-5 =
momentary states for readout
Bit 6
=
bit 2 state for falling edge of Enable signal
Bit 7
=
bit 3 state for falling edge of Enable signal
Bit 8
=
bit 4 state for falling edge of Enable signal
Bit 9
=
bit 5 state for falling edge of Enable signal
Bits 6-10
represent status of outputs for negative change in edge of Enable signal
Bit 11
=
High if gate-source voltage of sink transistors is > 5 V at moment of readout
Bits 11-15
are set if event occurs during switching (Enable = High)
Bit 11
=
High if sink transistor V
GS > 5 V
Bit 12
=
High if actual current lower than nominal current
Bit 13
=
High if overcurrent detected on source transistors
Bit 14
=
High if undervoltage detected
Bit 15
=
High if thermal link tripped
The memories are erased by a rising edge on the Enable input.
相關PDF資料 |
PDF描述 |
|---|---|
| TLE6208-3G | BRUSH DC MOTOR CONTROLLER, 1.2 A, PDSO14 |
| TLE6208-6G | BRUSH DC MOTOR CONTROLLER, 2 A, PDSO28 |
| TLE6210G | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO20 |
| TLE6266G | SPECIALTY ANALOG CIRCUIT, PDSO28 |
| TLE6280GP | BRUSHLESS DC MOTOR CONTROLLER, PDSO36 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE6208-3G | 功能描述:馬達/運動/點火控制器和驅動器 Triple-Half-Bridge RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| TLE6208-3-G | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Triple-Half-Bridge |
| TLE6208-3G_07 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Triple Half Bridges Optimized for DC motor management applications |
| TLE62083GXUMA1 | 制造商:Infineon Technologies AG 功能描述:Triple Half Bridge Motor Driver 14-Pin DSO 制造商:Infineon Technologies AG 功能描述:BODY BRIDGES - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC MOTOR DRIVER SPI 14DSO |
| TLE6208-6 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Hex-Half-Bridge / Double Six-Driver |
發布緊急采購，3分鐘左右您將得到回復。