- 您現在的位置：買賣IC網 > PDF目錄98263 > TLV990APFB (TEXAS INSTRUMENTS INC) SPECIALTY CONSUMER CIRCUIT, PQFP48 PDF資料下載
參數資料
| 型號： | TLV990APFB |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP48 |
| 封裝： | PLASTIC, TQFP-48 |
| 文件頁數： | 9/24頁 |
| 文件大小： | 328K |
| 代理商： | TLV990APFB |
TLV990A
3-V, 10-BIT, 28-MSPS AREA CCD AND VIDEO SIGNAL PROCESSOR
SLAS297 – SEPTEMBER 2000
17
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLES OF OPERATION
ADC
The ADC employs a pipelined architecture to achieve high throughput and low power consumption. Fully-
differential implementation and digital-error correction ensure 10-bit resolution.
The latency of the ADC data output is 6 ADCCLK cycles, as shown in Figure 1. Pulling the OE pin (pin 24) high
puts the ADC output in high impedance.
user DACs
The TLV990A includes two user DACs that can be used for external analog settings. The output voltage of each
DAC can be independently set and has a range of 0 V up to the supply voltage, with an 8-bit resolution. When
the user DACs are not used in a camera system, they can be put in the standby mode by programming control
bits in the control register.
internal timing
The SR and SV signals are required to operate the CDS, as previously explained. The user needs to
synchronize the SR and SV clocks with the CCD signal waveform. The output of the ADC is read out to external
circuitry by the ADCCLK signal, which is also used internally to control both ADC and PGA operations. It is
required that the positive half cycle of the ADCCLK signal always falls in between two adjacent SV pulses as
shown in Fig. 1. The user can then fine tune the ADCCLK timing in relation to the CDS timing to achieve optimal
performance.
The CLCCD signal is used to activate the input clamping and the OBCLP signal is used to activate auto-optical
black and offset correction.
input blanking function
Large input transients may occur at the TLV990A’s input during some period of operation which can saturate
the input circuits and cause long recovery time. To prevent circuit saturation the TLV990A includes an input
blanking function that blocks the input signals by disabling the CDS operation whenever the BLKG input is pulled
low. The TLV990A digital output will be set by the blanking data register after BLKG is pulled low.
NOTE:
If the BLKG pulse is located before the OBCLP pulse, there must be at least 4 pixels between the
rising edge of the BLKG pulse and the falling edge of the OBCLP pulse. If the BLKG pulse is located
after the OBCLP, the minimum number of pixels between the falling edge of the OBCLP and the
falling edge of the BLKG pulse should be equal to the number of optical black pixels per line + 4.
3-wire serial interface
A simple 3-wire (SCLK, SDIN, and CS) serial interface is provided to allow writing to the TLV990A internal
registers. Serial clock SCLK can be run at a maximum frequency of 40 MHz. Serial data SDIN is 16 bits long.
The two leading null bits are followed by four address bits for which the internal register is to be updated, and
then ten bits of data to be written to the register. The CS pin must be held low to enable the serial port. Data
transfer is initiated by the incoming SCLK after CS falls.
The SCLK polarity is selectable by pulling the SCKP pin either high or low.
相關PDF資料 |
PDF描述 |
|---|---|
| TLV990BPFB | SPECIALTY CONSUMER CIRCUIT, PQFP48 |
| TM21R-5A-3232-LP(50) | 32 CONTACT(S), FEMALE, RIGHT ANGLE TELECOM AND DATACOM CONNECTOR, SOLDER, JACK |
| TM21R-5B-3232D-LP(50) | 32 CONTACT(S), FEMALE, RIGHT ANGLE TELECOM AND DATACOM CONNECTOR, SOLDER, JACK |
| TM21R-5B-4848D-LP(50) | 48 CONTACT(S), FEMALE, RIGHT ANGLE TELECOM AND DATACOM CONNECTOR, SOLDER, JACK |
| TM21R-5C-88(50) | 8 CONTACT(S), FEMALE, RIGHT ANGLE TELECOM AND DATACOM CONNECTOR, SOLDER, JACK |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLV990B | 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-V, 10-BIT, 28-MSPS AREA CCD AND VIDEO SIGNAL PROCESSOR |
| TLV990BPFB | 功能描述:IC CCD SIGNAL PROC/DGTZR 48TQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模擬前端 (AFE) 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:- 通道數:2 功率（瓦特）:- 電壓 - 電源，模擬:3 V ~ 3.6 V 電壓 - 電源，數字:3 V ~ 3.6 V 封裝/外殼:32-VFQFN 裸露焊盤 供應商設備封裝:32-QFN（5x5） 包裝:帶卷 (TR) |
| TLV990PFB | 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-V, 10-BIT, 28-MSPS AREA CCD AND VIDEO SIGNAL PROCESSOR |
| TLVAIC12KIRHBRG4 | 功能描述:接口—CODEC Lo-Pwr Mono Voice Band CODEC RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| TLVAIC12KIRHBTG4 | 功能描述:接口—CODEC Lo-Pwr Mono Voice Band CODEC RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。