- 您現在的位置：買賣IC網 > PDF目錄382673 > TPA032D02DCAR Dual Audio Amplifier PDF資料下載
參數資料
| 型號： | TPA032D02DCAR |
| 元件分類： | 運動控制電子 |
| 英文描述： | Dual Audio Amplifier |
| 中文描述： | 雙音頻放大器 |
| 文件頁數： | 20/31頁 |
| 文件大小： | 445K |
| 代理商： | TPA032D02DCAR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
TPA0312
2-W STEREO AUDIO POWER AMPLIFIER
WITH FOUR SELECTABLE GAIN SETTINGS AND MUX CONTROL
SLOS335 –DECEMBER 2000
20
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
The –3 dB frequency can be calculated using equation 1:
(1)
–3 dB
1
2 C R RI
If the filter must be more accurate, the value of the capacitor should be increased while the value of the resistor
to ground should be decreased. In addition, the order of the filter could be increased.
input capacitor, C
I
In the typical application an input capacitor, C
I
, is required to allow the amplifier to bias the input signal to the
proper dc level for optimum operation. In this case, C
I
and the input impedance of the amplifier, Z
I
, form a
high-pass filter with the corner frequency determined in equation 2.
f
c(highpass)
1
2 Z
I
C
I
–3 dB
fc
(2)
The value of C
I
is important to consider as it directly affects the bass (low frequency) performance of the circuit.
Consider the example where Z
I
is 710 k
and the specification calls for a flat bass response down to 40 Hz.
Equation 2 is reconfigured as equation 3.
CI
1
2 ZIfc
(3)
In this example, C
I
is 5.6 nF so one would likely choose a value in the range of 5.6 nF to 1
μ
F. A further
consideration for this capacitor is the leakage path from the input source through the input network (C
I
) and the
feedback network to the load. This leakage current creates a dc offset voltage at the input to the amplifier that
reduces useful headroom, especially in high gain applications. For this reason a low-leakage tantalum or
ceramic capacitor is the best choice. When polarized capacitors are used, the positive side of the capacitor
should face the amplifier input in most applications as the dc level there is held at V
DD
/2, which is likely higher
than the source dc level. Note that it is important to confirm the capacitor polarity in the application.
相關PDF資料 |
PDF描述 |
|---|---|
| TPA100RL | SINGLE BIDIRECTIONAL BREAKOVER DIODE|133V V(BO) MAX|800MA I(S)|DO-204AC |
| TPA120RL | DIP Switch; No. of Switch Positions:6; Circuitry:SPST; Contact Current Max:25mA; Switch Terminals:SMT Gull Wing; Overall Length:8.75mm; Pitch Spacing:1.28mm; Series:TDA; Actuator Style:Flush Slide RoHS Compliant: Yes |
| TPA130RL | SINGLE BIDIRECTIONAL BREAKOVER DIODE|173V V(BO) MAX|800MA I(S)|DO-204AC |
| TPA180RL | SINGLE BIDIRECTIONAL BREAKOVER DIODE|240V V(BO) MAX|800MA I(S)|DO-204AC |
| TPA200RL | Pushbutton Switch; Actuator Diameter:0.1"; Circuitry:SPST; Switch Operation:(On)-Off; Contact Rating:0.4VA at 20VAC/VDC; Features:Plunger Actuator; Leaded Process Compatible:Yes; Mounting Type:PCB; Peak Reflow Compatible (260 C):Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA032D02DCARG4 | 功能描述:音頻放大器 Stereo Medium Power Class-D Audio Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA032D02EVM | 制造商:Texas Instruments 功能描述:CLASS-D STEREO AUDIO POWER AMP EVM - Bulk |
| TPA032D03 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-W MONO CLASS-D AUDIO POWER AMPLIFIER |
| TPA032D03_07 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-W MONO CLASS-D AUDIO POWER AMPLIFIER |
| TPA032D03DCA | 功能描述:音頻放大器 10W Monaur RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。