- 您現在的位置：買賣IC網 > PDF目錄98271 > TPA2015D1YZHT (TEXAS INSTRUMENTS INC) 1.7 W, 1 CHANNEL, AUDIO AMPLIFIER, BGA16 PDF資料下載
參數資料
| 型號： | TPA2015D1YZHT |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 1.7 W, 1 CHANNEL, AUDIO AMPLIFIER, BGA16 |
| 封裝： | 1.954 X 1.954 MM, 0.50 MM PITCH, DSBGA-16 |
| 文件頁數： | 5/27頁 |
| 文件大小： | 1016K |
| 代理商： | TPA2015D1YZHT |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
www.ti.com
SLOS638 – MAY 2010
Connect a resistor between the AGC pin and ground to set the inflection point, as shown in Table 1. Leave the
AGC pin floating to disable the inflection point, keeping the limiter level constant over all supply voltages.
The maximum limiter level is fixed, as is the slope of the limiter level versus supply voltage. If different values for
maximum limiter level and slope are required, contact your local Texas Instruments representative.
Table 1. AGC Function Table
Function
Resistor on AGC pin
Inflection Point
Constant limiter level; battery track OFF
Floating or connected to VBAT
disabled
AGC battery track option 1
39 k
3.55 V
AGC battery track option 2
27 k
3.78 V
AGC battery track option 3
18 k
3.96 V
The audio signal is not affected by the SpeakerGuard function unless the peak audio output voltage exceeds
the limiter level. Figure 23 shows the relationship between the audio signal, the limiter level, the supply voltage,
and the supply current.
When VBAT is greater than the inflection point, the limiter level allows the output signal to slightly clip to roughly
6% THD at 2 W into 8
Ω. This is an acceptable peak distortion level for most small-sized portable speakers,
while ensuring maximum loudness from the speaker.
Battery Tracking SpeakerGuard Example
Phase 1
Battery discharging normally; supply voltage is above inflection point; audio output remains
below limiter level.
The limiter level remains constant because the supply voltage is greater than the inflection point.
Amplifier gain is constant at fixed-gain as set by the GAIN pin. The audio output remains at a
constant loudness. The boost converter allows the audio output to swing above the battery supply
voltage. Battery supply current increases as supply voltage decreases.
Phase 2
Battery continues to discharge normally; supply voltage decreases below inflection point;
limiter level decreases below audio output.
The limiter level decreases as the battery supply voltage continues to decrease. SpeakerGuard
lowers amplifier gain, reducing the audio output below the new limiter level. The supply current
decreases due to reduced output power.
Phase 3
Battery supply voltage is constant; audio output remains below limiter level.
The audio output, limiter level, and supply current remain constant as well.
Phase 4
Phone plugged in and battery re-charges; supply voltage increases.
The limiter level increases as the supply voltage increases. SpeakerGuard increases amplifier
gain slowly, increasing audio output. Because the TPA2015D1 supply current is proportional to the
PVOUT-to-VBAT ratio, the supply current decreases as battery supply voltage increases.
Phase 5
Battery supply voltage is constant; audio output is below limiter level.
SpeakerGuard continues to increase amplifier gain to the fixed-gain as set by the GAIN pin. The
audio output signal increases (slowly due to release time) to original value.
Phase 6
Battery supply voltage is constant; audio output remains below limiter level.
Amplifier gain equal to fixed-gain as set by the GAIN pin. Audio output signal does not change.
Supply current remains constant.
Copyright 2010, Texas Instruments Incorporated
13
Product Folder Link(s): TPA2015D1
相關PDF資料 |
PDF描述 |
|---|---|
| TPA2016D2YZHR | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, BGA16 |
| TPA2016D2YZHT | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, BGA16 |
| TPA2016D2RTJR | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20 |
| TPA2016D2RTJT | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20 |
| TPA2017D2RTJR | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA2016D2 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1.7-W/Ch Stereo Class-D Audio Amplifier with Dynamic Range Compression and AGC |
| TPA2016D2EVM | 功能描述:音頻 IC 開發工具 TPA2016D2EVM Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| TPA2016D2RGPR | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1.7-W/Ch Stereo Class-D Audio Amplifier with Dynamic Range Compression and AGC |
| TPA2016D2RGPT | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1.7-W/Ch Stereo Class-D Audio Amplifier with Dynamic Range Compression and AGC |
| TPA2016D2RTJR | 功能描述:音頻放大器 1.7-W/Ch St Class-D Audio Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。