欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TPA2016D2RTJT
廠商: TEXAS INSTRUMENTS INC
元件分類: 音頻/視頻放大
英文描述: 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20
封裝: 4 X 4 MM, GREEN, PLASTIC, QFN-20
文件頁數: 9/38頁
文件大小: 1216K
代理商: TPA2016D2RTJT
V
-dBV
O
U
T
V
-dBV
IN
MaxGain
= 22dB
MaxGain
= 30dB
1:1
www.ti.com........................................................................................................................................................ SLOS524D – JUNE 2008 – REVISED AUGUST 2009
Figure 33. Output Signal vs. Input Signal State Diagram Showing Different Maximum Gains
A particular application requiring maximum gain of 22dB, for example. Thus, set the maximum gain at 22dB. The
amplifier gain will never have a gain higher than 22dB; however, this will reduce the limiter range.
Attack, Release, and Hold time:
The attack time is the minimum time between gain decreases.
The release time is the minimum time between gain increases.
The hold time is the minimum time between a gain decrease (attack) and a gain increase (release). The hold
time can be deactivated. Hold time is only valid if greater than release time.
Successive gain decreases are never faster than the attack time. Successive gain increases are never faster
than the release time.
All time variables (attack, release and hold) start counting after each gain change performed by the AGC. The
AGC is allowed to decrease the gain (attack) only after the attack time finishes. The AGC is allowed to increase
the gain (release) only after the release time finishes counting. However, if the preceding gain change was an
attack (gain increase) and the hold time is enabled and longer than the release time, then the gain is only
increased after the hold time.
The hold time is only enabled after a gain decrease (attack). The hold time replaces the release time after a gain
decrease (attack). If the gain needs to be increased further, then the release time is used. The release time is
used instead of the hold time if the hold time is disabled.
The attack time should be at least 100 times shorter than the release and hold time. The hold time should be the
same or greater than the release time. It is important to select reasonable values for those variables in order to
prevent the gain from changing too often or too slow.
Figure 34 illustrates the relationship between the three time variables.
Copyright 2008–2009, Texas Instruments Incorporated
17
Product Folder Link(s): TPA2016D2
相關PDF資料
PDF描述
TPA2017D2RTJR 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20
TPA2017D2RTJT 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20
TPA2026D2YZHR AUDIO AMPLIFIER, PBGA16
TPA2026D2YZHT AUDIO AMPLIFIER, PBGA16
TPA2028D1YZFR 3 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9
相關代理商/技術參數
參數描述
TPA2016D2V1YZHR 制造商:Texas Instruments 功能描述:
TPA2016D2YZHR 功能描述:音頻放大器 1.7W/Ch Stereo Class D Aud Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA2016D2YZHT 功能描述:音頻放大器 1.7W/Ch Stereo Class D Aud Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA2016DYZHT2 制造商:Texas Instruments 功能描述:
TPA2017D2 制造商:TI 制造商全稱:Texas Instruments 功能描述:2.8-W/Ch Stereo Class-D Audio Amplifier with SmartGainTM Dynamic Range Compression and AGC
主站蜘蛛池模板: 海阳市| 长春市| 普格县| 乐陵市| 清水县| 贺州市| 克什克腾旗| 缙云县| 旺苍县| 阳高县| 当雄县| 准格尔旗| 邵阳市| 时尚| 鄂温| 桃江县| 乌海市| 务川| 宁河县| 曲水县| 巨野县| 临夏市| 鹿邑县| 张家港市| 勐海县| 湘潭县| 阳曲县| 巴林左旗| 枣阳市| 来宾市| 华安县| 章丘市| 聂拉木县| 通渭县| 西畴县| 丁青县| 昂仁县| 天祝| 郎溪县| 广昌县| 南昌县|