- 您現在的位置：買賣IC網 > PDF目錄98280 > TPS2540RTET (TEXAS INSTRUMENTS INC) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC16 PDF資料下載
參數資料
| 型號： | TPS2540RTET |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC16 |
| 封裝： | GREEN, PLASTIC, WQFN-16 |
| 文件頁數： | 18/37頁 |
| 文件大小： | 999K |
| 代理商： | TPS2540RTET |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
SLVSAG2A
– OCTOBER 2010 – REVISED APRIL 2011
Logic Control Modes
Both the TPS2540/40A and TPS2541 support the listed standards above for the SDP, CDP and DCP modes
using the CTL1, CTL2, and CTL3 logic I/O control pins, although their truth tables are different as shown below.
The different CTLx settings correspond to the different types of charge modes. Also, using the Auto-Detect
Mode, the Divider Mode or BC1.2 / YD/T 1591-2009 can be automatically selected without external user
interaction.
NOTE
With the TPS254040A, if the
“000” mode is selected, the power switch will be turned off
and an output discharge resistor will be connected, while the data line switches will be
turned off.
Table 2. TPS2540/40A Control Truth Table
CTL1
CTL2
CTL3
MODE
0
OUT discharge, power switch OFF.
0
X
1
Dedicated charging port, auto-detect.
X
1
0
Standard downstream port, USB 2.0 Mode.
1
0
Dedicated charging port, BC1.2 only.
1
0
1
Dedicated charging port, Divider Mode only.
1
Charging downstream port, BC1.2.
Table 3. TPS2541 Control Truth Table
CTL1
CTL2
CTL3
MODE
0
X
Dedicated charging port, auto-detect.
0
1
X
Dedicated charging port, BC1.2.
1
0
X
Dedicated charging port, Divider Mode only.
1
0
Standard downstream port, USB 2.0 Mode.
1
Charging downstream port, BC1.2.
Output Discharge
To allow a charging port to renegotiate current with a portable device, TPS2540/40A/41 uses the VBUS
discharge function. It proceeds by turning off the power switch while discharging OUT, then turning back ON the
power switch to reassert the OUT voltage.
This discharge function is automatically applied when a change at the CTLx lines results in any of the following
mode transitions.
Any transition to and from CDP
Any transition to and from SDP
In addition to this, a direct discharge control, DSC, is available with the TPS2541, while with the TPS2540/40A, a
discharge can be achieved using the mode
“000”.
Overcurrent Protection
When an over-current condition is detected, the device maintains a constant output current and reduces the
output voltage accordingly. Two possible overload conditions can occur. In the first condition, the output has
been shorted before the device is enabled or before VIN has been applied.
The TPS2540/40A/41 senses the short and immediately switches into a constant-current output. In the second
condition, a short or an overload occurs while the device is enabled. At the instant the overload occurs, high
currents may flow for nominally one to two microseconds before the current-limit circuit can react. The device
operates in constant-current mode after the current-limit circuit has responded. Complete shutdown occurs only if
the fault is present long enough to activate thermal limiting. The device will remain off until the junction
temperature cools approximately 10
°C and will then re-start. The device will continue to cycle on/off until the
over-current condition is removed.
Copyright
2010–2011, Texas Instruments Incorporated
25
相關PDF資料 |
PDF描述 |
|---|---|
| TPS2541RTET | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC16 |
| TPS2550DBV | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
| TPS2551DRVR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
| TPS2551DRVTG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
| TPS2551DRVRG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS2540RTET | 制造商:Texas Instruments 功能描述:IC USB SWITCH 2.6GHZ 16-WQFN |
| TPS2541ARTER | 功能描述:電源開關 IC - USB USB Charging Port Pwr Sw & Controller RoHS:否 制造商:Micrel 電源電壓-最小:2.7 V 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2541ARTET | 功能描述:電源開關 IC - USB USB Charging Port Pwr Sw & Controller RoHS:否 制造商:Micrel 電源電壓-最小:2.7 V 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2541RTER | 功能描述:電源開關 IC - USB USB Charging Port Pwr Swtch &Contrller RoHS:否 制造商:Micrel 電源電壓-最小:2.7 V 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2541RTET | 功能描述:電源開關 IC - USB USB Charging Port Pwr Swtch &Contrller RoHS:否 制造商:Micrel 電源電壓-最小:2.7 V 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。