- 您現在的位置：買賣IC網 > PDF目錄98280 > TPS2551DRVRG4 (TEXAS INSTRUMENTS INC) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 PDF資料下載
參數資料
| 型號： | TPS2551DRVRG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
| 封裝： | GREEN, PLASTIC, SON-6 |
| 文件頁數： | 7/32頁 |
| 文件大小： | 1402K |
| 代理商： | TPS2551DRVRG4 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
DETAILED DESCRIPTION
OVERVIEW
OVERCURRENT
REVERSE-VOLTAGE PROTECTION
FAULT RESPONSE
UNDERVOLTAGE LOCKOUT (UVLO)
www.ti.com ........................................................................................................................................ SLVS736B – FEBRUARY 2008 – REVISED NOVEMBER 2008
The TPS2550/51 are current-limited, power distribution switches using N-channel MOSFETs for applications
where short-circuits or heavy capacitive loads will be encountered. These devices allow the user to program the
current-limit threshold between 100 mA and 1.1 A via an external resistor. Additional device shutdown features
include overtemperature protection and reverse-voltage protection. The device incorporates an internal charge
pump and gate drive circuitry necessary to drive the N-channel MOSFET. The charge pump supplies power to
the driver circuit and provides the necessary voltage to pull the gate of the MOSFET above the source. The
charge pump operates from input voltages as low as 2.5 V and requires little supply current. The driver controls
the gate voltage of the power switch. The driver incorporates circuitry that controls the rise and fall times of the
output voltage to limit large current and voltage surges and provide built-in soft-start functionality.
The TPS2550/51 responds to an overcurrent condition by limiting its output current to the IOC and IOS levels
shown in Figure 21. Three response profiles are possible depending on the loading conditions and are
summarized in Figure 4.
One response profile occurs if the TPS2550/51 is enabled into a short-circuit. The output voltage is held near
zero potential with respect to ground and the TPS2550/51 ramps the output current to IOS (see Figure 7).
A second response profile occurs if a short is applied to the output after the TPS2550/51 is enabled. The device
responds to the overcurrent condition within time tIOS (see Figure 3). The current-sense amplifier is over-driven
during this time and momentarily disables the internal current-limit MOSFET. The current-sense amplifier
gradually recovers and limits the output current to IOS.
A third response profile occurs if the load current gradually increases. The device first limits the load current to
IOC. If the load demands a current greater than IOC, the TPS2550/51 folds back the current to IOS and the output
The TPS2550/51 thermal cycles if an overload condition is present long enough to activate thermal limiting in any
of the above cases. The device turns off when the junction temperature exceeds 135°C (typ). The device
remains off until the junction temperature cools 15°C (typ) and then restarts. The TPS2550/51 cycles on/off until
The reverse-voltage protection feature turns off the N-channel MOSFET whenever the output voltage exceeds
the input voltage by 135 mV (typical) for 4-ms. This prevents damage to devices on the input side of the
TPS2550/51 by preventing significant current from sinking into the input capacitance. The N-channel MOSFET is
allowed to turn-on once the output voltage goes below the input voltage for the same 4-ms deglitch time. The
reverse-voltage comparator also asserts the FAULT output (active-low) after 4-ms.
The FAULT open-drain output is asserted (active low) during an overcurrent, overtemperature or reverse-voltage
condition. The output remains asserted until the fault condition is removed. The TPS2550/51 is designed to
eliminate false FAULT reporting by using an internal delay "deglitch" circuit for overcurrent (7.5-ms) and
reverse-voltage (4-ms) conditions without the need for external circuitry. This ensures that FAULT is not
accidentally asserted due to normal operation such as starting into a heavy capacitive load. The deglitch circuitry
delays entering and leaving fault conditions. Overtemperature conditions are not deglitched and assert the
FAULT signal immediately.
The undervoltage lockout (UVLO) circuit disables the power switch until the input voltage reaches the UVLO
turn-on threshold. Built-in hysteresis prevents unwanted on/off cycling due to input voltage drop from large
current surges.
Copyright 2008, Texas Instruments Incorporated
15
相關PDF資料 |
PDF描述 |
|---|---|
| TPS2551DBVR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
| TPS2554DRCT | POWER SUPPLY SUPPORT CKT, PDSO10 |
| TPS2557DRBT | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| TPS2557DRB | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| TPS2561DRC | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS2551DRVT | 功能描述:電源開關 IC - USB Adj Crnt-Ltd Pwr Dist Sw RoHS:否 制造商:Micrel 電源電壓-最小:2.7 V 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2551DRVTG4 | 功能描述:電源開關 IC - USB Adj current Ltd Sw RoHS:否 制造商:Micrel 電源電壓-最小:2.7 V 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2551QDBVRQ1 | 功能描述:電源開關 IC - USB Adj Crnt-Limited Pwr Distribution Sw RoHS:否 制造商:Micrel 電源電壓-最小:2.7 V 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2552DBV1EVM-364 | 功能描述:交換機 IC 開發工具 TPS2552DBV1EVM-364 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:USB Power Switches 工具用于評估:MAX4984E 工作電源電壓:2.8 V to 5.5 V |
| TPS2552DBVEVM-364 | 功能描述:交換機 IC 開發工具 TPS2552DBVEVM-364 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:USB Power Switches 工具用于評估:MAX4984E 工作電源電壓:2.8 V to 5.5 V |
發布緊急采購，3分鐘左右您將得到回復。