- 您現在的位置：買賣IC網 > PDF目錄98281 > TPS40077PWPRG4 (TEXAS INSTRUMENTS INC) 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | TPS40077PWPRG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | GREEN, PLASTIC, HTSSOP-16 |
| 文件頁數： | 19/43頁 |
| 文件大小： | 847K |
| 代理商： | TPS40077PWPRG4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁
COUT +
LOUT
I
STEP
2
V
UNDER
Dmax
(V
IN * VOUT)
(21)
COUT +
LOUT
I
STEP
2
V
OVER
V
OUT
(22)
ESR +
V
RIPPLE
I
RIPPLE
(23)
I
CAP(RMS) +
I
OUT * IIN(AVG)
2
)
I
RIPPLE
2
12
D ) IIN(AVG)
2
(1 * D)
(24)
I
QSW(RMS) +
V
OUT
V
IN(MIN)
I
OUT(MAX)
2
)
I
RIPPLE
2
12
(25)
SLUS714D – JANUARY 2007 – REVISED APRIL 2009 ..................................................................................................................................................... www.ti.com
Output Capacitor, COUT, ELCO and MLCC
Several parameters must be considered when selecting the output capacitor. The capacitance value should be
selected based on the output overshoot, VOVER, and undershoot, VUNDER, during a transient load, ISTEP, on the
converter. The equivalent series resistance (ESR) is chosen to allow the converter to meet the output ripple
specification, VRIPPLE. The voltage rating must be greater than the maximum output voltage. Another parameter
to consider is equivalent series inductance, which is important in fast-transient load situations. Also, size and
technology can be factors when choosing the output capacitor. In this design, a large-capacitance electrolytic
type capacitor, COUT ELCO, is used to meet the overshoot and undershoot specifications. Its ESR is chosen to
meet the output ripple specification. Smaller multiple-layer ceramic capacitors, COUT MLCC, are used to filter
high-frequency noise.
The minimum required capacitance and maximum ESR can be calculated using the following equations.
F, and
its ESR should be less than 12 m
. The 470-
F/6.3-V capacitor from Panasonic's FC series was chosen. Its
ESR is 160 m
. MLCCs of 47
F and 22 F/16 V are also added in parallel to achieve the required ESR and to
reduce high-frequency noise.
Input Capacitor, CIN ELCO and MLCC
The input capacitor is selected to handle the ripple current of the buck stage. Also, a relatively large capacitance
is used to keep the ripple voltage on the supply line low. This is especially important where the supply line has
high impedance. It is recommended however, that the supply-line impedance be kept as low as possible.
The input-capacitor ripple current can be calculated using Equation 24.
IIN(AVG) is the average input current. This is calculated simply by multiplying the output dc current by the duty
cycle. The ripple current in the input capacitor is 3.3 A. An 1812 MLCC using X5R material has a typical
dissipation factor of 5%. For a 22-
F capacitor at 300 kHz, the ESR is approximately 4 m. Two capacitors are
used in parallel, so the power dissipation in each capacitor is less than 11 mW.
A 470-
F/16-V electrolytic is added to maintain the voltage on the input rail.
Switching MOSFET, QSW
The following key parameters must be met by the selected MOSFET.
Drain source voltage, V
ds, must be able to withstand the input voltage plus spikes that may be on the
switching node. For this design a Vds rating of 30 volts is recommended.
Drain current, I
D, at 25°C, must be greater than that calculated using Equation 25.
With the parameters specified, the calculation of I
QSW(RMS) should be greater than 5 A.
Gate source voltage, V
gs, must be able to withstand the gate voltage from the control IC. For the TPS40077,
26
Copyright 2007–2009, Texas Instruments Incorporated
Product Folder Link(s) :TPS40077
相關PDF資料 |
PDF描述 |
|---|---|
| TPS40077PWPG4 | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40090QPWRQ1 | SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PDSO24 |
| TPS40101RGET | 1.3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC24 |
| TPS40131RHBT | SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PQCC32 |
| TPS40131RHBTG4 | SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PQCC32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS40090 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:HIGH FREQUENCY MULTIPHASE CONTROLLER |
| TPS40090EVM-001 | 功能描述:電源管理IC開發工具 TPS40090-001 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS40090EVM-002 | 功能描述:電源管理IC開發工具 TPS40090-002 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS40090PW | 功能描述:DC/DC 開關控制器 4 Ch Multiphase Buck DC/DC Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TPS40090PW | 制造商:Texas Instruments 功能描述:CONTROLLER IC |
發布緊急采購，3分鐘左右您將得到回復。