- 您現在的位置：買賣IC網 > PDF目錄98281 > TPS40211DRCTG4 (TEXAS INSTRUMENTS INC) SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | TPS40211DRCTG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | GREEN, PLASTIC, SON-10 |
| 文件頁數： | 7/47頁 |
| 文件大?。?/td> | 1375K |
| 代理商： | TPS40211DRCTG4 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
(
)
f
SW
ISNS(oc)
ISNS
SW
OUT(oc)
OUT
D
IN
L V
R
2 L
I
V
=
+
-
(
)
f
ISNS
OUT
RIPPLE
OUT
IN
SW
V
R
I
D
V
1
D
2
1
D
2
L
=
+
÷
÷
÷
÷
÷
-
è
-
è
è
è
f
VDD
e
SW
V
s
20
=
÷
è
(
)
CS
ISNS
OUT
D
IN
A
R
V
m2
L
+
-
=
www.ti.com
SLUS772D – MARCH 2008 – REVISED APRIL 2010
(6)
(7)
Where:
RISNS is the value of the current sense resistor in .
VISNS(oc) is the overcurrent threshold voltage at the ISNS pin (from electrical specifications)
D is the duty cycle (from Equation 2)
f SW is the switching frequency in Hz
VIN is the input voltage to the power stage in V (see text)
L is the value of the inductor in H
IOUT(oc) is the desired overcurrent trip point in A
The TPS40210/11 has a fixed undervoltage lockout (UVLO) that allows the controller to start at a typical input
voltage of 4.25 V. If the input voltage is slowly rising, the converter might have less than its designed nominal
input voltage available when it has reached regulation. As a result, this may decreases the apparent current limit
load current value and must be taken into consideration when selecting RISNS. The value of VIN used to calculate
RISNS must be the value at which the converter finishes startup. The total converter output current at startup is
the sum of the external load current and the current required to charge the output capacitor(s). See the Soft Start
section of this datasheet for information on calculating the required output capacitor charging current.
The topology of the standard boost converter has no method to limit current from the input to the output in the
event of a short circuit fault on the output of the converter. If protection from this type of event is desired, it is
necessary to use some secondary protection scheme, such as a fuse, or rely on the current limit of the upstream
power source.
Current Sense and Sub-Harmonic Instability
A characteristic of peak current mode control results in a condition where the current control loop can exhibit
instability. This results in alternating long and short pulses from the pulse width modulator. The voltage loop
maintains regulation and does not oscillate, but the output ripple voltage increases. The condition occurs only
when the converter is operating in continuous conduction mode and the duty cycle is 50% or greater. The cause
of this condition is described in Texas Instruments literature number SLUA101, available at www.ti.com. The
remedy for this condition is to apply a compensating ramp from the oscillator to the signal going to the pulse
width modulator. In the TPS40210/11 the oscillator ramp is applied in a fixed amount to the pulse width
modulator. The slope of the ramp is given in Equation 8.
(8)
To ensure that the converter does not enter into sub-harmonic instability, the slope of the compensating ramp
signal must be at least half of the down slope of the current ramp signal. Since the compensating ramp is fixed in
the TPS40210/11, this places a constraint on the selection of the current sense resistor.
The down slope of the current sense wave form at the pulse width modulator is described in Equation 9.
(9)
Copyright 2008–2010, Texas Instruments Incorporated
15
相關PDF資料 |
PDF描述 |
|---|---|
| TPS40210DGQG4 | SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS40304ADRCT | SWITCHING CONTROLLER, PQCC10 |
| TPS40304ADRCR | SWITCHING CONTROLLER, PQCC10 |
| TPS5100IPWRG4 | SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS5100PWLE | SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS40211EVM-352 | 功能描述:電源管理IC開發工具 TPS40211EVM-352 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS40211EVM-352 | 制造商:Texas Instruments 功能描述:EVAL BOARD, TPS40211 ADJ 700mA NON SYS B |
| TPS40211QDGQRQ1 | 功能描述:LED照明驅動器 WIDE INP CRNT MODE BOOST CONTROLLER RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| TPS40-22 | 制造商:TOTAL-POWER 制造商全稱:TOTAL-POWER 功能描述:40 WATT OPEN - FRAME SWITCHING POWER SUPPLY |
| TPS40222 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1.6-A, 1.25-MHz BUCK CONVERTER IN A 3 mm 3 mm SON PACKAGE |
發布緊急采購，3分鐘左右您將得到回復。