欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TPS5110PW
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24
封裝: GREEN, PLASTIC, TSSOP-24
文件頁數: 43/43頁
文件大小: 813K
代理商: TPS5110PW
TPS5110
SLVS025B APRIL 2002 REVISED JULY 2004
9
www.ti.com
DETAILED DESCRIPTION
dead time
The internally defined dead-time prevents shoot-through current flowing through the main power MOSFETs
during switching transitions. Typical value of the dead-time is 100 ns.
standby
The SBRC and the LDO controller can be switched into standby mode separately by grounding the STBY pin
and/or SYBY_LDO pins. The standby-mode current, when both controllers are off, can be as low as 1 nA.
Table 1. Standby Logic (VREG5V_IN > 4 V){
STBY
STBY_LDO
SBRC
LDO
POWERGOOD
L
OFF
L
H
OFF
ON
OFF
H
L
ON
OFF
H
ON
soft start
Soft-start ramp up of the SBRC is controlled by the SOFTSTART pin voltage. After the STBY pin is raised to
a HIGH level, an internal current source charges up an external capacitor connected between the SOFTSTART
and GND pins. The output voltage ramps up as the SOFTSTART pin voltage increases from 0 V to 0.85 V. The
soft-start time is easily calculated by the supply current and the capacitance value (see application information).
The soft-start timing circuit for the LDO is integrated into the device. The soft-start time is fixed and can be as
short as 600
s. This is observed when the LDO is turned on separately from the SBRC. Simultaneous start
up of the two outputs is also possible. Tie the LDO input to the SBRC’s output and let both STBY_LDO and STBY
voltages rise to the HIGH level simultaneously, then the LDO’s output follows the ramp of the SBRC’s output.
over current protection
Over current protection (OCP) is achieved by comparing the drain-to-source voltage of the high-side and
low-side MOSFET to a set-point voltage, which is defined by both the internal current source, ITRIP, and the
external resistor connected between the VIN_SENSE and TRIP pins. ITRIP has a typical value of 13 A at 25°C.
When the drain-to-source voltage exceeds the set-point voltage during low-side conduction, the high-side
current comparator becomes active, and the low-side pulse is extended until this voltage comes back below
the threshold. If the set-point voltage is exceeded during high-side conduction in the following cycle, the
current-limit circuit terminates the high-side driver pulse. Together this action has the effect of decreasing the
output voltage until the under voltage protection circuit is activated to latch both the high-side and low-side
drivers OFF. In the TPS5110, trip current ITRIP also has a temperature coefficient of 3400 ppm/°C in order to
compensate for temperature drift of the MOSFET on-resistance.
相關PDF資料
PDF描述
TPS51163DRCR SWITCHING CONTROLLER, 660 kHz SWITCHING FREQ-MAX, PDSO10
TPS51113DRCR SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO10
TPS51200DRCT SPECIALTY ANALOG CIRCUIT, PDSO10
TPS51200DRCTG4 SPECIALTY ANALOG CIRCUIT, PDSO10
TPS51206DSQT SWITCHING REGULATOR, PDSO10
相關代理商/技術參數
參數描述
TPS5110PWG4 功能描述:DC/DC 開關控制器 Sync Buck w/NMOS LDO Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS5110PWR 功能描述:DC/DC 開關控制器 Sync Buck w/NMOS LDO Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS5110PWRG4 功能描述:DC/DC 開關控制器 Sync Buck w/NMOS LDO Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS51113 制造商:TI 制造商全稱:Texas Instruments 功能描述:SYNCHRONOUS BUCK CONTROLLER WITH HIGH-CURRENT GATE DRIVER
TPS51113DRCR 功能描述:DC/DC 開關控制器 4.5-13.2V Synch Buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
主站蜘蛛池模板: 广安市| 饶阳县| 苍山县| 北流市| 依兰县| 黔江区| 边坝县| 镇康县| 卫辉市| 弋阳县| 舒兰市| 榆中县| 和平县| 托克逊县| 潍坊市| 石河子市| 治县。| 宣武区| 竹北市| 威海市| 宜良县| 新巴尔虎左旗| 手游| 张家界市| 华阴市| 宝坻区| 广德县| 钟祥市| 许昌市| 松溪县| 大冶市| 若尔盖县| 绥德县| 开封市| 巫山县| 昌邑市| 阳信县| 金门县| 玉门市| 郁南县| 循化|