- 您現在的位置：買賣IC網 > PDF目錄98283 > TPS54623RHLT (TEXAS INSTRUMENTS INC) 15 A SWITCHING REGULATOR, 1760 kHz SWITCHING FREQ-MAX, PQCC14 PDF資料下載
參數資料
| 型號： | TPS54623RHLT |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 15 A SWITCHING REGULATOR, 1760 kHz SWITCHING FREQ-MAX, PQCC14 |
| 封裝： | 3.50 X 3.50 MM, GREEN, PLASTIC, QFN-14 |
| 文件頁數： | 10/35頁 |
| 文件大小： | 1468K |
| 代理商： | TPS54623RHLT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁
VSENSE
COMP
VOUT
R1
R3
C1
C2
R2
Coea
Roea
gm
1300 mA/V
0.6 V
Power Stage
PH
RESR
CO
RL
b
a
c
16 A/V
SLVSB09
– SEPTEMBER 2011
Furthermore, if an output overload condition (as measured by the COMP pin voltage) has lasted for more than
the hiccup wait time which is programmed for 512 switching cycles, the device will shut down itself and restart
after the hiccup time of 16384 cycles. The hiccup mode helps to reduce the device power dissipation under
severe overcurrent conditions.
Thermal Shutdown
The internal thermal shutdown circuitry forces the device to stop switching if the junction temperature exceeds
175
°C typically. Once the junction temperature drops below 165°C typically, the internal thermal hiccup timer will
start to count. The device reinitiates the power up sequence after the built-in thermal shutdown hiccup time
(16384 cycles) is over.
Small Signal Model for Loop Response
Figure 27 shows an equivalent model for the device control loop which can be modeled in a circuit simulation
program to check frequency response and transient responses. The error amplifier is a transconductance
amplifier with a gm of 1300
μA/V. The error amplifier can be modeled using an ideal voltage controlled current
source. The resistor Roea (2.38 M
) and capacitor Coea (20.7 pF) model the open loop gain and frequency
response of the error amplifier. The 1-mV ac voltage source between the nodes a and b effectively breaks the
control loop for the frequency response measurements. Plotting a/c and c/b show the small signal responses of
the power stage and frequency compensation respectively. Plotting a/b shows the small signal response of the
overall loop. The dynamic loop response can be checked by replacing the RL with a current source with the
appropriate load step amplitude and step rate in a time domain analysis.
Figure 27. Small Signal Model for Loop Response
Simple Small Signal Model for Peak Current Mode Control
Figure 28 is a simple small signal model that can be used to understand how to design the frequency
compensation. The device power stage can be approximated to a voltage controlled current source (duty cycle
modulator) supplying current to the output capacitor and load resistor. The control to output transfer function is
shown in Equation 10 and consists of a dc gain, one dominant pole and one ESR zero. The quotient of the
change in switch current and the change in COMP pin voltage (node c in Figure 27) is the power stage
transconductance (gmps) which is 16 A/V for the device. The DC gain of the power stage is the product of gmps
and the load resistance
L) as shown in Equation 11 with resistive loads. As the load current increases, the DC
gain decreases. This variation with load may seem problematic at first glance, but fortunately the dominant pole
moves with load current (see Equation 12). The combined effect is highlighted by the dashed line in Figure 29.
As the load current decreases, the gain increases and the pole frequency lowers, keeping the 0-dB crossover
frequency the same for the varying load conditions which makes it easier to design the frequency compensation.
18
Copyright
2011, Texas Instruments Incorporated
Product Folder Link(s) :TPS54623
相關PDF資料 |
PDF描述 |
|---|---|
| TPS54672PWPG4 | 12 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS54810PWPRG4 | 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS54810PWPG4 | 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS54873PWPG4 | 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS54880PWPR | 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS54625EVM-608 | 制造商:Texas Instruments 功能描述:TPS54625EVM-608 - Boxed Product (Development Kits) 制造商:Texas Instruments 功能描述:TPS54625 EVAL MOD |
| TPS54625PWP | 制造商:Texas Instruments 功能描述: 制造商:Texas Instruments 功能描述:IC REG BUCK ADJ 6.5A 14HTSSOP 制造商:Texas Instruments 功能描述:IC SYNC STEP DOWN 650KHZ HT |
| TPS54625PWPR | 功能描述:Buck Switching Regulator IC Positive Adjustable 0.765V 1 Output 6.5A 14-TSSOP (0.173", 4.40mm Width) Exposed Pad 制造商:texas instruments 系列:D-CAP2?? 包裝:剪切帶（CT） 零件狀態:有效 功能:降壓 輸出配置:正 拓撲:降壓 輸出類型:可調式 輸出數:1 電壓 - 輸入（最小值）:4.5V 電壓 - 輸入（最大值）:18V 電壓 - 輸出（最小值/固定）:0.765V 電壓 - 輸出（最大值）:5.5V 電流 - 輸出:6.5A 頻率 - 開關:650kHz 同步整流器:是 工作溫度:-40°C ~ 85°C（TA） 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬）裸焊盤 供應商器件封裝:14-HTSSOP 標準包裝:1 |
| TPS54626EVM-608 | 制造商:Texas Instruments 功能描述:TPS54626EVM-608 - Boxed Product (Development Kits) 制造商:Texas Instruments 功能描述:TPS54626 EVAL MOD |
| TPS54626PWP | 制造商:Texas Instruments 功能描述: 制造商:Texas Instruments 功能描述:IC SYNC STEP DOWN 650KHZ HT 制造商:Texas Instruments 功能描述:18V 6.5A DCAP2 sync converter |
發布緊急采購，3分鐘左右您將得到回復。