- 您現在的位置：買賣IC網 > PDF目錄98284 > TPS61251DSG (TEXAS INSTRUMENTS INC) SWITCHING REGULATOR, 3500 kHz SWITCHING FREQ-MAX, PDSO8 PDF資料下載
參數資料
| 型號： | TPS61251DSG |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, 3500 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | 2 X 2 MM, PLASTIC, WSON-8 |
| 文件頁數： | 5/21頁 |
| 文件大小： | 446K |
| 代理商： | TPS61251DSG |
1
OUT
FB
2
R
V
1
R
=
+
÷
è
g
ILIM
LIM
1.0V
R
10,000
I
=
g
IN
OUT(max)
LIM
OUT
V
I
V
h
g
www.ti.com
SLVSAF7 – SEPTEMBER 2010
APPLICATION INFORMATION
EXAMPLE
During the following Application Information section one specific example will be used to define and work with the
different equations.
Parameter
Symbol
Value
Unit
Input Voltage
VIN
3.6
V
Minimum Input Voltage
VIN(min)
2.9
V
Output Voltage
VOUT
5.5
V
Input Current Limit set by RILIM
ILIM
500
mA
Feedback Voltage
VFB
1.2
V
Switching Frequency
f
3.5
MHz
Estimated Efficiency
h
90
%
Inductor Value of Choice
L1
1.0
H
OUTPUT VOLTAGE SETTING
The output voltage can be calculated by Equation 4:
(4)
To minimize the current through the feedback divider network and therefore increase efficiency during snooze
mode operation, R2 should be >240k. To keep the network robust against noise the resistor divider can also be
in the lower 100k values. Regarding the example, R1 is 1000 k
Ω and R2 is 280 kΩ.
An external feed forward capacitor C1 is required for optimum load transient response. The value of C1 should
be 1000pF. The connection from FB pin to the resistor divider should be kept short and away from noise
sources, such as the inductor or the SW line.
AVERAGE INPUT CURRENT LIMIT
The average input current is set by selecting the correct external resistor value correlating to the required current
limit. Equation 5 is a guideline for selecting the correct resistor value:
(5)
For a current limit of 500 mA the resistor value will be 20 k
Ω
MAXIMUM OUTPUT CURRENT
The maximum output current is set by RILIM and the input to output voltage ratio and can be calculated by
(6)
Following the example IOUT(max) will be 295 mA at 3.6 V input voltage and will decrease with lower input voltage
values due to the energy conservation.
INDUCTOR SELECTION
As for all switching power supplies two main passive components are required for storing the energy during
operation. This is done by an inductor and an output capacitor. The inductor must be connected between VIN pin
and SW pin to make sure that the TPS61251 device operates. To select the right inductor current rating the
programmed input current limit as well as the current ripple through the inductor is necessary. Estimation of the
maximum peak inductor current can be done using Equation 7.
Copyright 2010, Texas Instruments Incorporated
13
Product Folder Link(s): TPS61251
相關PDF資料 |
PDF描述 |
|---|---|
| TPS62000YEGR | 1.6 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, BGA12 |
| TPS62000YEGT | 1.6 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, BGA12 |
| TPS62000YEG | 1.6 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, BGA12 |
| TPS62000YZG | 1.6 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, BGA12 |
| TPS62080DSG | 0.002 A SWITCHING REGULATOR, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS61251DSGR | 功能描述:直流/直流開關調節器 3.5MHz1.5A Current Limit92% Eff Boost RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS61251DSGT | 功能描述:直流/直流開關調節器 3.5MHz1.5A Current Limit92% Eff Boost RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS61251DSGT | 制造商:Texas Instruments 功能描述:IC BOOST DC/DC CONV ADJ 3V-6.5V OUTPUT 制造商:Texas Instruments 功能描述:IC, BOOST DC/DC CONV, ADJ 3V-6.5V OUTPUT, 1.5A, 8-QFN |
| TPS61251EVM-517 | 功能描述:電源管理IC開發工具 TPS61251 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS61252 | 制造商:TAOS 制造商全稱:TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS 功能描述:TINY 1.5-A BOOST CONVERTER WITH ADJUSTABLE INPUT CURRENT LIMIT |
發布緊急采購，3分鐘左右您將得到回復。