- 您現在的位置：買賣IC網 > PDF目錄382716 > UBA1707 (NXP Semiconductors N.V.) Cordless telephone, answering machine line interface(無繩電話，電話應答機線接口) PDF資料下載
參數資料
| 型號： | UBA1707 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Cordless telephone, answering machine line interface(無繩電話，電話應答機線接口) |
| 中文描述： | 無繩電話，應答機行界面（無繩電話，電話應答機線接口） |
| 文件頁數： | 13/36頁 |
| 文件大小： | 245K |
| 代理商： | UBA1707 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
1999 Feb 17
13
Philips Semiconductors
Product specification
Cordless telephone, answering machine
line interface
UBA1707
Fig.11 Equivalent circuit of an anti-sidetone network in a Wheatstone bridge configuration.
handbook, full pagewidth
MGL217
Im
ZRXI
RXI
Zbal
Rast1
SLPE
RSLPE
GND
Zline
ZSET
LN
RA
A
UTOMATIC GAIN CONTROL
(
PIN
AGC;
BITS
RAGC1,
RAGC2, SAGC
AND
AGC)
The UBA1707 performs automatic line loss compensation.
The automatic gain control varies the gain of the transmit
amplifier and the gain of the receive amplifier in
accordance with the DC line current. The control range is
6.5 dB (which roughly corresponds to a line length of
5.5 km for a 0.5 mm diameter twisted-pair copper cable
with a DC resistance of 176
/km and an average
attenuation of 1.2 dB/km).
When the line current is greater than I
stop
, the voltage
gains are minimum. When the line current is less than I
start
,
the voltage gains are maximum. When the AGC pin is
connected to pin GND, the start line current (I
start
) can be
chosen between 22.5 and 29.5 mA via bits RAGC1 and
RAGC2 through the serial interface. Two values for the
I
stop
/I
start
ratio (slope of the AGC) are possible via the bit
SAGC through the serial interface. When bit SAGC is at
logic 0 then I
stop
= 2.7
×
I
start
(optimized for voltage
regulation mode). When SAGC is at logic 1 then
I
stop
= 1.9
×
I
start
(optimized for current regulation mode).
An external resistor R
AGC
(connected between pins GND
and AGC) enables the I
start
and I
stop
line currents to be
increased (the ratio between I
start
and I
stop
is not affected
by this external resistor). So internal and external
adjustments of the automatic gain control allow
optimization of the IC for many configurations of exchange
supply voltage and feeding bridge resistance. Part of the
line current flows into the Z
SET
impedance network. The IC
has been optimized for Z
SET
= 619
. Changing this 619
value slightly modifies I
stop
and I
start
line currents as well as
the value of the two AGC slopes.
The automatic gain control function can be disabled by
setting the AGC bit to logic 0 via the serial interface or
when pin AGC is left open-circuit. In this case both of the
voltage gains are maximum.
相關PDF資料 |
PDF描述 |
|---|---|
| UBA1710M | Modulator for GaAs power amplifiers(應用于GaAs功率放大器的調節器) |
| UBA2000T | Electronic TL-lamp starter(電子TL-lamp啟動器) |
| UBA2030T | Full bridge driver IC(整橋驅動器芯片) |
| UBA2050 | One-chip telephone ICs with speech, dialler and ringer functions(帶語音，撥號及振鈴功能的單片電話芯片) |
| UBA2050A | One-chip telephone ICs with speech, dialler and ringer functions(帶語音，撥號及振鈴功能的單片電話芯片) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UBA1707T | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Cordless telephone, answering machine line interface |
| UBA1707TS | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Cordless telephone, answering machine line interface |
| UBA1710M | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Modulator for GaAs power amplifiers |
| UBA2000T | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Electronic TL-lamp starter |
| UBA2007 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Charge switch |
發布緊急采購，3分鐘左右您將得到回復。