- 您現在的位置：買賣IC網 > PDF目錄373920 > AD7862SQ-10 (ANALOG DEVICES INC) Simultaneous Sampling Dual 250 kSPS 12-Bit ADC PDF資料下載
參數資料
| 型號： | AD7862SQ-10 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | ADC |
| 英文描述： | Simultaneous Sampling Dual 250 kSPS 12-Bit ADC |
| 中文描述： | 2-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, CDIP28 |
| 封裝： | CERDIP-28 |
| 文件頁數： | 13/16頁 |
| 文件大小： | 414K |
| 代理商： | AD7862SQ-10 |
AD7862
–13–
REV. 0
MICROPROCESSOR INTERFACING
The AD7862 high speed bus timing allows direct interfacing to
DSP processors as well as modern 16-bit microprocessors.
Suitable microprocessor interfaces are shown in Figures 14
through 18.
AD7862–ADSP-2100 Interface
Figure 14 shows an interface between the AD7862 and the
ADSP-2100. The
CONVST
signal can be supplied from the
ADSP-2100 or from an external source. The AD7862 BUSY
line provides an interrupt to the ADSP-2100 when conversion is
completed on all four channels. The four conversion results can
then be read from the AD7862 using four successive reads to
the same memory address. The following instruction reads one
of the four results (this instruction is repeated four times to read
all four results in sequence):
MR0
=
DM
(
ADC
)
where
MR0
is the ADSP-2100 MR0 register, and
ADC
is the
AD7862 address.
OPTIONAL
DMA0
DMA13
DMD15
DMD0
DMS
EN
ADDR
DECODE
ADDRESS BUS
ADSP-2100
(ADSP-2101/
ADSP-2102)
* ADDITIONAL PINS OMITTED FOR CLARITY
DATA BUS
CONVST
CS
DB11
DB0
RD
BUSY
AD7862*
IRQn
DMRD (RD)
A0
Figure 14. AD7862–ADSP-2100 Interface
AD7862–ADSP-2101/ADSP-2102 INTERFACE
The interface outlined in Figure 14 also forms the basis for an
interface between the AD7862 and the ADSP-2101/ADSP-2102.
The READ line of the ADSP-2101/ADSP-2102 is labeled
RD
.
In this interface, the
RD
pulse width of the processor can be
programmed using the Data Memory Wait State Control Register.
The instruction used to read one of the four results is outlined
for the ADSP-2100.
AD7862–TMS32010 Interface
An interface between the AD7862 and the TMS32010 is shown
in Figure 15. Once again, the
CONVST
signal can be supplied
from the TMS32010 or from an external source, and the
TMS32010 is interrupted when both conversions have been
completed. The following instruction is used to read the conver-
sion results from the AD7862:
IN D,ADC
where
D
is Data Memory address, and
ADC
is the AD7862
address.
OPTIONAL
PA0
PA2
D15
D0
MEN
EN
ADDR
DECODE
ADDRESS BUS
TMS32010
* ADDITIONAL PINS OMITTED FOR CLARITY
DATA BUS
CONVST
CS
DB11
DB0
RD
BUSY
AD7862*
INT
DEN
A0
Figure 15. AD7862–TMS32010 Interface
AD7862–TMS320C25 Interface
Figure 16 shows an interface between the AD7862 and the
TMS320C25. As with the two previous interfaces, conversion
can be initiated from the TMS320C25 or from an external
source, and the processor is interrupted when the conversion
sequence is completed. The TMS320C25 does not have a
separate
RD
output to drive the AD7862
RD
input directly.
This has to be generated from the processor STRB and R/
W
outputs with the addition of some logic gates. The
RD
signal is
OR-gated with the MSC signal to provide the one WAIT state
required in the read cycle for correct interface timing. Conver-
sion results are read from the AD7862 using the following
instruction:
IN D,ADC
where
D
is Data Memory address and
ADC
is the AD7862
address.
A0
A15
D15
D0
IS
EN
ADDR
DECODE
ADDRESS BUS
OPTIONAL
DATA BUS
CONVST
A0
CS
DB11
DB0
RD
BUSY
AD7862*
TMS320C25
*ADDITIONAL PINS OMITTED FOR CLARITY
INTn
R/W
STRB
MSC
READY
Figure 16. AD7862–TMS320C25 Interface
相關PDF資料 |
PDF描述 |
|---|---|
| AD7862AR-3 | Simultaneous Sampling Dual 250 kSPS 12-Bit ADC |
| AD7862ARS-10 | Simultaneous Sampling Dual 250 kSPS 12-Bit ADC |
| AD7862ARS-2 | Simultaneous Sampling Dual 250 kSPS 12-Bit ADC |
| AD7862ARS-3 | Simultaneous Sampling Dual 250 kSPS 12-Bit ADC |
| AD7862BR-3 | Simultaneous Sampling Dual 250 kSPS 12-Bit ADC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7863 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Simultaneous Sampling Dual 175 kSPS 14-Bit ADC |
| AD7863AR-10 | 功能描述:IC ADC 14BIT DUAL 2CH 28-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| AD7863AR-10REEL | 功能描述:IC ADC 14BIT DUAL 2CH 28-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| AD7863AR-10REEL7 | 制造商:Analog Devices 功能描述:ADC Dual SAR 175ksps 14-bit Parallel 28-Pin SOIC W T/R |
| AD7863AR-2 | 功能描述:IC ADC 14BIT DUAL 2CH 28-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
發布緊急采購，3分鐘左右您將得到回復。