- 您現在的位置：買賣IC網 > PDF目錄373921 > AD7865BS-3 (ANALOG DEVICES INC) Four-Channel, Simultaneous Sampling, Fast, 14-Bit ADC PDF資料下載
參數資料
| 型號： | AD7865BS-3 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | ADC |
| 英文描述： | Four-Channel, Simultaneous Sampling, Fast, 14-Bit ADC |
| 中文描述： | 4-CH 14-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, PQFP44 |
| 封裝： | PLASTIC, QFP-44 |
| 文件頁數： | 17/19頁 |
| 文件大小： | 195K |
| 代理商： | AD7865BS-3 |
AD7865
–17–
REV. A
AC Linearity Plots
The plots shown in Figure 18 below show typical DNL and INL
for the AD7865.
ADC – Code
0
D
–0.60
0
4000
8000
12000
16383
0.60
ADC – Code
0
i
–0.60
0
4000
8000
12000
16383
0.60
Figure 18. Typical DNL and INL Plots
MICROPROCESSOR INTERFACING
The high speed parallel interface of the AD7865 allows easy
interfacing to most DSPs and microprocessors. The AD7865
interface of the AD7865 consists of the data lines (DB0 to
DB13),
CS
,
RD
,
WR
,
EOC
and BUSY.
AD7865–ADSP-21xx Interface
Figure 19 shows an interface between the AD7865 and the
ADSP-210x. The
CONVST
signal can be generated by the
ADSP-210x or from some other external source. Figure 19
shows the
CS
being generated by a combination of the
DMS
signal and the address bus of the ADSP-2100. In this way the
AD7865 is mapped into the data memory space of the
ADSP-210x.
The AD7865 BUSY line provides an interrupt to the ADSP-
210x when the conversion sequence is complete on all the se-
lected channels. The conversion results can then be read from
the AD7865 using successive read operations. Alternately, one
can use the
EOC
pulse to interrupt the ADSP-210x when the
conversion on each channel is complete when reading between
each conversion in the conversion sequence (Figure 8). The
AD7865 is read using the following instruction
MR
0
= DM(ADC
)
where
MR
0 is the ADSP-210x MR0 register and
ADC
is the
AD7865 address.
CS
RD
WR
BUSY
CONVST
DB0–DB13
AD7865
V
IN1
V
IN2
V
IN3
V
IN4
DT1/F0
IRQn
RD
WR
D0–D13
DMS
A0–A13
ADSP-21xx
ADDRESS
DECODE
Figure 19. AD7865–ADSP-21xx Interface
AD7865–TMS320C5x Interface
Figure 20 shows an interface between the AD7865 and the
TMS320C5x. As with the previous interfaces, conversion can be
initiated from the TMS320C5x or from an external source and
the processor is interrupted when the conversion sequence is
completed. The
CS
signal to the AD7865 derived from the DS
signal and a decode of the address bus. This maps the AD7865
into external data memory. The
RD
signal from the TMS320 is
used to enable the ADC data onto the data bus. The AD7865
has a fast parallel bus so there are no wait state requirements.
The following instruction is used to read the conversion results
from the AD7865:
IN D,ADC
where
D
is Data Memory address and
ADC
is the AD7865
address.
PA0
INTn
DS
TMS320C5x
CS
RD
WR
BUSY
CONVST
DB0–DB13
AD7865
V
IN1
V
IN2
V
IN3
V
IN4
RD
WR
D0–D13
A0–A13
ADDRESS
DECODE
Figure 20. AD7865–TMS320C5x Interface
AD7865–MC68000 Interface
An interface between the AD7865 and the MC68000 is shown
in Figure 21. The conversion can be initiated from the MC68000
or from an external source. The AD7865 BUSY line can be
used to interrupt the processor or, alternatively, software delays
can ensure that conversion has been completed before a read to
the AD7865 is attempted. Because of the nature of its inter-
rupts, the 68000 requires additional logic (not shown in Figure
21) to allow it to be interrupted correctly. For further informa-
tion on 68000 interrupts, consult the 68000 users manual.
相關PDF資料 |
PDF描述 |
|---|---|
| AD7866ARU | Dual 1 MSPS, 12-Bit, 2-Channel SAR ADC with Serial Interface |
| AD7866BRU | Dual 1 MSPS, 12-Bit, 2-Channel SAR ADC with Serial Interface |
| AD7866 | Dual 1 MSPS, 12-Bit, 2-Channel SAR ADC with Serial Interface |
| AD7868AN | LC2MOS Complete, 12-Bit Analog I/O System |
| AD7868AQ | LC2MOS Complete, 12-Bit Analog I/O System |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7865BS-3REEL | 制造商:Analog Devices 功能描述:ADC Single SAR 350ksps 14-bit Parallel 44-Pin MQFP T/R |
| AD7865BSZ-1 | 功能描述:IC ADC 14BIT 4CHAN 5V 44-MQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| AD7865BSZ-1 | 制造商:Analog Devices 功能描述:ADC, 14BIT, 100KSPS, PARALLEL, QFP-44 |
| AD7865BSZ-1REEL | 功能描述:IC ADC 14BIT 4CHAN 5V 44-MQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| AD7865BSZ-2 | 功能描述:IC ADC 14BIT 4CHAN 5V 44-MQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
發布緊急采購，3分鐘左右您將得到回復。