欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: AD9833
廠商: Analog Devices, Inc.
英文描述: +2.5 V to +5.5 V, 25 MHz Low Power CMOS Complete DDS
中文描述: 2.5 V至5.5 V,25 MHz低功耗CMOS完整的DDS
文件頁數: 15/18頁
文件大?。?/td> 210K
代理商: AD9833
AD9833
15
REV PrG
PRELIMINARY TECHNICAL DATA
Figure 8. Data Writes
INTERFACING TO MICROPROCESSORS
The AD9833 has a standard serial interface which allows
the part to interface directly with several microprocessors.
The device uses an external serial clock to write the data/
control information into the device. The serial clock can
have a frequency of 40 MHz maximum. The serial clock
can be continuous or, it can idle high or low between
write operations. When data/control information is being
written to the AD9833, FSYNC is taken low and is held
low while the 16 bits of data are being written into the
AD9833. The FSYNC signal frames the 16 bits of infor-
mation being loaded into the AD9833.
AD9833 to ADSP-21xx Interface
Figure 9 shows the serial interface between the AD9833
and the ADSP-21xx. The ADSP-21xx should be set up to
operate in the SPORT Transmit Alternate Framing Mode
(TFSW = 1). The ADSP-21xx is programmed through
the SPORT control register and should be configured as
follows:
Internal clock operation (ISCLK = 1)
Active low framing (INVTFS = 1)
16-bit word length (SLEN = 15)
Internal frame sync signal (ITFS = 1)
Generate a frame sync for each write (TFSR = 1).
Transmission is initiated by writing a word to the Tx reg-
ister after the SPORT has been enabled. The data is
clocked out on each rising edge of the serial clock and
clocked into the AD9833 on the SCLK falling edge.
ADSP-2101/
ADSP-2103*
AD9833*
TFS
DT
SCLK
FSYNC
* ADDITIONAL PINS OMITTED FOR CLARITY
SDATA
SCLK
Figure 9. ADSP2101/ADSP2103 to AD9833 Interface
AD9833 to 68HC11/68L11 Interface
Figure 10 shows the serial interface between the AD9833
and the 68HC11/68L11 microcontroller. The
microcontroller is configured as the master by setting bit
MSTR in the SPCR to 1 and, this provides a serial clock
on SCK while the MOSI output drives the serial data line
SDATA. Since the microcontroller does not have a dedi-
cated frame sync pin, the FSYNC signal is derived from a
port line (PC7). The set up conditions for correct opera-
tion of the interface are as follows:
DATA WRITE
WRITE A FULL 28-BIT WORD
TO A FREQUENCY REGISTER
WRITE 14 MSBs OR LSBs
TO A FREQUENCY REGISTER
WRITE TO PHASE
REGISTER
(CONTROL REGISTER WRITE)
B28 (D13) = 1
WRITE 2 CONSECUTIVE
16-BIT WORDS
(See Table 5 for Example)
WRITE A 16-BIT WORD
(See Tables 6 & 7 for
examples)
(CONTROL REGISTER WRITE)
B28 (D13) = 0
HLB (D12) = 0 / 1
WRITE ANOTHER FULL
28 BITS TO A
FREQUENCY REGISTER
WRITE 14 MSBs OR LSBs
TO A
FREQUENCY REGISTER
(16 - Bit Write)
D15, D14 = 11
D13 = 0/1 (chooses the
phase register)
D12 = X
D11 ... D0 = Phase Data
WRITE TO ANOTHER
PHASE REGISTER
YES
YES
YES
YES
YES
YES
NO
NO
NO
NO
NO
相關PDF資料
PDF描述
AD9833BRM +2.5 V to +5.5 V, 25 MHz Low Power CMOS Complete DDS
AD9834 Low Power, +2.3 V to +5.5 V, 50 MHz Complete DDS
AD9834BRU Low Power, +2.3 V to +5.5 V, 50 MHz Complete DDS
AD9835 50 MHz CMOS Complete DDS
AD9835BRU 50 MHz CMOS Complete DDS
相關代理商/技術參數
參數描述
AD9833BRM 功能描述:IC WAVEFORM GEN PROG 10-MSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 直接數字合成 (DDS) 系列:- 產品變化通告:Product Discontinuance 27/Oct/2011 標準包裝:2,500 系列:- 分辨率(位):10 b 主 fclk:25MHz 調節字寬(位):32 b 電源電壓:2.97 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
AD9833BRM-REEL 制造商:Analog Devices 功能描述:Direct Digital Synthesizer 25MHz 1-DAC 10-Bit Serial 10-Pin MSOP T/R 制造商:Analog Devices 功能描述:PROGRAMMABLE WAVEFORM GENERATOR 10MSOP - Tape and Reel
AD9833BRM-REEL7 功能描述:IC WAVEFORM GEN PROG 10-MSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 直接數字合成 (DDS) 系列:- 產品變化通告:Product Discontinuance 27/Oct/2011 標準包裝:2,500 系列:- 分辨率(位):10 b 主 fclk:25MHz 調節字寬(位):32 b 電源電壓:2.97 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
AD9833BRMZ 功能描述:IC WAVEFORM GENERTR PROG 10-MSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 直接數字合成 (DDS) 系列:- 產品變化通告:Product Discontinuance 27/Oct/2011 標準包裝:2,500 系列:- 分辨率(位):10 b 主 fclk:25MHz 調節字寬(位):32 b 電源電壓:2.97 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
AD9833BRMZ 制造商:Analog Devices 功能描述:WAVEFORM GENERATOR 9833 MSOP10
主站蜘蛛池模板: 来宾市| 织金县| 金溪县| 武隆县| 沂水县| 宝山区| 甘洛县| 唐海县| 丰都县| 太谷县| 陈巴尔虎旗| 齐齐哈尔市| 鸡泽县| 库伦旗| 高阳县| 梁河县| 鹤壁市| 东丽区| 天气| 泰州市| 图片| 舒城县| 铜梁县| 锡林浩特市| 中宁县| 宁海县| 枣阳市| 淳化县| 商河县| 双牌县| 辛集市| 卓尼县| 芮城县| 井陉县| 房山区| 龙泉市| 望江县| 廊坊市| 博乐市| 格尔木市| 灵石县|