- 您現在的位置：買賣IC網 > PDF目錄373977 > ADCMP572BCP (ANALOG DEVICES INC) Ultrafast 3.3 V Single-Supply Comparators PDF資料下載
參數資料
| 型號： | ADCMP572BCP |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | Ultrafast 3.3 V Single-Supply Comparators |
| 中文描述： | COMPARATOR, 5000 uV OFFSET-MAX, QCC16 |
| 封裝： | MO-220-VEED-2, LFCSP-16 |
| 文件頁數： | 11/16頁 |
| 文件大小： | 412K |
| 代理商： | ADCMP572BCP |
Preliminary Technical Data
ADCMP572/ADCMP573
COMPARATOR HYSTERESIS
The addition of hysteresis to a comparator is often desirable in a
noisy environment or when the differential input amplitudes are
relatively small or slow moving. The transfer function for a
comparator with hysteresis is shown in Figure 16. If the input
voltage approaches the threshold (0.0 V in this example) from
the negative direction, the comparator switches from a low to a
high when the input crosses +V
H
/2. The new switching threshold
becomes V
H
/2. The comparator remains in the high state until
the threshold V
H
/2 is crossed from the positive direction. In
this manner, noise centered on 0.0 V input does not cause the
comparator to switch states unless it exceeds the region
bounded by ±V
H
/2.
Rev. PrB | Page 11 of 16
OUTPUT
INPUT
0
V
OL
V
OH
+V
H
2
–V
H
2
0
Figure 16. Comparator Hysteresis Transfer Function
The customary technique for introducing hysteresis into a
comparator uses positive feedback from the output back to the
input. A limitation of this approach is that the amount of
hysteresis varies with the output logic levels, resulting in
hysteresis that is not symmetric about the threshold. The
external feedback network can also introduce significant
parasitics that reduce high speed performance, and can even
induce oscillation in some cases.
The ADCMP572/ADCMP573 comparators offer a
programmable hysteresis feature that can significantly improve
the accuracy and stability of the desired hysteresis. By
connecting an external pull-down resistor from the HYS pin to
GND, a variable amount of hysteresis can be applied. Leaving
the HYS pin disconnected disables the feature, and hysteresis is
then less than 1 mV as specified. The maximum hysteresis that
can be applied using this method is approximately ±25 mV.
Figure 17 illustrates the amount of hysteresis applied as a
function of external resistor value. The advantages of applying
hysteresis in this manner are improved accuracy, stability, and
reduced component count. An external bypass capacitor is not
recommended on the HYS pin because it would likely degrade
the jitter performance of the device.
0
10
20
30
40
50
60
H
2
3
0
1
4
5
6
R
HYS
(k
)
0
Figure 17. Hysteresis vs. R
HYS
Control Resistor
MINIMUM INPUT SLEW RATE REQUIREMENT
As with all high speed comparators, a minimum slew rate
requirement must be met to ensure that the device does not
oscillate as the input signal crosses the threshold. This
oscillation is due in part to the high input bandwidth of the
comparator and the feedback parasitics inherent in the package.
Analog Devices recommends a minimum slew rate of 50 V/μs
to ensure a clean output transition from the ADCMP572/
ADCMP573 comparators unless hysteresis is programmed as
discussed previously.
相關PDF資料 |
PDF描述 |
|---|---|
| ADCMP573 | Ultrafast 3.3 V Single-Supply Comparators |
| ADCMP573BCP | Ultrafast 3.3 V Single-Supply Comparators |
| ADCMP580 | Ultrafast SiGe Voltage Comparators |
| ADCMP580_05 | Ultrafast SiGe Voltage Comparators |
| ADCMP580BCP-R2 | Ultrafast SiGe Voltage Comparators |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADCMP572BCP-R2 | 制造商:Analog Devices 功能描述:Comparator Single 5.4V 16-Pin LFCSP EP T/R 制造商:Rochester Electronics LLC 功能描述:SINGLE SUPPLY, CML ON XFCB3.0- - Bulk |
| ADCMP572BCP-RL7 | 制造商:Analog Devices 功能描述:Comparator Single 5.4V 16-Pin LFCSP EP T/R |
| ADCMP572BCP-WP | 制造商:Analog Devices 功能描述:Comparator Single 5.4V 16-Pin LFCSP EP |
| ADCMP572BCPZ-R2 | 功能描述:IC COMPARATOR CML 3.3-5V 16LFCSP RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:- 標準包裝:1 系列:- 類型:通用 元件數:1 輸出類型:CMOS，開路集電極，TTL 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V 電壓 - 輸入偏移（最小值）:7mV @ 5V 電流 - 輸入偏壓（最小值）:0.25µA @ 5V 電流 - 輸出（標準）:84mA @ 5V 電流 - 靜態（最大值）:120µA CMRR, PSRR（標準）:- 傳輸延遲（最大）:600ns 磁滯:- 工作溫度:-40°C ~ 85°C 封裝/外殼:SC-74A，SOT-753 安裝類型:表面貼裝 包裝:剪切帶 (CT) 產品目錄頁面:1268 (CN2011-ZH PDF) 其它名稱:*LMV331M5*LMV331M5/NOPBLMV331M5CT |
| ADCMP572BCPZ-RL7 | 功能描述:IC COMPARATOR CML 3.3-5V 16LFCSP RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:通用 元件數:1 輸出類型:CMOS，推挽式，滿擺幅，TTL 電壓 - 電源，單路/雙路(±):2.5 V ~ 5.5 V，±1.25 V ~ 2.75 V 電壓 - 輸入偏移（最小值）:5mV @ 5.5V 電流 - 輸入偏壓（最小值）:1pA @ 5.5V 電流 - 輸出（標準）:- 電流 - 靜態（最大值）:24µA CMRR, PSRR（標準）:80dB CMRR，80dB PSRR 傳輸延遲（最大）:450ns 磁滯:±3mV 工作溫度:-40°C ~ 85°C 封裝/外殼:6-WFBGA，CSPBGA 安裝類型:表面貼裝 包裝:管件 其它名稱:Q3554586 |
發布緊急采購，3分鐘左右您將得到回復。