- 您現在的位置：買賣IC網 > PDF目錄374032 > ADSP-2109LKP-55 (ANALOG DEVICES INC) Low Cost DSP Microcomputers PDF資料下載
參數資料
| 型號： | ADSP-2109LKP-55 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 數字信號處理 |
| 英文描述： | Low Cost DSP Microcomputers |
| 中文描述： | 24-BIT, 13.824 MHz, OTHER DSP, PQCC68 |
| 封裝： | PLASTIC, LCC-68 |
| 文件頁數： | 5/36頁 |
| 文件大小： | 333K |
| 代理商： | ADSP-2109LKP-55 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
ADSP-2104/ADSP-2109
REV. 0
–5–
T he interrupt control register, ICNT L, allows the external
interrupts to be set as either edge- or level-sensitive. Depending
on bit 4 in ICNT L, interrupt service routines can either be
nested (with higher priority interrupts taking precedence) or be
processed sequentially (with only one interrupt service active at
a time).
T he interrupt force and clear register, IFC, is a write-only register
that contains a force bit and a clear bit for each interrupt.
When responding to an interrupt, the AST AT , MST AT , and
IMASK status registers are pushed onto the status stack and
the PC counter is loaded with the appropriate vector address.
T he status stack is seven levels deep to allow interrupt nesting.
T he stack is automatically popped when a return from the
interrupt instruction is executed.
Pin Definitions
T able II shows pin definitions for the ADSP-2104/ADSP-2109
processors. Any inputs not used must be tied to V
DD
.
SY ST E M INT E RFACE
Figure 3 shows a typical system for the ADSP-2104/ADSP-2109,
with two serial I/O devices, a boot EPROM, and optional external
program and data memory. A total of 14.25K words of data
memory and 14.5K words of program memory is addressable.
Programmable wait-state generation allows the processors to
easily interface to slow external memories.
T he ADSP-2104/ADSP-2109 also provides either: one external
interrupt (
IRQ2
) and two serial ports (SPORT 0, SPORT 1),
or
three external interrupts (
IRQ2
,
IRQ1
,
IRQ0
) and one serial
port (SPORT 0).
Clock Signals
T he ADSP-2104/ADSP-2109’s CLK IN input may be driven by
a crystal or by a T T L-compatible external clock signal. T he
CLK IN input may not be halted or changed in frequency during
operation, nor operated below the specified low frequency limit.
If an external clock is used, it should be a T T L-compatible
signal running at the instruction rate. T he signal should be
connected to the processor’s CLK IN input; in this case, the
X T AL input must be left unconnected.
Because the processor includes an on-chip oscillator circuit, an
external crystal may also be used. T he crystal should be con-
nected across the CLK IN and X T AL pins, with two capacitors
connected as shown in Figure 2. A parallel-resonant, fundamen-
tal frequency, microprocessor-grade crystal should be used.
T able II. ADSP-2104/ADSP-2109 Pin Definitions
Pin
Name(s)
# of
Pins
Input /
Output
Function
Address
Data
1
14
24
O
I/O
Address outputs for program, data and boot memory.
Data I/O pins for program and data memories. Input only for
boot memory, with two MSBs used for boot memory addresses.
Unused data lines may be left floating.
Processor Reset Input
External Interrupt Request #2
External Bus Request Input
External Bus Grant Output
External Program Memory Select
External Data Memory Select
Boot Memory Select
External Memory Read Enable
External Memory Write Enable
Memory Map Select Input
External Clock or Quartz Crystal Input
Processor Clock Output
Power Supply Pins
Ground Pins
Serial Port 0 Pins
(TFS0, RFS0, DT0, DR0, SCLK0)
Serial Port 1 Pins
(TFS1, RFS1, DT1, DR1, SCLK1)
RESET
IRQ2
BR
2
BG
PMS
DMS
BMS
RD
WR
MMAP
CLK IN, X T AL
CLK OUT
V
DD
GND
SPORT 0
SPORT 1
or
Interrupts & Flags:
IRQ0
(RFS1)
IRQ1
(TFS1)
FI
(DR1)
FO
(DT1)
1
1
1
1
1
1
1
1
1
1
2
1
I
I
I
O
O
O
O
O
O
I
I
O
5
5
I/O
I/O
1
1
1
1
I
I
I
O
External Interrupt Request #0
External Interrupt Request #1
Flag Input Pin
Flag Output Pin
NOT ES
1
Unused data bus lines may be left floating.
2
BR
must be tied high (to V
DD
) if not used.
相關PDF資料 |
PDF描述 |
|---|---|
| ADSP-2104 | low cost DSP microcomputers |
| ADSP-2109 | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| ADSP2104 | Low Cost DSP Microcomputers |
| ADSP-2104KP-80 | Low Cost DSP Microcomputers |
| ADSP-2104LKP-55 | Low Cost DSP Microcomputers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADSP-2111 | 制造商:AD 制造商全稱:Analog Devices 功能描述:ADSP-2100 Family DSP Microcomputers |
| ADSP-2111BG-52 | 制造商:AD 制造商全稱:Analog Devices 功能描述:ADSP-2100 Family DSP Microcomputers |
| ADSP-2111BG-66 | 制造商:AD 制造商全稱:Analog Devices 功能描述:ADSP-2100 Family DSP Microcomputers |
| ADSP-2111BG-80 | 功能描述:IC DSP CONTROLLER 16BIT 100PGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:ADSP-21xx 標準包裝:2 系列:StarCore 類型:SC140 內核 接口:DSI，以太網，RS-232 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:1.436MB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:431-BFBGA，FCBGA 供應商設備封裝:431-FCPBGA（20x20） 包裝:托盤 |
| ADSP-2111BGZ-80 | 制造商:Analog Devices 功能描述:DSP FIX PT 16BIT 20MHZ 20MIPS 100CPGA - Trays |
發布緊急采購，3分鐘左右您將得到回復。