欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: ADSP2186
廠商: Analog Devices, Inc.
元件分類: 數字信號處理
英文描述: DSP Microcomputer
中文描述: DSP微機
文件頁數: 8/32頁
文件大?。?/td> 293K
代理商: ADSP2186
ADSP-2186
–8–
REV. 0
T here are 8K words of memory accessible internally when the
PMOVLAY register is set to 0. When PMOVLAY is set to some-
thing other than 0, external accesses occur at addresses 0x2000
through 0x3FFF. T he external address is generated as shown in
T able II.
T able II.
PMOVLAY
Memory
A13
A12:0
0
1
Internal
External
Overlay 1
Not Applicable Not Applicable
13 LSBs of Address
Between 0x2000
and 0x3FFF
13 LSBs of Address
Between 0x2000
and 0x3FFF
0
2
External
Overlay 2
1
NOT E: Addresses 0x2000 through 0x3FFF should not be accessed when
PMOVLAY = 0.
T his organization provides for two external 8K overlay segments
using only the normal 14 address bits, which allows for simple
program overlays using one of the two external segments in
place of the on-chip memory. Care must be taken in using this
overlay space in that the processor core (i.e., the sequencer)
does not take into account the PMOVLAY register value. For
example, if a loop operation was occurring on one of the exter-
nal overlays and the program changes to another external over-
lay or internal memory, an incorrect loop operation could occur.
In addition, care must be taken in interrupt service routines as
the overlay registers are not automatically saved and restored on
the processor mode stack.
When Mode B = 1, booting is disabled and overlay memory is
disabled (PMOVLAY must be 0). Figure 5 shows the memory
map in this configuration.
RESERVED
0x3FFF
0x2000
0x1FFF
8K EXTERNAL
0x0000
PROGRAM MEMORY
ADDRESS
Figure 5. Program Memory (Mode B = 1)
Data Memory
T he ADSP-2186 has 8160 16-bit words of internal data memory.
In addition, the ADSP-2186 allows the use of 8K external memory
overlays. Figure 6 shows the organization of the data memory.
EXTERNAL 8K
(DMOVLAY = 1, 2)
INTERNAL
8160 WORDS
DATA MEMORY
ADDRESS
32 MEMORY–
MAPPED REGISTERS
0x3FFF
0x3FEO
0x3FDF
0x2000
0x1FFF
0x0000
Figure 6. Data Memory
T here are 8160 words of memory accessible internally when the
DMOVLAY register is set to 0. When DMOVLAY is set to
something other than 0, external accesses occur at addresses
0x0000 through 0x1FFF. T he external address is generated as
shown in T able III.
T able III.
DMOVLAY
Memory
A13
A12:0
0
1
Internal
External
Overlay 1
Not Applicable Not Applicable
13 LSBs of Address
Between 0x2000
and 0x3FFF
13 LSBs of Address
Between 0x2000
and 0x3FFF
0
2
External
Overlay 2
1
T his organization allows for two external 8K overlays using only
the normal 14 address bits. All internal accesses complete in one
cycle. Accesses to external memory are timed using the wait
states specified by the DWAIT register.
I/O Space (Full Memory Mode)
T he ADSP-2186 supports an additional external memory space
called I/O space. T his space is designed to support simple con-
nections to peripherals or to bus interface ASIC data registers.
I/O space supports 2048 locations. T he lower eleven bits of the
external address bus are used; the upper three bits are unde-
fined. T wo instructions were added to the core ADSP-2100
Family instruction set to read from and write to I/O memory
space. T he I/O space also has four dedicated three-bit wait state
registers, IOWAIT 0-3, which specify up to seven wait states to
be automatically generated for each of four regions. T he wait
states act on address ranges as shown in T able IV.
T able IV.
Address Range
Wait State Register
0x000–0x1FF
0x200–0x3FF
0x400–0x5FF
0x600–0x7FF
IOWAIT 0
IOWAIT 1
IOWAIT 2
IOWAIT 3
Composite Memory Select (
CMS
)
T he ADSP-2186 has a programmable memory select signal that
is useful for generating memory select signals for memories
mapped to more than one space. T he
CMS
signal is generated
to have the same timing as each of the individual memory select
signals (
PMS
,
DMS
,
BMS
,
IOMS
), but can combine their
functionality.
Each bit in the CMSSEL register, when set, causes the
CMS
signal to be asserted when the selected memory select is as-
serted. For example, to use a 32K word memory to act as both
program and data memory, set the
PMS
and
DMS
bits in the
CMSSEL register and use the
CMS
pin to drive the chip select
of the memory and use either
DMS
or
PMS
as the additional
address bit.
T he
CMS
pin functions as the other memory select signals, with
the same timing and bus request logic. A 1 in the enable bit
causes the assertion of the
CMS
signal at the same time as the
selected memory select signal. All enable bits, except the
BMS
bit, default to 1 at reset.
相關PDF資料
PDF描述
ADT14 Circular Connector; No. of Contacts:61; Series:LJT07R; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:25; Circular Contact Gender:Socket; Circular Shell Style:Jam Nut Receptacle; Insert Arrangement:25-61
ADT14GP Circular Connector; No. of Contacts:61; Series:LJT07R; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:25; Circular Contact Gender:Socket; Circular Shell Style:Jam Nut Receptacle; Insert Arrangement:25-61
ADT14GS Circular Connector; No. of Contacts:61; Series:LJT07R; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:25; Circular Contact Gender:Socket; Circular Shell Style:Jam Nut Receptacle; Insert Arrangement:25-61
ADT7460 dB COOL?? Remote Thermal Controller and Fan Controller
ADT7460ARQ dB COOL?? Remote Thermal Controller and Fan Controller
相關代理商/技術參數
參數描述
ADSP-2186 制造商:AD 制造商全稱:Analog Devices 功能描述:DSP Microcomputer
ADSP-2186_01 制造商:AD 制造商全稱:Analog Devices 功能描述:DSP Microcomputer
ADSP-2186BCA-160 制造商:AD 制造商全稱:Analog Devices 功能描述:DSP Microcomputer
ADSP-2186BST-115 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 28.8MHz 28.8MIPS 100-Pin LQFP 制造商:Rochester Electronics LLC 功能描述:DSP,5V,28MHZ,16K WORD RAM, 100TQFP - Bulk 制造商:Analog Devices 功能描述:IC MICROCOMPUTER 16-BIT
ADSP-2186BST-133 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 33.3MHz 33.3MIPS 100-Pin LQFP 制造商:Rochester Electronics LLC 功能描述:DSP,5V,33MHZ,16K WORD RAM, 100TQFP - Bulk 制造商:Analog Devices 功能描述:IC MICROCOMPUTER 16-BIT
主站蜘蛛池模板: 南充市| 偃师市| 西乌| 涿鹿县| 淮安市| 讷河市| 平乡县| 安平县| 樟树市| 通海县| 东光县| 互助| 鹤庆县| 南平市| 玉溪市| 吉林市| 花莲县| 云霄县| 麻城市| 茶陵县| 行唐县| 丰镇市| 寿宁县| 伊川县| 定襄县| 敖汉旗| 郁南县| 阳曲县| 丰城市| 海丰县| 郯城县| 合水县| 奉节县| 井冈山市| 滨州市| 杭锦旗| 凉城县| 安西县| 安溪县| 洛宁县| 石柱|