欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: ADUC845BCP8-3
廠商: ANALOG DEVICES INC
元件分類: 微控制器/微處理器
英文描述: MicroConverter Multichannel 24-/16-Bit ADCs with Embedded 62 kB Flash and Single-Cycle MCU
中文描述: 8-BIT, FLASH, 12.58 MHz, MICROCONTROLLER, QCC56
封裝: 8 X 8 MM, MO-220-VLLD-2, LFCSP-56
文件頁數: 88/108頁
文件大?。?/td> 1109K
代理商: ADUC845BCP8-3
ADuC845/ADuC847/ADuC848
As an alternative to providing two separate power supplies,
AV
DD
can be kept quiet by placing a small series resistor and/or
ferrite bead between it and DV
DD
, and then decoupling AV
DD
separately to ground. An example of this configuration is shown
in Figure 65. In this configuration, other analog circuitry (such
as op amps and voltage reference) can be powered from the
AV
DD
supply line as well.
Rev. A | Page 88 of 108
DV
DD
AGND
AV
DD
DGND
DIGITAL SUPPLY
+
BEAD
1.6
0.1
μ
F
0.1
μ
F
10
μ
F
10
μ
F
ADuC845/
ADuC847/
ADuC848
0
6
5
4
22
36
51
50
38
37
23
Figure 65. External Single-Supply Connections (56-Lead CSP Pin Numbering)
Notice that in both Figure 64 and Figure 65 a large value (10 μF)
reservoir capacitor sits on DV
DD
and a separate 10 μF capacitor
sits on AV
DD
. Also, local decoupling capacitors (0.1 μF) are
located at each V
DD
pin of the chip. As per standard design
practice, be sure to include all of these capacitors and ensure
that the smaller capacitors are closer than the 10 μF capacitors
to each V
DD
pin with lead lengths as short as possible. Connect
the ground terminal of each of these capacitors directly to the
underlying ground plane. Finally, note that, at all times, the
analog and digital ground pins on the part must be referenced
to the same system ground reference point. It is recommended
that the CSP paddle be soldered to ensure mechanical stability
but be floated with respect to system V
DD
s or grounds.
POWER-ON RESET OPERATION
An internal power-on reset (POR) is implemented on the
ADuC845/ADuC847/ADuC848. For DV
DD
below 2.63 V, the
internal POR holds the part in reset. As DV
DD
rises above 2.63 V,
an internal timer times out for typically 128 ms before the part
is released from reset. The user must ensure that the power
supply has at least reached a stable 2.7 V minimum level by this
time. Likewise on power-down, the internal POR holds the part
in reset until the power supply drops below 1 V. Figure 66
illustrates the operation of the internal POR.
128ms TYP
1.0V TYP
128ms TYP
2.63V TYP
1.0V TYP
INTERNAL
CORE RESET
DV
DD
0
Figure 66. ADuC845/ADuC847/ADuC848 Internal Power-On Reset Operation
POWER CONSUMPTION
The DV
DD
power supply current consumption is specified in
normal and power-down modes. The AV
DD
power supply
current is specified with the analog peripherals disabled. The
normal mode power consumption represents the current drawn
from DV
DD
by the digital core. The other on-chip peripherals
(such as the watchdog timer and power supply monitor)
consume negligible current and are therefore included with the
normal operating current. The user must add any currents
sourced by the parallel and serial I/O pins, and those sourced by
the DAC to determine the total current needed at the ADuC845/
ADuC847/ADuC848 DV
DD
and AV
DD
supply pins. Also, current
drawn from the DV
DD
supply increases by approximately 5 mA
during Flash/EE erase and program cycles.
POWER-SAVING MODES
Setting the power-down mode bit, PCON.1, in the PCON SFR
described in Table 6, allows the chip to be switched from
normal mode into full power-down mode.
In power-down mode, both the PLL and the clock to the core
are stopped. The on-chip oscillator can be halted or can
continue to oscillate, depending on the state of the oscillator
power-down bit (OSC_PD) in the PLLCON SFR. The TIC,
driven directly from the oscillator, can also be enabled during
power-down. However, all other on-chip peripherals are shut
down. Port pins retain their logic levels in this mode, but the
DAC output goes to a high impedance state (three-state) while
ALE and PSEN outputs are held low. There are five ways to
terminate power-down mode:
Asserting the RESET Pin
Returns to normal mode. All registers are set to their reset
default value and program execution starts at the reset
vector once the RESET pin is de-asserted.
Cycling Power
All registers are set to their default state and program exe-
cution starts at the reset vector approximately 128 ms later.
Time Interval Counter (TIC) Interrupt
If the OSC_PD bit in the PLLCON SFR is clear, the 32 kHz
oscillator remains powered up even in power-down mode.
If the time interval counter (wake-up/RTC timer) is
enabled, a TIC interrupt wakes the part from power-down
mode. The CPU services the TIC interrupt. The RETI at
the end of the TIC ISR returns the core to the next
instruction after that one that enabled power-down.
相關PDF資料
PDF描述
ADUC847BCP8-3 MicroConverter Multichannel 24-/16-Bit ADCs with Embedded 62 kB Flash and Single-Cycle MCU
ADUC845BCP8-5 MicroConverter Multichannel 24-/16-Bit ADCs with Embedded 62 kB Flash and Single-Cycle MCU
ADUC847BCP8-5 MicroConverter Multichannel 24-/16-Bit ADCs with Embedded 62 kB Flash and Single-Cycle MCU
ADUC845BCP62-3 MicroConverter Multichannel 24-/16-Bit ADCs with Embedded 62 kB Flash and Single-Cycle MCU
ADUC845BCP62-5 MicroConverter Multichannel 24-/16-Bit ADCs with Embedded 62 kB Flash and Single-Cycle MCU
相關代理商/技術參數
參數描述
ADUC845BCP8-5 制造商:Analog Devices 功能描述:10 CHANNEL 24 BIT DUAL ADC + FAST 8BIT UP - Trays
ADUC845BCPZ62-3 功能描述:IC MCU FLASH W/24BIT ADC 56LFCSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:MicroConverter® ADuC8xx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA,UART/USART 外圍設備:欠壓檢測/復位,LED,POR,PWM,WDT 輸入/輸出數:16 程序存儲器容量:4KB(4K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND
ADUC845BCPZ62-5 功能描述:IC FLASH MCU W/24BIT ADC 56-CSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:MicroConverter® ADuC8xx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA,UART/USART 外圍設備:欠壓檢測/復位,LED,POR,PWM,WDT 輸入/輸出數:16 程序存儲器容量:4KB(4K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND
ADUC845BCPZ8-3 功能描述:IC MCU FLASH 24BIT ADC 56LFCSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:MicroConverter® ADuC8xx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA,UART/USART 外圍設備:欠壓檢測/復位,LED,POR,PWM,WDT 輸入/輸出數:16 程序存儲器容量:4KB(4K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND
ADUC845BCPZ8-5 功能描述:IC MCU FLASH 24BIT ADC 56LFCSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:MicroConverter® ADuC8xx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA,UART/USART 外圍設備:欠壓檢測/復位,LED,POR,PWM,WDT 輸入/輸出數:16 程序存儲器容量:4KB(4K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND
主站蜘蛛池模板: 华坪县| 鄱阳县| 灌云县| 长子县| 大新县| 阳谷县| 肥东县| 大冶市| 建宁县| 米泉市| 盐池县| 屏山县| 凤台县| 连州市| 四平市| 湘西| 洞头县| 龙陵县| 定州市| 伊春市| 海南省| 波密县| 蛟河市| 九江县| 杭州市| 鲁山县| 合川市| 北票市| 偏关县| 瓦房店市| 乌兰察布市| 永和县| 个旧市| 惠州市| 商河县| 鲜城| 安仁县| 上虞市| 甘肃省| 霍林郭勒市| 克什克腾旗|